CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 2
1
2
Search: Posts Made By: Elovette
Showing results 1 to 25 of 48
Search took 0.83 seconds.
Forum: C5 Parts for Sale/Wanted
10-14-2018, 01:44 PM
Replies: 23
Views: 2,595
Posted By Elovette

Flanges

hey, I just need the 3-bolt flanges. They are also cheaper to ship to HI. $50 for the two flanges (leave about 3” of pope on each one)?
Forum: C5 Parts for Sale/Wanted
10-14-2018, 04:11 AM
Replies: 50
Views: 5,167
Posted By Elovette

Mid-pipe flanges

Hi, looking for the 3-bolt mid-pipe flanges only for a custom exhaust.
Forum: C5 Parts for Sale/Wanted
10-14-2018, 04:08 AM
Replies: 7
Views: 1,537
Posted By Elovette

Corner lights?

still have the corner lights?
Forum: C5 Parts for Sale/Wanted
10-14-2018, 04:06 AM
Replies: 6
Views: 982
Posted By Elovette

Need the flanges only!

hey do you still have this? I actually need the 3-bolt mid-pipe flanges. LMK
Forum: C5 Parts for Sale/Wanted
10-31-2016, 03:57 AM
Replies: 9
Views: 2,451
Posted By Elovette

Hey, Possibly sizing down from 20" rear...

Hey,
Possibly sizing down from 20" rear 305's to 19". Same style as shown. Brand new tires.
Forum: C7 Z06 Discussion
05-25-2015, 02:31 PM
Replies: 33
Views: 3,021
Posted By Elovette

Me too!

Cool. Me too, living in Mexico. We live over by the Vets home. Yellow c5 zo6. Need to swap the engine out. Any clue where I cod do it myself around here? Our rental has no garage to speak of.
Forum: C5 Parts for Sale/Wanted
05-25-2015, 01:01 AM
Replies: 17
Views: 2,145
Posted By Elovette

Headers work on an LS6?

Looking at getting headers on my '03 zo6. Do you know if these will work on that LS6? Thx.
Forum: C5 Parts for Sale/Wanted
05-21-2015, 04:50 PM
Replies: 32
Views: 3,229
Posted By Elovette

Hey PM me!

Could you send me a PM? May be interested. Thx
Forum: C5 Parts for Sale/Wanted
03-16-2015, 09:09 PM
Replies: 10
Views: 519
Posted By Elovette

Lower end in MO

Did you see my post on here? I have a z06 Lower end. It's in MO and I can deliver within 100 miles. What r u looking to spend?
Forum: C5 Parts for Sale/Wanted
03-16-2015, 07:08 PM
Replies: 0
Views: 249
Posted By Elovette

F/S '03Z LS6 motor lower end

For sale or will part out. 03Z06 motor complete lower end; one piston and one cylinder wall slightly damaged. No other damage evident. Motor started tapping and was shut off immediately (at low RPM)....
Forum: C5 Parts for Sale/Wanted
03-15-2015, 07:58 AM
Replies: 34
Views: 2,767
Posted By Elovette

Call today

Gotcha. Give me a call-my top end is good, so if you wanted to keep yours, then we could prob work that out.
Forum: C5 Parts for Sale/Wanted
03-14-2015, 04:53 PM
Replies: 34
Views: 2,767
Posted By Elovette

In need of the engine

PM me with any other details about the engine. Just starting my search but we may be able to deal! Tks
Forum: C5 Parts for Sale/Wanted
03-14-2015, 09:33 AM
Replies: 1
Views: 228
Posted By Elovette

WTB LS6 or rebuild in MO / KS area

Well, my '03 Z06 motor broke again...need a replacement or rebuild in the St. Louis or KC area. Also looking for recommendations of who is good. Also, how do you find private sellers by their...
Forum: C5 Tech
08-28-2014, 07:32 PM
Replies: 3
Views: 1,203
Posted By Elovette

New stereo-LOUD popping noise!

I had an auto electronics installer put a stereo in. Now, it "POPS" in between stereo stations and when I switch sources. The installer says it is because it is a Bose system and each speaker has...
Forum: C6 Tech/Performance
04-30-2014, 07:21 PM
Replies: 41
Views: 7,000
Posted By Elovette

Do we have yellow?

Do we have yellow?
Forum: C5 General
02-26-2014, 12:10 PM
Replies: 3
Views: 403
Posted By Elovette

Thanks, getting there...

Gents, thanks, the suggestions are contributing to full knowledge. I hope. Scooter, did you mean those go INSIDE the head cavity with the rockers, etc.? And they to the far ends of the engine/car...
Forum: C5 General
02-26-2014, 12:08 AM
Replies: 3
Views: 403
Posted By Elovette

Help needed....cyl head bolts

Just need a weeeeee bit of assistance. I didn't notice where the short and long bolts went in the cylinder head when I removed it..... 2003 Z06. Tks!!!!!!
Forum: C5 Tech
02-23-2014, 02:49 AM
Replies: 43
Views: 25,101
Posted By Elovette

Well, I have a pair of used fog lights, and the...

Well, I have a pair of used fog lights, and the combo trunk/fog switch....,now I just need the brackets and wiring harness. Anyone have any laying around????
Forum: C5 General
02-23-2014, 02:38 AM
Replies: 20
Views: 6,030
Posted By Elovette

These might really pop if u added those cheap...

These might really pop if u added those cheap little LED lights to the inside of your wheel wells. Just sayin.
Forum: C6 Corvette General Discussion
02-23-2014, 01:59 AM
Replies: 385
Views: 90,618
Posted By Elovette

Yup, thinking about doing the big letters on the...

Yup, thinking about doing the big letters on the back of my c5...also I wonder how the glovebox letters would turn out?
Forum: C5 Parts for Sale/Wanted
02-13-2014, 05:21 AM
Replies: 155
Views: 12,274
Posted By Elovette

Hi, Price pls for radiator overflow tank,...

Hi,
Price pls for radiator overflow tank, dual fog light switch, and the little latch inside the center console shipped to 65459. Tks
Forum: C5 Parts for Sale/Wanted
02-04-2014, 07:19 AM
Replies: 30
Views: 17,658
Posted By Elovette

Front chin air dam/spoiler

Ummm,, where did you get that black front air splitter. Want one. Tks
Forum: C5 Parts for Sale/Wanted
02-02-2014, 09:00 PM
Replies: 22
Views: 1,416
Posted By Elovette

Pls call cell

Trying to reach you via PM. Not sure if it's working. Pls call the cell I sent you. I really need the cyl. Head. Tks.
Forum: C5 Parts for Sale/Wanted
02-02-2014, 07:09 PM
Replies: 22
Views: 1,416
Posted By Elovette

Make that, 99.99%. FLW, HOO-ah. And maybe the...

Make that, 99.99%. FLW, HOO-ah. And maybe the exhaust.
Forum: C5 Parts for Sale/Wanted
02-02-2014, 07:04 PM
Replies: 22
Views: 1,416
Posted By Elovette

PM me about the cyl head. I am 99%.

PM me about the cyl head. I am 99%.
Showing results 1 to 25 of 48
 
Page 1 of 2
1
2


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 08:33 PM.