Search: Posts Made By: Mr.1984
Showing results 1 to 25 of 44
Search took 1.15 seconds.
02-18-2012, 05:18 AM
Replies: 28
Views: 1,249
Posted By Mr.1984

Newthread located in forced induction section....

Newthread located in forced induction section. Decided to listen to a few members on the forum. Talked it out with a few others and came to the conclusion it is best to start off with something a...
02-18-2012, 12:35 AM
Replies: 5
Views: 2,566
Posted By Mr.1984

Blown 84

New project using stock heads and block. SBC 6-71 Blower single carb an 800. Having the block splayed, rods reconditioned, forged 350 crank, bored to .030, forged dish pistons, comp cam kit,...
02-17-2012, 07:07 PM
Replies: 5
Views: 2,282
Posted By Mr.1984

How did you remove it from the door?

How did you remove it from the door?
02-14-2012, 12:58 AM
Replies: 28
Views: 1,249
Posted By Mr.1984

My fiancé loves it. So it won't be her.

My fiancé loves it. So it won't be her.
02-14-2012, 12:11 AM
Replies: 28
Views: 1,249
Posted By Mr.1984

Hopefully that doesn't happen But I'll try to get...

Hopefully that doesn't happen But I'll try to get it finished on my vacation time so it doesn't drag out. If my cousin and I can get a week off together it's all finished. We swapped an engine out of...
02-13-2012, 02:40 PM
Replies: 28
Views: 1,249
Posted By Mr.1984

I would say it is a dream as of now but ive...

I would say it is a dream as of now but ive decided I'll do anything to achieve that dream. As of now I have the car that's all. I'm going to wait until I have half of the money needed. So I will do...
02-12-2012, 06:07 PM
Replies: 28
Views: 1,249
Posted By Mr.1984

Thinking of an 800+ HP engine supercharger and...

Thinking of an 800+ HP engine supercharger and nitrous combo. In my mind 500-600 HP is going to run 11-13k but I can substitute 200 shot of nos every now and then for about $600
02-11-2012, 06:53 AM
Replies: 7
Views: 538
Posted By Mr.1984

Thank you

Thank you all for your help.
02-11-2012, 06:28 AM
Replies: 28
Views: 1,249
Posted By Mr.1984

Question about 84 engine

IF I were looking to sell an 84 crossfire engine turn key engine everything from the harness to the ECM and dash radiator hoses ac components front portion of fuel lines hedman hedders minus the smog...
05-23-2011, 11:32 PM
Replies: 7
Views: 538
Posted By Mr.1984

flat tapped and about 250. another question is it...

flat tapped and about 250. another question is it possible to only get larger pushrods to create a larger lift insted of buying another cam, or will it create a problem. like say .150 or .250 longer...
05-23-2011, 08:39 PM
Replies: 7
Views: 538
Posted By Mr.1984

machine work

Im going to bore my engine to .040 and install a new cam. I have a 84 crossfire what kind of part list am I looking at. what should the lift on the cam be?
04-06-2011, 02:00 PM
Replies: 0
Views: 502
Posted By Mr.1984

please help! A/c and Air pump removal on 84

guys I need some help i am removing my air pump and A/c compressor from my 84. I already have the condenser off and my coolant hose connected from the intake to the water pump.I also know that the ac...
03-27-2011, 11:14 PM
Replies: 0
Views: 240
Posted By Mr.1984

84 a/c wire harness removal

trying to clean up the engine compartment need to remove the harness but it has some sort of silicone bonding all the wires together any ideas that will not ruin the harness. maybe im just too close...
10-12-2010, 11:19 PM
Replies: 15
Views: 11,428
Posted By Mr.1984

My setup was stolen over the summer. I had...

My setup was stolen over the summer. I had everything needed to do the nitrous. but now i am kind of glad they did because my engine is slowly starting to wear away. i guess it just wasnt meant to...
07-13-2010, 10:49 PM
Replies: 3
Views: 1,081
Posted By Mr.1984

I guess I have to keep it in 3 until i can get...

I guess I have to keep it in 3 until i can get one later this week drive only on a have to basis.
07-13-2010, 09:40 PM
Replies: 3
Views: 1,081
Posted By Mr.1984

Shake or Shudder What is wrong

:eek:Whether you call it a shake or shudder something is terribly wrong i believe it is in the transmission driveline area. When my car is shifting from 1-2 nothing happens 2-3 nothing happens but...
07-11-2010, 04:36 AM
Replies: 4
Views: 832
Posted By Mr.1984

84 shaking violently

When I drive my 84 crossfire around 55-70 mph i have a violent shake in my front end. but levels out around 75 also when my trans kicks into drive it acts like it is struggling to gain speed. do i...
06-09-2010, 12:21 PM
Replies: 2
Views: 342
Posted By Mr.1984

My bad the price is $350

My bad the price is $350
06-08-2010, 01:25 PM
Replies: 0
Views: 312
Posted By Mr.1984

Misc parts for sale

Stock 84 Manifold with heat shield-------------------$50

Chrome timing chain cover----------------------------$15

Rear bumper Emblem----------------------------------$15

C4 Xenon light...
06-08-2010, 01:00 PM
Replies: 0
Views: 252
Posted By Mr.1984

F/S Nitrous and extra parts

Selling my nitrous kit for my 84 vette this is a dry kit that i never installed comes with: $350

10 lb bottle
10 feet of line
Nitrous solenoid
2 dry Nozzles
2 Stainless 50 hp jets
3-an tee...
06-08-2010, 12:57 PM
Replies: 2
Views: 342
Posted By Mr.1984

F/S Nitrous and extra parts

Selling my nitrous kit for my 84 vette this is a dry kit that i never installed comes with: $350

10 lb bottle
10 feet of line
Nitrous solenoid
2 dry Nozzles
2 Stainless 50 hp jets
3-an tee...
04-11-2010, 11:32 PM
Replies: 16
Views: 1,844
Posted By Mr.1984

Please Bump:thumbs:

Please Bump:thumbs:
04-11-2010, 11:06 PM
Replies: 0
Views: 551
Posted By Mr.1984

Trade 10lb bottle for 2 lb bottle of Nos!

Will anyone trade me their 2lb bottle of Nos for My 10lb bottle? Has brackets and bottle fitting. Edelbrock is the brand. Getting tired of this big bottle decided to go with a hidden kit.
03-16-2010, 06:44 PM
Replies: 9
Views: 662
Posted By Mr.1984

that would work also do you have one or know...

that would work also do you have one or know anyone who does?
03-15-2010, 11:21 PM
Replies: 16
Views: 1,844
Posted By Mr.1984

Np if you ever change your mind let me know.

Np if you ever change your mind let me know.
Showing results 1 to 25 of 44
 


 
Forum Jump


All times are GMT -4. The time now is 03:06 PM.