CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: Dano523
Showing results 1 to 25 of 497
Search took 0.72 seconds.
Forum: C6 Corvette General Discussion
Yesterday, 11:16 PM
Replies: 18
Views: 1,529
Posted By Dano523

If that far into the heads, would have guides...

If that far into the heads, would have guides replaced, reamed to fit now valve stems, and make dam sure that they ID chamfer both the top and bottom ID's of the guides, so there are no burs left...
Forum: C6 Tech/Performance
Yesterday, 10:55 PM
Replies: 6
Views: 179
Posted By Dano523

Have been in Huston in the winter time, with...

Have been in Huston in the winter time, with temps below freezing, so would not screw around with Dex cool ratios, to raise is freezing point and chance having the coolant freeze up to take out the...
Forum: C6 Tech/Performance
Yesterday, 10:50 PM
Replies: 8
Views: 199
Posted By Dano523

New upgraded Oem master cylinder, and tell by cap...

New upgraded Oem master cylinder, and tell by cap having Dot 4 and tank being black, not clear/white, and should only be about 1Hr shop time if you need a shop to replace it,since you go in from the...
Forum: C6 Tech/Performance
Yesterday, 10:19 PM
Replies: 3
Views: 86
Posted By Dano523

What color is the brake fluid, and if still...

What color is the brake fluid, and if still clear, then how much have you been abusing the clutch?

If clear fluid, then going to suspect TB plastic pilot race on slave is melted from abuse and you...
Forum: C6 Corvette General Discussion
Yesterday, 10:04 PM
Replies: 15
Views: 410
Posted By Dano523

https://cimg2.ibsrv.net/gimg/www.corvetteforum.com...

https://cimg2.ibsrv.net/gimg/www.corvetteforum.com-vbulletin/1297x975/img_0555_2cc8ca1e874235a2e0712b00fc1ba52f0a0c34ef.jpg

Rear main would be leaking from the bottom vent channel in the bell...
Forum: C6 Corvette General Discussion
04-24-2024, 05:47 PM
Replies: 13
Views: 325
Posted By Dano523

Best advice I can give you, a hidden unit...

Best advice I can give you, a hidden unit (something like the Valentine One Remote), since if you do get pulled over for speeding, and have a visible radar detector at the rear view mirror that the...
Forum: C6 Corvette General Discussion
04-24-2024, 05:41 PM
Replies: 35
Views: 688
Posted By Dano523

As pointed out, on a base car, the rear...

As pointed out, on a base car, the rear measurement from fender tips, to ground with car parked on level ground, should be about 1-1/8" higher than the fronts, to get close to 4 wheel balance.
...
Forum: C6 Corvette General Discussion
04-24-2024, 12:49 AM
Replies: 14
Views: 463
Posted By Dano523

JL9 rotors - Front 325mm/12.8"; Rear 305mm/12" ...

JL9 rotors - Front 325mm/12.8"; Rear 305mm/12"

J55 rotors - Front 340mm/13.4"; Rear 330mm/13"

So later is the size of your rotors with the J55 brakes.
Forum: C6 Tech/Performance
04-23-2024, 06:35 PM
Replies: 6
Views: 179
Posted By Dano523

Meth kit running 50/50 mix, and as you pointed...

Meth kit running 50/50 mix, and as you pointed out, Dewalt radiator with dual fan set up and SSR as PWM so you can push the fans harder, and not burn up a stock PWM..

Also, make dam sure you have...
Forum: C6 Corvette General Discussion
04-22-2024, 04:41 PM
Replies: 14
Views: 463
Posted By Dano523

Ditto, look at glove box sticker for RPO code...

Ditto, look at glove box sticker for RPO code Z51, since may just find that the car has only F55 MRC and J55 brakes options alone, and not the rest of the Z51 options.
And just a hint, but Z51 did...
Forum: C6 Corvette General Discussion
04-22-2024, 04:26 PM
Replies: 7
Views: 217
Posted By Dano523

At that point, you remove the fob from slot,...

At that point, you remove the fob from slot, press lock and unlock on the fob at the same time and learning has been completed.

My guess, did not do that, but instead just pull the fob pressed the...
Forum: C6 Corvette General Discussion
04-21-2024, 08:49 PM
Replies: 7
Views: 514
Posted By Dano523

Get your insurance company on the phone and have...

Get your insurance company on the phone and have them send out an adjuster to do a once over on the car once GM dealer states is ready, before you pick it up.
Until its correct (any wrench damage,...
Forum: C6 Corvette General Discussion
04-21-2024, 02:28 PM
Replies: 6
Views: 505
Posted By Dano523

Pulls air in from the vents on the top of the...

Pulls air in from the vents on the top of the front cowling,
At speed, the base of the windsheild creates a high pressure zone, which helps to drive more air through the front cowling vents as well....
Forum: C6 Tech/Performance
04-21-2024, 12:52 AM
Replies: 8
Views: 199
Posted By Dano523

Yes, and no on the tick master cylinder. The...

Yes, and no on the tick master cylinder.

The yes part is the master cylinder is in fact a Tilton aluminum master cylinder that has been converted to use in the C-6, so rebuild able.

The no part...
Forum: C6 Corvette General Discussion
04-19-2024, 02:51 PM
Replies: 13
Views: 408
Posted By Dano523

Walk in the park, Get after market or oem fobs,...

Walk in the park, Get after market or oem fobs, Then SPS flash the RCDLR into relearn mode.

This will work, with the exception of the top auto start button that is not going to work with the...
Forum: C6 Tech/Performance
04-17-2024, 11:56 PM
Replies: 4
Views: 199
Posted By Dano523

C6 has clean side and dirty side of PCV system. ...

C6 has clean side and dirty side of PCV system.

With only dirty side begin caught by single catch can, your still getting oil into the intake manifold during WOT on clean side.
Forum: C6 Corvette General Discussion
04-16-2024, 09:51 AM
Replies: 8
Views: 419
Posted By Dano523

Not going to work, since head intake ports on the...

Not going to work, since head intake ports on the LS2 and the Ls3 are different.
Hence the fast intake for the LS2, has cathedral ports to match the LS2 head intake port sizes.

So only way your...
Forum: C6 Tech/Performance
04-16-2024, 09:45 AM
Replies: 6
Views: 177
Posted By Dano523

And remember, is not you coming off the pedal...

And remember, is not you coming off the pedal that is going to cause the pistons to be pushed back into the calipors, but the rotor spinning that will vibrate on the pads, for them to push the piston...
Forum: C6 Tech/Performance
04-16-2024, 09:39 AM
Replies: 6
Views: 177
Posted By Dano523

Yes, if plunger assembly is not able to come all...

Yes, if plunger assembly is not able to come all the way back with pedal at top rest, so compensation ports are not blocked.

https://www.youtube.com/watch?v=Xk2zGvKfrhc

No, fluid level in is...
Forum: C6 Tech/Performance
04-15-2024, 09:13 PM
Replies: 6
Views: 220
Posted By Dano523

Not a clue, since power stop does not post any...

Not a clue, since power stop does not post any information on their brake pads, such as working heat ranges, or coefficient or frictions either.
https://wiki.seloc.tv/images/4/47/HawkPadChart.jpg...
Forum: C6 Tech/Performance
04-15-2024, 09:09 PM
Replies: 4
Views: 219
Posted By Dano523

Need an after market radio adapter, since C6 has...

Need an after market radio adapter, since C6 has not ACC wire for the radio, and the command to turn the radio on and off, comes digitally from the BCM on the serial 2 bus.

As for which after...
Forum: C6 Tech/Performance
04-15-2024, 09:01 PM
Replies: 7
Views: 188
Posted By Dano523

Yep, clock wise threads, with rubber side of ride...

Yep, clock wise threads, with rubber side of ride height adjuster down, so turning adjuster from top clockwise will thread them down, to raise the car up.

As for getting close on ride heights,...
Forum: C6 Tech/Performance
04-15-2024, 08:54 PM
Replies: 6
Views: 177
Posted By Dano523

Check the pedal adjustment for push rod,since if...

Check the pedal adjustment for push rod,since if master plungers are not allow to come back to get past return bleeder channel, then pressure from master is not allowed to be relieved.
...
Forum: C6 Corvette General Discussion
04-15-2024, 08:31 PM
Replies: 42
Views: 1,589
Posted By Dano523

Crash information will be stored in not only SRS...

Crash information will be stored in not only SRS if air bags deployed, but VCIM if A/H was activated during the crash as well.
Hence why Onstar is tied into the VCIM module, so they can pull its...
Forum: C6 Corvette General Discussion
04-15-2024, 08:22 PM
Replies: 8
Views: 419
Posted By Dano523

Most oil type filters, do not filter the air...

Most oil type filters, do not filter the air correctly until they get a little dirty, and an over oiled air filter, is a quick way to foul up the Maf sensor.

Also to point out, stock oem dry air...
Showing results 1 to 25 of 497
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 08:35 PM.