CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: SweetZO6
Showing results 1 to 25 of 488
Search took 1.58 seconds.
Forum: C6 Corvette ZR1 & Z06
11-10-2021, 10:44 AM
Replies: 17
[ZR1] ZR1 is gone.
Views: 1,121
Posted By SweetZO6

It is a 2010 CMG 3ZR #768 with 54k miles. I...

It is a 2010 CMG 3ZR #768 with 54k miles. I bought it with 9700 miles in 2015 as a CPO car. At 11,000 miles the HVAC controller and the driver door lock mechanism were replaced. At 12,000 miles the #...
Forum: C6 Corvette ZR1 & Z06
11-09-2021, 07:38 PM
Replies: 17
[ZR1] ZR1 is gone.
Views: 1,121
Posted By SweetZO6

ZR1 is gone.

Traded the ZR1 today for a more practical vehicle for a 74 year old with aching knees. Got a 2022 Nissan Armada Platinum Reserve. Armada was 80k and I got 65k trade for the ZR1with 54,013 miles on...
Forum: C6 Corvette ZR1 & Z06
09-22-2021, 12:52 PM
Replies: 5
Views: 655
Posted By SweetZO6

This is what Brisk tech sent me. Hello Ed, ...

This is what Brisk tech sent me. Hello Ed,

If the motor is completely stock the silver racing line part number you need is our Brisk Silver Racing GR14YS

Best Regards,

Bret Lednicky

Brisk...
Forum: C6 Corvette ZR1 & Z06
09-21-2021, 10:05 PM
Replies: 5
Views: 655
Posted By SweetZO6

Since I posted this thread, I contacted Brisk...

Since I posted this thread, I contacted Brisk technical support. They said, as long as it is stock, GR14YS is the recommended plug. Gonna try a set.

Ed
Forum: C6 Corvette ZR1 & Z06
09-19-2021, 05:07 PM
Replies: 5
Views: 655
Posted By SweetZO6

Brisk Silver Tip Racing Plugs

Anyone have the Brisk part # for the ZR1 plugs. My ZR1 is stock.

Ed
Forum: C6 Corvette ZR1 & Z06
06-23-2021, 10:11 PM
Replies: 18
Views: 2,056
Posted By SweetZO6

I have a ‘10 ZR1 that had the original battery in...

I have a ‘10 ZR1 that had the original battery in it when I bought it in’15. I replaced it with a yellow top Optima and after 6 months, I replaced it. It would not hold a enough charge over 12 days...
Forum: C6 Corvette ZR1 & Z06
06-03-2021, 05:23 PM
Replies: 37
Views: 2,688
Posted By SweetZO6

Agree. No grip is the only Hellcat deficiency I...

Agree. No grip is the only Hellcat deficiency I have and, imho, dangerous, especially passing cars. I have Pedal Commander throttle controllers on the HC and ZR1. The throttle response on both is...
Forum: C6 Corvette ZR1 & Z06
05-30-2021, 07:40 PM
Replies: 37
Views: 2,688
Posted By SweetZO6

Well, they all were not trouble free miles. It...

Well, they all were not trouble free miles. It was a CPO car and just before that warranty expired (21000 miles) #4 cylinder exhaust valve spring broke during idle. No valve or piston damage. That...
Forum: C6 Corvette ZR1 & Z06
05-29-2021, 06:55 PM
Replies: 37
Views: 2,688
Posted By SweetZO6

I got my ZR1 in 2015 with 9700 miles. Today I...

I got my ZR1 in 2015 with 9700 miles. Today I have 53K miles on the beast and have enjoyed every mile. It is an AWESOME ride. The CMG with black satin cups is a real head tuner. My 7 year old...
Forum: C6 Corvette ZR1 & Z06
05-28-2021, 08:45 PM
Replies: 37
Views: 2,688
Posted By SweetZO6

I also have one of each. 2010 CMG ZR1 3ZR and a...

I also have one of each. 2010 CMG ZR1 3ZR and a 2016 pearl white Charger Hellcat.

IMHO, at 73 years young, my ZR1 is stupid fast. My Hellcat is stupid fast and very, very comfortable. After...
Forum: C6 Corvette ZR1 & Z06
05-22-2021, 09:30 PM
Replies: 2
Views: 441
Posted By SweetZO6

Need Some Brake Rotor Advice

Have a 2010 3ZR with 53K on the clock and black cup wheels. When I bought it in 2015, it had 9700 miles on it. Had the engine coolant changed yesterday since it was the original coolant. While on the...
Forum: C6 Corvette ZR1 & Z06
05-07-2021, 11:33 AM
Replies: 12
Views: 2,055
Posted By SweetZO6

OP, apologies about the badge pins info. I...

OP, apologies about the badge pins info. I thought you were talking about the flag badges. My rear ZR1badge is 1/16” lower at the blue 1. Not going to change it for 1/16”.

Ed
Forum: C6 Corvette ZR1 & Z06
05-05-2021, 03:24 PM
Replies: 12
Views: 2,055
Posted By SweetZO6

You can remove one of the taillights and reach in...

You can remove one of the taillights and reach in and check for pins/holes.

Ed
Forum: C6 Corvette ZR1 & Z06
05-05-2021, 10:16 AM
Replies: 12
Views: 2,055
Posted By SweetZO6

The OEM badges are pinned to fit in factory...

The OEM badges are pinned to fit in factory drilled holes. Only one way to install. Either a bad badge was installed when built or the holes were drilled wrong. I don’t believe aftermarket badges...
Forum: C6 Corvette ZR1 & Z06
04-29-2021, 07:41 AM
Replies: 28
Views: 2,618
Posted By SweetZO6

So did GM use the same valve guides in the LS9...

So did GM use the same valve guides in the LS9 that were used in the LS7? Are there less LS9 failures due to a lot of ZR1s with very low miles compared to the LS7 ZO6s? Is it a lubricant quality...
Forum: C6 Corvette ZR1 & Z06
04-28-2021, 03:22 PM
Replies: 28
Views: 2,618
Posted By SweetZO6

The only valve train issue I had was a broken #4...

The only valve train issue I had was a broken #4 cylinder exhaust valve spring @ 19,000 miles. It happened at idle so no piston slap or valve damage. I borescoped the cylinder after the repair. The...
Forum: C6 Corvette ZR1 & Z06
04-27-2021, 03:04 PM
Replies: 28
Views: 2,618
Posted By SweetZO6

Yeah, lied to again. When I discussed the...

Yeah, lied to again. When I discussed the replacement SC with the dealer, I said the same thing. The parts guy assured me that my replacement SC has an updated coupler. I thought, right, Eaton...
Forum: C6 Corvette ZR1 & Z06
04-20-2021, 09:28 PM
Replies: 28
Views: 2,618
Posted By SweetZO6

I don’t know when my coupler failed. I bought my...

I don’t know when my coupler failed. I bought my 2010 ZR1 in 2015 with 9600 miles. I thought the noise was a little bit of rotor slap. After reading another thread, the owner said he heard a rattling...
Forum: C6 Corvette ZR1 & Z06
04-17-2021, 07:57 AM
Replies: 35
Views: 3,197
Posted By SweetZO6

I’m 73, live in the Peoples Republic of MD and...

I’m 73, live in the Peoples Republic of MD and insured by USAA. $924.00 per year with $1,000 deductible.

Ed
Forum: C6 Corvette ZR1 & Z06
02-21-2021, 09:11 PM
Replies: 2
Views: 438
Posted By SweetZO6

Follow Up Question to The “Moderstors”

Why is it the C4 has it's own ZR1 section, the C7 has it's own ZR1 section, yet the C6 ZR1 has been grouped with the Z06 when there are more C6 Zr1's built vs the C7 Zr1's?

I asked the same...
Forum: C6 Corvette ZR1 & Z06
01-20-2021, 05:45 PM
Replies: 6
Views: 573
Posted By SweetZO6

Did you spray any lubricant like WD 40 on it and...

Did you spray any lubricant like WD 40 on it and manually activate it several times? If you are not careful, a piece of debris can jet jammed in it. Should be able to remover the cover and visually...
Forum: C6 Corvette ZR1 & Z06
01-16-2021, 12:55 PM
Replies: 28
Views: 4,442
Posted By SweetZO6

It’s true! I have a ‘10 ZR1 and a ‘16 Charger...

It’s true! I have a ‘10 ZR1 and a ‘16 Charger Hellcat. Only thing I hear on the Z is a moan. Very little whine. I have a K&N carbon fiber CAI intake on it. The HC SCREAMS!!!! I have a K&N Typhoon...
Forum: C6 Corvette ZR1 & Z06
01-14-2021, 09:46 PM
Replies: 13
Views: 2,259
Posted By SweetZO6

Loosen the SC belt tensioner and check the play...

Loosen the SC belt tensioner and check the play between the pulley and shaft. If there is any, it is the SC isolator coupler and not the LS9. Mine had a 1/2” of play. My SC was replaced under...
Forum: C6 Corvette ZR1 & Z06
01-07-2021, 10:20 PM
Replies: 12
Views: 1,415
Posted By SweetZO6

OP, if you don’t hear a rattle at idle, your...

OP, if you don’t hear a rattle at idle, your coupler is, more than likely, ok. Mine had a distinct rattle at idle and after loosing the belt tensioner, I had 1/2” of play between the pulley and the...
Forum: C6 Corvette ZR1 & Z06
12-06-2020, 10:01 PM
Replies: 6
Views: 768
Posted By SweetZO6

Stefuel, I contacted Jack Granatelli after I...

Stefuel, I contacted Jack Granatelli after I installed his 85K coils to ask him why his coils solve my off idle clutch shutter. He told me that with the OEM coils coming off idle and under load they...
Showing results 1 to 25 of 488
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 10:36 AM.