Search: Posts Made By: Freight
Showing results 1 to 23 of 23
Search took 0.81 seconds.
04-07-2012, 11:06 PM
Replies: 15
Views: 12,351
Posted By Freight

Roger that. That's good to know. I will check...

Roger that. That's good to know. I will check it first thing when there is light outsidde.
04-07-2012, 10:44 PM
Replies: 15
Views: 12,351
Posted By Freight

Did that. Helt the key in start while I went...

Did that. Helt the key in start while I went from Park to first and back again.
04-07-2012, 09:36 PM
Replies: 15
Views: 12,351
Posted By Freight

Roger that! Thanks for the great advise!

Roger that! Thanks for the great advise!
04-07-2012, 09:29 PM
Replies: 15
Views: 12,351
Posted By Freight

The car is a 1982 Collectors Edition. I will get...

The car is a 1982 Collectors Edition. I will get under the car and see what I can find out.

From what I’m getting is there are two small wires on the solenoid (plus one big battery direct).
...
04-07-2012, 08:49 PM
Replies: 15
Views: 12,351
Posted By Freight

The car does not have any remote starter...

The car does not have any remote starter installed.

I need to find the starter relay and ignition switch. I believe the ignition switch is on top of the steering column under the dash.
...
04-07-2012, 08:22 PM
Replies: 15
Views: 12,351
Posted By Freight

Corvette will not turn over again.

This is a tricky one so I will start when the first time it did this (would not start). Roughly two months ago I was out in my corvette and stopped at a auto parts store to pick up some detail...
Forum: C3 General
03-09-2012, 12:05 PM
Replies: 12
Views: 551
Posted By Freight

BAHAHAHA... Oh MAN!!! Super funny!!! Good...

BAHAHAHA... Oh MAN!!! Super funny!!! Good catch! Great advise! I'm going to check all listed above. Its a 1982 Collectors Edition. I'm sure the last owner did nothing to it with upgrades...
Forum: C3 General
03-09-2012, 10:55 AM
Replies: 12
Views: 551
Posted By Freight

Ideals to help with my car ridding experience!

Good morning fellow Corvette Enthuses! Want to pick some veteran brains about the way my corvette rides. First off, it’s similar to ridding in a tank. My question is, do all later year corvettes...
03-09-2012, 08:50 AM
Replies: 11
Views: 624
Posted By Freight

Maxmachz Yes, I hit the two studs off the...

Maxmachz
Yes, I hit the two studs off the solenoid with the key in the on position. She starts fine now! I will get her hot an hope she does the same, not start so I can perform some operation...
03-08-2012, 08:07 PM
Replies: 11
Views: 624
Posted By Freight

do you thing its possible the starter sylnoid...

do you thing its possible the starter sylnoid could get hot and not function properly?
03-08-2012, 07:48 PM
Replies: 11
Views: 624
Posted By Freight

Just went out and she started right up.... Humm....

Just went out and she started right up.... Humm. When I got home yesterday I shut her off and went to start her up nothing. Now, I go and try and she's good to go... What could that be?
03-08-2012, 07:39 PM
Replies: 11
Views: 624
Posted By Freight

No, it did not start when I got home. I am about...

No, it did not start when I got home. I am about to go back out right now and see if she will start. So it could be the netural safety then!!!
03-08-2012, 07:31 PM
Replies: 11
Views: 624
Posted By Freight

Yes.

Yes.
03-08-2012, 07:30 PM
Replies: 11
Views: 1,221
Posted By Freight

You are good to go!!!!! Keep the Vette clean and...

You are good to go!!!!! Keep the Vette clean and she will be good to you!!!
03-08-2012, 07:25 PM
Replies: 11
Views: 624
Posted By Freight

My baby will not turn over

Alright Team,

Its that time again. So I drive to AutoZone yesterday, shut down the car to run and buy some parts , then came back out to start up and cruise off, only issue was there was no...
02-15-2012, 08:47 PM
Replies: 12
Views: 1,768
Posted By Freight

What do you feel a good cam is? I would like a...

What do you feel a good cam is? I would like a mild cam, something with a good lump but nothing that would give me a check engine light and nothing that would task me to change my fuel pump. ...
02-14-2012, 07:13 PM
Replies: 12
Views: 1,768
Posted By Freight

Correct, the vales is stuck open and its lower...

Correct, the vales is stuck open and its lower from all the others even with the rocker arm off. The spring is in-tack!
02-14-2012, 07:41 AM
Replies: 11
Views: 1,420
Posted By Freight

Great thought team! I feel it's best if I keep...

Great thought team! I feel it's best if I keep it stock! It's easy to think I can do this and that but the more important ideal for me is to keep it stock! Thanks for the great advise and I will...
02-14-2012, 07:38 AM
Replies: 12
Views: 1,768
Posted By Freight

When I pulled the right valve cover off I noticed...

When I pulled the right valve cover off I noticed number 5 was loose, that caught my attention and I noticed it was stuck open. I pulled the rocker and rod before I tapped on it to unfreeze but no...
02-13-2012, 07:33 AM
Replies: 11
Views: 1,420
Posted By Freight

Goodness, I did put TPI. I mean TBI, my bad! I...

Goodness, I did put TPI. I mean TBI, my bad! I feel the TBI is gutless and will always run rough. Thanks for the advise with clearance and each day I am leaning towards making the change.

I...
02-12-2012, 11:18 PM
Replies: 11
Views: 1,420
Posted By Freight

Thoughts about taking my 1982 C-Edition from TPI to Edelbrock

Good day Corvette enthusiast!

Wanted to hear some thoughts about taking my split TPI set up to a Edelbrock 1406. The carb set up I have at this time is the stock two carburetor with the crazy...
01-31-2012, 10:29 AM
Replies: 12
Views: 1,768
Posted By Freight

Billa, I pulled the valve covers and noticed...

Billa,
I pulled the valve covers and noticed number 5 at that time. I tapped a bit on the valve trying to free it up but no luck. I have not done a compression or leak down test, I felt there was...
01-30-2012, 05:44 PM
Replies: 12
Views: 1,768
Posted By Freight

Head CC for 1982

Good day Corvette Enthusiast!

I have read almost every form looking for what type heads my 1982 Collectors Edition has. I recently pored in Lucas fuel additive to clean the injectors and I have a...
Showing results 1 to 23 of 23


 
Forum Jump


All times are GMT -4. The time now is 08:52 PM.