Search: Posts Made By: RUU
Showing results 1 to 25 of 254
Search took 1.28 seconds.
04-17-2024, 10:53 AM
Replies: 13
Views: 149
Posted By RUU

I would start with the ICM. It is attached to a...

I would start with the ICM. It is attached to a finned heat sink which is bolted to the cylinder head. The heat sink can get quite dirty and greasy which decreases its ability to cool the ICM. There...
04-04-2024, 09:24 AM
Replies: 26
Views: 854
Posted By RUU

Those are not stock sizes.

Those are not stock sizes.
03-14-2024, 11:34 AM
Replies: 3
Views: 192
Posted By RUU

I think you'll be fine. There will be 12-13...

I think you'll be fine. There will be 12-13 inches of depth under the top at the rear of the trunk which goes down to 8-9 inches at the front. The transparent top should have more room underneath...
03-11-2024, 07:18 PM
Replies: 6
Views: 387
Posted By RUU

Should be pretty easy to Google convert your...

Should be pretty easy to Google convert your current litres/100km to Imperial and US MPG. Whichever is closest is the answer.
03-04-2024, 09:15 AM
Replies: 68
Views: 2,096
Posted By RUU

Sorry, missed that detail. I installed a set...

Sorry, missed that detail. I installed a set several years ago and they were basically the same as the originals except they weren't numbered.
03-03-2024, 04:59 PM
Replies: 68
Views: 2,096
Posted By RUU

FYI, Corvette Central appears to still carry OEM...

FYI, Corvette Central appears to still carry OEM style LT-4 plug wires. They do fit the factory looms....
02-14-2024, 11:03 PM
Replies: 68
Views: 2,096
Posted By RUU

Sounds more expensive than just shipping the...

Sounds more expensive than just shipping the transmission, but you're probably ready to drive it rather than continuing to wrench on it.
Forum: C3 General
02-11-2024, 02:30 PM
Replies: 59
Views: 3,137
Posted By RUU

:iagree: Loved his Sparty restoration thread....

:iagree: Loved his Sparty restoration thread. :sadangel:
02-01-2024, 02:39 PM
Replies: 3
Views: 160
Posted By RUU

Last Dephi fuel pump I bought for my '96 (FE0114)...

Last Dephi fuel pump I bought for my '96 (FE0114) was made in China. The one prior was made in Mexico. Both lasted about 3-5 years each. Would not buy again.
01-12-2024, 11:35 PM
Replies: 17
Views: 489
Posted By RUU

FWIW, the OP has a C3 in their avatar, so it may...

FWIW, the OP has a C3 in their avatar, so it may be that they have posted to the wrong section. Just a hunch...
12-21-2023, 11:41 AM
Replies: 4
Views: 275
Posted By RUU

There are vacuum lines associated with the HVAC...

There are vacuum lines associated with the HVAC system, but I think they only control what vents the air comes out of. You may have an issue with the blend door actuator. Try disconnecting the...
12-21-2023, 11:18 AM
Replies: 15
Views: 415
Posted By RUU

Tire Rack has a page with links to some...

Tire Rack has a page with links to some manufacturers documents related to replacement information.
https://www.tirerack.com/upgrade-garage/what-do-tire-manufacturers-say-about-tire-age

Seems...
12-04-2023, 09:40 AM
Replies: 10
Views: 363
Posted By RUU

:iagree: Cruise and HVAC controller both depend...

:iagree: Cruise and HVAC controller both depend on this check valve.
09-01-2023, 11:08 AM
Replies: 9
Views: 342
Posted By RUU

:iagree:

:iagree:
08-31-2023, 01:47 PM
Replies: 3
Views: 272
Posted By RUU

What about just jacking the car up a bit on one...

What about just jacking the car up a bit on one side? Then all the gas should be on the opposite side of the tank.
07-08-2023, 01:59 PM
Replies: 51
Views: 2,156
Posted By RUU

I agree with checking the fuel pressure. Since it...

I agree with checking the fuel pressure. Since it was sitting in a rainstorm, is it possible rain water got in the gas tank? Especially if drain under the fuel door is plugged and water accumulates...
07-01-2023, 09:58 AM
Replies: 11
Views: 752
Posted By RUU

Do you use any products on the dashboard that...

Do you use any products on the dashboard that could be off-gassing onto the windshield?
06-27-2023, 04:18 PM
Replies: 3
Views: 364
Posted By RUU

You may want to try asking this in the Canadian...

You may want to try asking this in the Canadian Events section. It's mostly people from the GTA that post there.
06-19-2023, 02:26 PM
Replies: 7
Views: 617
Posted By RUU

As stated, most likely the anti-rattle clips are...

As stated, most likely the anti-rattle clips are missing. They are often included with a caliper pin kit....
06-07-2023, 09:11 AM
Replies: 5
Views: 309
Posted By RUU

Are you sure you have it on the whole way? The...

Are you sure you have it on the whole way? The "nodes" on the strainer just grip the neck on the pump inlet. I have found they take a fair amount of effort to put on.
05-31-2023, 09:06 AM
Replies: 6
Views: 426
Posted By RUU

May not be red loctite. The original and...

May not be red loctite. The original and replacement knock sensors I've seen have had red thread sealant on them.
04-24-2023, 01:59 PM
Replies: 16
Views: 1,028
Posted By RUU

I've noticed that NAPA sells a lot of repackaged...

I've noticed that NAPA sells a lot of repackaged Gates products at a much higher price than the corresponding Gates branded product can be had for. Even the product numbers are almost the same.
04-16-2023, 06:59 PM
Replies: 8
Views: 453
Posted By RUU

https://cimg1.ibsrv.net/gimg/www.corvetteforum.com...

https://cimg1.ibsrv.net/gimg/www.corvetteforum.com-vbulletin/720x1280/screenshot_20230416_185626_26e54827e2a8c66129c53b0ef6923fffa2467576.png
04-15-2023, 04:04 PM
Replies: 8
Views: 453
Posted By RUU

If you're not stuck on original finishes : ...

If you're not stuck on original finishes :
https://americanhydrocarbon.com/product/c4-corvette-radio-bezel-and-shifter-console-kit-83-96/
04-13-2023, 08:27 PM
Replies: 3
Views: 457
Posted By RUU

Looks like the vent/drain fitting on the starter....

Looks like the vent/drain fitting on the starter. I can't remember exactly where on the starter it is fastened to.
Showing results 1 to 25 of 254
 


 
Forum Jump


All times are GMT -4. The time now is 01:16 AM.