CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: k24556
Showing results 1 to 25 of 496
Search took 2.61 seconds.
Forum: Autocrossing & Roadracing Classifieds
08-09-2022, 05:09 PM
Replies: 0
Views: 507
Posted By k24556

Trailer Tire Rack

All aluminum tire rack, 77 inches wide.Bolts to trailer . $475 local pickup huntersville NC PM if interested. Made from 1.5x3 80/20 extrusion Sold, Pending Funds
...
Forum: C5 Tech
04-16-2022, 08:53 AM
Replies: 7
Views: 457
Posted By k24556

here are some ideas to consider: *Engine...

here are some ideas to consider:
*Engine running lean. need to diagnose fuel trims. if running lean, the vacuum leak trouble shooting in order
*PCV system not working properly, allowing oil to be...
Forum: C7 Parts for Sale/Wanted
12-16-2021, 07:03 AM
Replies: 6
Views: 1,104
Posted By k24556

Thanks. They are sold. The sale went through

Thanks. They are sold. The sale went through
Forum: C5 Tech
11-05-2021, 09:48 AM
Replies: 12
Views: 755
Posted By k24556

Amazon is covered up with knock offs in OEM...

Amazon is covered up with knock offs in OEM looking packages. I would order bearings from Summit or Rock Auto so you have recourse.

Axles are another story. Rebuilt ones don’t have the high speed...
Forum: C5 Tech
10-29-2021, 05:29 PM
Replies: 10
Views: 3,087
Posted By k24556

Be careful what you delete

Be careful what you delete
Forum: C7 Parts for Sale/Wanted
10-29-2021, 09:10 AM
Replies: 6
Views: 1,104
Posted By k24556

(SOLD) Competition Seat backs

i have a GM competition seat back kit I bought from Trunk Monkey (Suburban Chevrolet) in 2018. I installed them in my C7 Z51 and took them out when I could no longer run at the track. They are the...
Forum: C5 Tech
10-29-2021, 07:42 AM
Replies: 10
Views: 3,087
Posted By k24556

check out this site: This guy is pretty much an...

check out this site: This guy is pretty much an expert on GM PCM’s. https://lt1swap.com/wiringharness.htm


the 411 PCM us used in many chev and GMC trucks that have the 5.3 and 6.0 engines. He...
Forum: C5 Tech
10-23-2021, 04:52 PM
Replies: 6
Views: 962
Posted By k24556

There are two bolts that hold the steering rack...

There are two bolts that hold the steering rack to the cradle. Driver side a hard one to tighten. the pass side has a bushing that could be shot. Not unusual to find eithe bolt a bit loose.

The...
Forum: C5 Tech
10-19-2021, 03:01 PM
Replies: 6
Views: 748
Posted By k24556

How about pulling the DTC codes. There may be a...

How about pulling the DTC codes. There may be a clue in the DTC’s as there are some codes related to the cam/crank sensor, particularly, for shorts and open circuits. When you say you swapped...
Forum: C5 Tech
10-13-2021, 11:05 AM
Replies: 4
Views: 519
Posted By k24556

At the risk of seeming sarcastic, have you tried...

At the risk of seeming sarcastic, have you tried mechanical trouble shooting?

Watch the cable termination. Move the parking brake lever. Does the cable end move? (right behind the backing plate,...
Forum: C5 Tech
10-12-2021, 09:29 AM
Replies: 4
Views: 519
Posted By k24556

The brakes are adjusted by measuring the diameter...

The brakes are adjusted by measuring the diameter of the drum in the rotor and measuring the diameter of the shoe, 90 degrees away from what you are calling the cylinder. All you need is a flat blade...
Forum: C5 Tech
10-05-2021, 07:49 AM
Replies: 1
Views: 404
Posted By k24556

1 Research here, look up rocking seat fix....

1 Research here, look up rocking seat fix. Several vendors sell repair kits to fix. There are some youtube videos on fixing this too.
2. Another common problem again search here. The fix is...
Forum: C5 Tech
10-04-2021, 03:18 PM
Replies: 2
Views: 326
Posted By k24556

nope, no concern the knuckle will hold it. You...

nope, no concern the knuckle will hold it. You want it to allow grease to squeeze out when you grease it. Normal.
Forum: C5 Tech
09-27-2021, 01:44 PM
Replies: 2
Views: 275
Posted By k24556

not sure what you are asking. C5 keys are not...

not sure what you are asking. C5 keys are not programmable. The key fob syncs with the car. The key has a resistor pellet that has to match what the car expects the resistance to be, What does “new...
Forum: C7 Tech/Performance
09-25-2021, 10:55 AM
Replies: 5
Views: 2,174
Posted By k24556

Several of us routed the sub belt under the...

Several of us routed the sub belt under the boutte and secured with the harness plate that secures the lap belt. Although it was a compromise, I found that sitting on the belt uncomfortable. Also,...
Forum: C5 Tech
09-25-2021, 10:27 AM
Replies: 12
Views: 978
Posted By k24556

A second poster has a similar problem. perhaps...

A second poster has a similar problem. perhaps the suggestions here will help that person. However, you are correct, a little courtesy would be nice. Follow ups of what was found has value to all of...
Forum: C5 Tech
09-25-2021, 09:44 AM
Replies: 12
Views: 978
Posted By k24556

I use a Motive too. Then yoou can get enough...

I use a Motive too. Then yoou can get enough fluid through to make sure there is no air. I just use the Motive as a pressure source. Brake fluid dries out the tygon tubing, and if it blows out, you...
Forum: C5 Tech
09-25-2021, 08:51 AM
Replies: 12
Views: 978
Posted By k24556

The wheel speed sensors are inside the bearing...

The wheel speed sensors are inside the bearing hubs. Hard to get fluid in them as they are pretty well sealed. ATEtyp 200 is a DOT 4 fluid and is compatible, so it should not be the cause

Use the...
Forum: C5 Tech
09-23-2021, 06:37 PM
Replies: 9
Views: 521
Posted By k24556

the gas tank vents through the charcoal canister....

the gas tank vents through the charcoal canister. you probably have a plugged vent path or the charcoal canister is saturated with liquid.

Is your car possibly a flood damaged car?
Forum: C5 Tech
09-18-2021, 01:55 PM
Replies: 6
Views: 418
Posted By k24556

C5 diag has a good youtube video about the fuel...

C5 diag has a good youtube video about the fuel pump circuit.
Forum: C5 Tech
09-18-2021, 07:46 AM
Replies: 6
Views: 418
Posted By k24556

The more I think about starting an engine that is...

The more I think about starting an engine that is only supported by the engine mounts and probably a block of wood and a jack, the less I think it is a good idea at all.
Forum: C5 Tech
09-17-2021, 07:15 PM
Replies: 6
Views: 418
Posted By k24556

When you drop the drive train you usually have to...

When you drop the drive train you usually have to disconnect a ground lug at G401. It is on the frame behind the LR wheel, find the wire with the eye attach it and the fuel pump will work.. That is...
Forum: C5 Tech
09-14-2021, 09:43 AM
Replies: 27
Views: 1,353
Posted By k24556

Your photos show standard valve springs. The LS6...

Your photos show standard valve springs. The LS6 had beehives. So, someone has been there before. You may already have an LS1 in the car.

Your photos show both keeper halves laying next to the...
Forum: C5 Tech
09-06-2021, 05:40 PM
Replies: 47
Views: 4,476
Posted By k24556

If you are considering having someone with...

If you are considering having someone with diagnostic experience, I suggest you get in touch with Ivan at Pine Hollow Diagnostics. He is in State College PA and has a really great YouTube channel....
Forum: C5 Tech
09-06-2021, 02:54 PM
Replies: 47
Views: 4,476
Posted By k24556

One very common problem is the battery. It is...

One very common problem is the battery. It is common that people replace with wet cell batteries, and the acid spills out of the cells. You will see crusties and green/yellow corrosion products...
Showing results 1 to 25 of 496
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 06:49 AM.