CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 9
1
2
3
Last »
Search: Posts Made By: ProjectC4
Showing results 1 to 25 of 216
Search took 1.04 seconds.
Forum: C4 Tech/Performance
08-25-2023, 02:31 PM
Replies: 29
Views: 11,008
Posted By ProjectC4

Mine is a non-ZR1 - I plated my pins.

Mine is a non-ZR1 - I plated my pins.
Forum: C4 Tech/Performance
02-27-2016, 10:46 AM
Replies: 8
Views: 1,535
Posted By ProjectC4

Those PDF parts catalogs with illustrations are...

Those PDF parts catalogs with illustrations are invaluable when your into something deep, the exploded diagrams really help with re-assembly or when someone else used the wrong fasteners, etc.

I...
Forum: C4 Tech/Performance
07-08-2015, 06:56 PM
Replies: 109
Views: 78,972
Posted By ProjectC4

I think there's 2 rods - the rearmost rod in the...

I think there's 2 rods - the rearmost rod in the picture for the high beam switch and the foremost squarish piece going to a rod the ignition switch rod maybe? The ignition switch is down low on the...
Forum: C4 Tech/Performance
03-30-2015, 05:55 AM
Replies: 14
Views: 1,921
Posted By ProjectC4

Back when everything had a distributer cap and...

Back when everything had a distributer cap and wires, when a customer had no start or drivability problems on rainy days it was virtually always the cap and wires.
Forum: C4 Tech/Performance
03-21-2015, 07:56 AM
Replies: 1
Views: 1,310
Posted By ProjectC4

That plastic grommet at the top of the boot that...

That plastic grommet at the top of the boot that came on it is probably not down far enough on the shifter. Same thing happened to me. Rock it a bit and push it down hard. Once it snaps down you'll...
Forum: C4 Tech/Performance
07-20-2014, 06:41 AM
Replies: 17
Views: 1,541
Posted By ProjectC4

CB Radio? Some cars had them as options.

CB Radio? Some cars had them as options.
Forum: C4 Tech/Performance
03-23-2014, 02:28 PM
Replies: 1
Views: 8,668
Posted By ProjectC4

How to Set up 1984 C4 Crossfire TB's & TPS

It turns out that the Crossfire set up procedure that I have lived in fear of for so long is actually fairly easy!

I have had the car for 4 years. It probably should have been used for parts but...
Forum: C4 Tech/Performance
10-30-2013, 11:12 PM
Replies: 13
Views: 1,567
Posted By ProjectC4

I have a 4 + 4 in need of some work, too. Spoke...

I have a 4 + 4 in need of some work, too. Spoke to Brian at SK speed in Long Island, NY 2 weeks ago. He's still doing them. Quoted me I think 2,500 for both units, 1,400 or 1,500 for just the OD...
Forum: C4 Tech/Performance
09-12-2013, 02:08 PM
Replies: 42
Views: 9,298
Posted By ProjectC4

I was looking for an interior picture with a...

I was looking for an interior picture with a Keisler to see if the shifter fit the console OK. It looks like yours did, nice job! Is the Keisler supplied rubber boot under the console?
Forum: C4 Tech/Performance
07-28-2013, 03:08 AM
Replies: 10
Views: 759
Posted By ProjectC4

If you want to take the seat frame out there's a...

If you want to take the seat frame out there's a wire clip under the front of the seat that holds the cushion in the seat. Once you get the cushion off there's 4 bolts that hold the seat frame to the...
Forum: C4 Tech/Performance
07-22-2013, 10:40 PM
Replies: 7
Views: 731
Posted By ProjectC4

I totally took mine apart. Shimmed it up some...

I totally took mine apart. Shimmed it up some with valve spring shims to remove some very minor play. Replaced the rubber bushings where the shift rods connect with some new ones that were close that...
Forum: C4 General Discussion
07-17-2013, 11:35 PM
Replies: 11
Views: 601
Posted By ProjectC4

The `84-`85`s are around but no longer come with...

The `84-`85`s are around but no longer come with the rubber piece where it meets the column. For some reason they stopped making it that way in reproduction pieces. China? I bought 2 based on catalog...
Forum: C4 Tech/Performance
07-17-2013, 11:24 PM
Replies: 8
Views: 1,051
Posted By ProjectC4

Mine was rear wheel alignment. Actually the scary...

Mine was rear wheel alignment. Actually the scary thing was I had sort of made it go mostly away by learning to automatically correct in anticipation.
Forum: C4 Tech/Performance
06-21-2013, 03:08 PM
Replies: 0
Views: 497
Posted By ProjectC4

Slow Cranking Hot Fixed w/ New Cables

1984 w/ 4+3 manual - Had the car almost 4 years, starter was bad so I put in a rebuilt when I first got the car. Cranked good cold but cranked slow when hot from day 1. Had the battery tested, it was...
Forum: C4 Tech/Performance
06-02-2013, 10:29 AM
Replies: 10
Views: 1,088
Posted By ProjectC4

I used a headlight polishing kit. Don't remember...

I used a headlight polishing kit. Don't remember who made it but it came in a yellow box. There were 2 pads with 3 stages of grit, a spray on liquid to use with the pads and a polishing cream for...
Forum: C4 Tech/Performance
06-02-2013, 08:45 AM
Replies: 5
Views: 676
Posted By ProjectC4

I found the cover with bolts and the rubber...

I found the cover with bolts and the rubber clutch fork boot on eBay. Had to really haunt eBay to find the boot. Had to open up the starter bolt holes just a little to get the cover to fit, just...
Forum: C4 Tech/Performance
05-04-2013, 10:05 AM
Replies: 8
Views: 590
Posted By ProjectC4

I had my carpet completely out of the front for a...

I had my carpet completely out of the front for a while and it was miserably hot. Put in the foil backed insulation and the "Mass Backed" carpet and it made a world of difference. My AC doesn't work...
Forum: C4 Tech/Performance
04-30-2013, 12:28 PM
Replies: 1
Views: 450
Posted By ProjectC4

1984 Speedo Faceplate Knock Offs?

So I bought a new speedo face plate from 2 different sources, Full Throttle Corvette and Ecklers. Both showed a picture of a "GM Restoration Parts" face plate which included the rubber piece that...
Forum: C4 Tech/Performance
04-26-2013, 05:45 AM
Replies: 7
Views: 388
Posted By ProjectC4

The parts book is worth having, too. Lots of...

The parts book is worth having, too. Lots of exploded diagrams - I use mine a lot. They are on eBay for under 50 bucks.
Forum: C4 Tech/Performance
04-20-2013, 09:37 AM
Replies: 11
Views: 1,267
Posted By ProjectC4

There's a GM weatherstrip training video for C4....

There's a GM weatherstrip training video for C4. I got mine on ebay for $20 or so. Well worth getting, its on VHS.
About halfway down this page I showed all the supplies needed....
Forum: C4 Tech/Performance
03-09-2013, 04:55 AM
Replies: 20
Views: 1,652
Posted By ProjectC4

On the weatherstripping if you do use glue you...

On the weatherstripping if you do use glue you should use the 3m black weatherstrip adhesive. It takes longer to set up than the yellow so you have time to slide the weatherstrip in the track for...
Forum: C4 Tech/Performance
03-08-2013, 05:47 AM
Replies: 24
Views: 3,059
Posted By ProjectC4

I used that rubber or silicone newer style Felpro...

I used that rubber or silicone newer style Felpro with just a little RTV in the corners like it said. It leaks in the front corner. I should have used more. My '84 came down with just removing the...
Forum: C4 Tech/Performance
03-07-2013, 10:09 PM
Replies: 4
Views: 1,528
Posted By ProjectC4

I bought a kit from Plastex on the internet. It...

I bought a kit from Plastex on the internet. It works with all plastics for fixing cracks, replacing tabs, etc. It comes with fiberglass cloth which can be used for reinforcement too. I have used it...
Forum: C4 Tech/Performance
03-06-2013, 01:33 PM
Replies: 66
Views: 14,143
Posted By ProjectC4

I think that the replacement of the 2nd & 4th...

I think that the replacement of the 2nd & 4th gear switches would help give the ECM the inputs it needs to make it decide to energize the OD but I don't know if not having the 2nd and 4th switches...
Forum: C4 General Discussion
03-03-2013, 12:13 AM
Replies: 7
Views: 515
Posted By ProjectC4

http://forums.corvetteforum.com/c4-general-discuss...

http://forums.corvetteforum.com/c4-general-discussion/1741731-power-pass-seat-fix.html#post1582065823
Showing results 1 to 25 of 216
 
Page 1 of 9
1
2
3
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 02:01 AM.