CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: stevieturbo
Showing results 1 to 25 of 494
Search took 1.58 seconds.
Forum: C5 Forced Induction/Nitrous
04-19-2024, 01:57 PM
Replies: 12
Views: 482
Posted By stevieturbo

Swap to a larger supercharger. It'll make sense...

Swap to a larger supercharger. It'll make sense in the long run.
Forum: C5 Forced Induction/Nitrous
09-15-2023, 03:03 PM
Replies: 35
Views: 1,890
Posted By stevieturbo

interesting to try and compare to EV's But...

interesting to try and compare to EV's

But even with those, the makers try to use higher voltages for better performance and efficiency there too. Obviously there are safety limits as to how high....
Forum: C5 Forced Induction/Nitrous
09-14-2023, 02:53 PM
Replies: 35
Views: 1,890
Posted By stevieturbo

king copy n paste, really, you're not worth the...

king copy n paste, really, you're not worth the effort. If being a forum admin is the pinnacle of your existence and gives you the credibility you seek....fair play. I've seen forum admins elsewhere...
Forum: C5 Forced Induction/Nitrous
09-13-2023, 05:17 PM
Replies: 35
Views: 1,890
Posted By stevieturbo

mad ? lol....go back to your moms basement.

mad ? lol....go back to your moms basement.
Forum: C5 Forced Induction/Nitrous
09-13-2023, 12:46 PM
Replies: 35
Views: 1,890
Posted By stevieturbo

Again it is physically impossible when some large...

Again it is physically impossible when some large injectors operate so slowly to actually open and close, often you'll try and command a lower value than is physically possible for the injector. So...
Forum: C5 Forced Induction/Nitrous
09-13-2023, 12:43 PM
Replies: 35
Views: 1,890
Posted By stevieturbo

There's a reason talon is banned on most...

There's a reason talon is banned on most forums....his bullshit just never ends. Running a low pressure is idiotic. End of story, unless he wants a carb.

And his spouting about injection timing is...
Forum: C5 Forced Induction/Nitrous
09-12-2023, 01:59 PM
Replies: 35
Views: 1,890
Posted By stevieturbo

No it won't, if working correctly with stock...

No it won't, if working correctly with stock setup, within it's flow abilities, pressure will remain pretty constant. Not withstanding losses from the reg being at the back...but again this comes to...
Forum: C5 Forced Induction/Nitrous
09-12-2023, 12:45 PM
Replies: 35
Views: 1,890
Posted By stevieturbo

he's full of shit, ignore most of what he says....

he's full of shit, ignore most of what he says. Obviously with lower pressures, spray patterns turn to shit so clearly it is a very dumb notion.
Forum: C5 Forced Induction/Nitrous
09-03-2023, 03:40 PM
Replies: 35
Views: 1,890
Posted By stevieturbo

It is not "normal", and they should not have...

It is not "normal", and they should not have tuned around it

They should have clearly stated you need to fix the problem, and when it is fixed, you will need retuned.

Even at 5psi boost, that's...
Forum: C5 Forced Induction/Nitrous
07-15-2023, 04:08 PM
Replies: 20
Views: 1,944
Posted By stevieturbo

You're all over the place. So you want...

You're all over the place.

So you want 1000hp...but not now ?

You want a turbo kit, but then you want to build your own ?

And where does the used supercharger kit appear from ?

Buy once,...
Forum: C5 Forced Induction/Nitrous
07-14-2023, 05:17 PM
Replies: 20
Views: 1,944
Posted By stevieturbo

Exactly what difficulty are you having with...

Exactly what difficulty are you having with choice ? There are options, if you call the people who can give you the options.

And most popular on here would either be ECS or A&A

Obviously simply...
Forum: C6 Forced Induction/Nitrous
07-06-2023, 04:01 PM
Replies: 1,537
Views: 222,474
Posted By stevieturbo

interestingly, looking at the sensor on the side...

interestingly, looking at the sensor on the side of that DRP setup....

Much like the typical cheap valve spring tester ( see link ), it looks like the base is a "DIY" hydraulic cylinder of sorts,...
Forum: C6 Forced Induction/Nitrous
07-06-2023, 03:57 PM
Replies: 1,537
Views: 222,474
Posted By stevieturbo

Out of interest....why a direct load measurement...

Out of interest....why a direct load measurement on the suspension, vs just suspension position via a linear potentiometer ? From measured length and known spring rates etc, load could be calculated...
Forum: C5 Forced Induction/Nitrous
05-27-2023, 11:48 AM
Replies: 5
Views: 761
Posted By stevieturbo

Buy a genuine GM filter then ? But really,...

Buy a genuine GM filter then ?

But really, 60 to 66psi, I wouldn't worry too much as long as it is stable throughout the rpm range.
Forum: C5 Forced Induction/Nitrous
04-05-2023, 04:40 PM
Replies: 3
Views: 549
Posted By stevieturbo

In reality ? Remove the turbo kit, buy some...

In reality ?

Remove the turbo kit, buy some exhaust manifolds and just run the engine as is, re-tuned of course. You do not need to go crazy with a complete new setup, engine, etc etc

So what...
Forum: C5 Forced Induction/Nitrous
03-05-2023, 10:09 AM
Replies: 2
Views: 426
Posted By stevieturbo

It would be a lot easier to dent the header tube,...

It would be a lot easier to dent the header tube, than the booster.

But a little in both should do no harm.
Forum: C5 Forced Induction/Nitrous
01-23-2023, 01:03 PM
Replies: 36
Views: 3,400
Posted By stevieturbo

FAST cracking, not fast cranking

FAST cracking, not fast cranking
Forum: C5 Forced Induction/Nitrous
01-22-2023, 02:26 PM
Replies: 36
Views: 3,400
Posted By stevieturbo

I doubt you'd make 900 to the wheels even with a...

I doubt you'd make 900 to the wheels even with a pair of good 67mm turbos at only 10-12psi boost. It will need more boost ( depending on motor size of course )

But in that case, you'll need all...
Forum: C5 Forced Induction/Nitrous
01-22-2023, 02:17 PM
Replies: 36
Views: 3,400
Posted By stevieturbo

Not needed no.....but as all his tests show, it...

Not needed no.....but as all his tests show, it does offer gains throughout the rpm range.

I would say if turbo, this can be helpful, more power/torque down low, will also mean quicker spool. If...
Forum: C5 Forced Induction/Nitrous
01-22-2023, 11:25 AM
Replies: 36
Views: 3,400
Posted By stevieturbo

Keep it simple and ignore long posts full of...

Keep it simple and ignore long posts full of bullshit

What intake do you currently have ? You're mentioning intakes there some that are cathedral, and some only in square port.

What rpm range...
Forum: C5 Forced Induction/Nitrous
10-01-2022, 08:33 AM
Replies: 13
Views: 1,897
Posted By stevieturbo

There is every reason if they've never used them...

There is every reason if they've never used them before. Would you prefer they just said yes and took a massive learning curve on your car ?
Forum: C5 Forced Induction/Nitrous
10-01-2022, 08:32 AM
Replies: 13
Views: 1,897
Posted By stevieturbo

It makes perfect sense if the tuner has never...

It makes perfect sense if the tuner has never used a particular ecu before, to not use it.

If they have used other ecu's with good success, it makes sense for them to wish to use that ecu. There...
Forum: C5 Forced Induction/Nitrous
09-22-2022, 03:32 PM
Replies: 32
Views: 10,614
Posted By stevieturbo

Depends on what centri, and how extreme a...

Depends on what centri, and how extreme a camshaft you intend.
Forum: C6 Forced Induction/Nitrous
01-02-2022, 05:17 AM
Replies: 68
Views: 3,334
Posted By stevieturbo

Some good reviews of various tyres, although he...

Some good reviews of various tyres, although he never does any drag orientated tyres. A lot of them are not strictly legal in the UK for road use anyway
...
Forum: C6 Forced Induction/Nitrous
01-02-2022, 05:10 AM
Replies: 68
Views: 3,334
Posted By stevieturbo

You really are retarded ? This is the...

You really are retarded ?

This is the boosted section, if you make no power, disappear.



For me they never did. The older 888's were better than the newer R888R, but of a lot of the trackday...
Showing results 1 to 25 of 494
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 12:45 PM.