CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 9
1
2
3
Last »
Search: Posts Made By: SH-60B
Showing results 1 to 25 of 210
Search took 1.38 seconds.
Forum: C4 Tech/Performance
12-01-2023, 08:12 AM
Replies: 3
Views: 210
Posted By SH-60B

Just spitballing, but the first pic is probably...

Just spitballing, but the first pic is probably the clutch safety switch and the second might be cruise control
Forum: C3 General
11-13-2023, 09:03 AM
Replies: 35
Views: 1,295
Posted By SH-60B

I give them away, with a warning of how old they...

I give them away, with a warning of how old they are.
Forum: C3 Tech/Performance
10-27-2023, 01:52 PM
Replies: 92
Views: 2,951
Posted By SH-60B

deleted

deleted
Forum: C4 Tech/Performance
10-25-2023, 10:34 AM
Replies: 28
Views: 633
Posted By SH-60B

https://www.youtube.com/watch?v=hckqOzkTUoU&pp=ygU...

https://www.youtube.com/watch?v=hckqOzkTUoU&pp=ygUodGVzdCBhIDE5OTUgY29ydmV0dGUgYmxvd2VyIG1vdG9yIG1vZHVsZQ%3D%3D
Forum: C4 Tech/Performance
10-23-2023, 10:43 AM
Replies: 28
Views: 633
Posted By SH-60B

Test the old module too

Test the old module too
Forum: C4 Tech/Performance
10-23-2023, 07:52 AM
Replies: 28
Views: 633
Posted By SH-60B

Sportdoc replaced that. What's your solution ?

Sportdoc replaced that. What's your solution ?
Forum: C4 Tech/Performance
10-20-2023, 02:31 PM
Replies: 28
Views: 633
Posted By SH-60B

But you are turning off the power when you turn...

But you are turning off the power when you turn off the car/remove the key. Is the blower motor powered though a relay? I'd look at that, they can fail.
Forum: C4 Tech/Performance
10-19-2023, 08:55 AM
Replies: 20
Views: 2,246
Posted By SH-60B

Start a new thread, this one's 6 years old and...

Start a new thread, this one's 6 years old and things change
Forum: C3 Tech/Performance
10-13-2023, 11:14 AM
Replies: 21
Views: 1,119
Posted By SH-60B

An LS swap will need some light fabrication but...

An LS swap will need some light fabrication but if you're comfortable with that it should be considered. You can get a good used Vortec truck motor for pretty cheap. It will have the heads you first...
Forum: C4 General Discussion
10-12-2023, 06:47 AM
Replies: 8
Views: 356
Posted By SH-60B

Nice car and neighbor.

Nice car and neighbor.
Forum: C3 Tech/Performance
10-11-2023, 11:48 AM
Replies: 24
Views: 789
Posted By SH-60B

And you're worried over $600?

And you're worried over $600?
Forum: C3 Tech/Performance
10-10-2023, 03:11 PM
Replies: 24
Views: 789
Posted By SH-60B

Then you're better off with a Maseratti

Then you're better off with a Maseratti
Forum: C3 Tech/Performance
10-10-2023, 09:36 AM
Replies: 24
Views: 789
Posted By SH-60B

Just go with steel and avoid all the issues. When...

Just go with steel and avoid all the issues. When you use those gaskets you're introducing another sealing surface into the joint that's un necessary. I had so much trouble with the SS lines on the...
Forum: C3 General
09-27-2023, 11:10 AM
Replies: 26
Views: 1,272
Posted By SH-60B

My parking pass when I bring it to work.

My parking pass when I bring it to work.
Forum: C4 Tech/Performance
09-22-2023, 09:40 AM
Replies: 13
Views: 1,342
Posted By SH-60B

Get your car up on a lift and look at the...

Get your car up on a lift and look at the clearance you have now with the 4L60E. Get some basic dimensions from 10 speed and get an idea of the clearance that one will need. You could widen the...
Forum: C3 Tech/Performance
09-19-2023, 08:03 AM
Replies: 30
Views: 902
Posted By SH-60B

If there's not a black wire in the plug/harness...

If there's not a black wire in the plug/harness I'd ground the housing.
Forum: C4 Tech/Performance
09-15-2023, 11:02 AM
Replies: 10
Views: 535
Posted By SH-60B

lol!

lol!
Forum: C4 Tech/Performance
09-01-2023, 06:08 AM
Replies: 17
Views: 638
Posted By SH-60B

If I found myself at this point I would continue...

If I found myself at this point I would continue drilling but with a smaller bit than that. I have also used a small drift and hit the bottom of the hole to try and break the corrosion bond . IDK if...
Forum: C5 Tech
08-15-2023, 07:10 AM
Replies: 3
Views: 341
Posted By SH-60B

Look closely at the head gaskets in the areas...

Look closely at the head gaskets in the areas between the pistons and all of the water passages for an obvious breach. The mating surfaces of the block and heads also in those areas might reveal...
Forum: C4 Tech/Performance
08-09-2023, 12:34 PM
Replies: 36
Views: 1,860
Posted By SH-60B

Yes the 4L80E is described as a th400 but...

Yes the 4L80E is described as a th400 but electric and with overdrive. It's dimensionally larger than the 4L60e/TH700R4 and has more torque capacity.

BTW, I drove a little pickup truck for years...
Forum: C4 Tech/Performance
08-08-2023, 10:49 AM
Replies: 4
Views: 253
Posted By SH-60B

The car wouldn't run without power to the fuel...

The car wouldn't run without power to the fuel pump, I'd suspect the tester. You should be able to hear the Fuel Pump prime when you turn the key to "on". Does the blower motor run when you apply 12...
Forum: C4 General Discussion
08-07-2023, 03:07 PM
Replies: 15
Views: 424
Posted By SH-60B

Did you check battery voltage on the old one? A...

Did you check battery voltage on the old one? A good battery should have 13.6V or more. If thats good examine the cables.
Forum: C4 Tech/Performance
08-07-2023, 03:00 PM
Replies: 4
Views: 253
Posted By SH-60B

Did the blower motor stop? There is a resistor in...

Did the blower motor stop? There is a resistor in the duct that controls the motor speeds that fails from time to time.
Forum: C4 General Discussion
08-01-2023, 09:10 AM
Replies: 9
Views: 393
Posted By SH-60B

See what Jegs or Summit has for header wrap/heat...

See what Jegs or Summit has for header wrap/heat wrap, unless you're doing a restoration.
Forum: C4 Tech/Performance
07-27-2023, 11:00 AM
Replies: 36
Views: 1,860
Posted By SH-60B

The converter lockup solenoid.

The converter lockup solenoid.
Showing results 1 to 25 of 210
 
Page 1 of 9
1
2
3
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 08:48 PM.