Search: Posts Made By: jereo96
Showing results 1 to 25 of 29
Search took 1.19 seconds.
08-02-2008, 04:40 PM
Replies: 3
Views: 402
Posted By jereo96

You May Be Right----the First Time I Attempted To...

You May Be Right----the First Time I Attempted To Start It (in A Dark Garage) I Had The Key Upside Down When I Tried To Put It In The Ignition. Naturally It Didnt Go In, But I'm Wondering If That...
08-02-2008, 10:37 AM
Replies: 3
Views: 402
Posted By jereo96

Starting Problems ????

1996 LT1 COUPE AUTOMATIC
Hi All,
This morning I hopped in the Vette to go for a spin. Turned the key and ---nothing---. Tried the lights and they were bright. Still wouldn't start. Battery is 4...
Forum: C5 General
07-12-2008, 09:15 AM
Replies: 3
Views: 357
Posted By jereo96

Light Removal

Hi Everyone,
Can anyone tell me how to remove the drivers side parking light/turn signal housing? Thought I would ask and get proper instructions before removing parts that I shouldnt have.
...
05-02-2008, 08:49 AM
Replies: 6
Views: 415
Posted By jereo96

that is the whole unit---I am looking for the...

that is the whole unit---I am looking for the sender only
05-01-2008, 09:29 PM
Replies: 6
Views: 415
Posted By jereo96

Fuel Gauge Sender Unit

The car is a 96 LT1 coupe. Does anyone know where I can buy a new fuel gauge sender. It is the small plastic unit that has very small windings in it and naturally mounts in the gas tank. This item...
02-14-2008, 05:04 PM
Replies: 1
Views: 361
Posted By jereo96

Gas Tank Gasket

hI,
It's a 96 LT1 coupe. The new gasket for the gas tank arrived today. It has the same GM part # as the one in the thread showing fuel gauge repair. But the one in the repair photo has 9 holes in...
02-04-2008, 08:46 PM
Replies: 9
Views: 1,240
Posted By jereo96

headlight motor

THIS IS WHAT YOU DO !!
Loosen screws holding motor to gearbox
Loosen nut on threaded rod that has a slot for a flat screwdriver.
Then turn threaded rod about two turns--this will relieve pressure...
01-01-2008, 09:22 PM
Replies: 3
Views: 492
Posted By jereo96

Repair Info

hi,
i HAVE A 96 COUPE WITH THE BOSE AM/FM CASSETTE CD PLAYER. THE CD PLAYER SHOWS "ERR" WHEN A DISC IS INSERTED. HAS ANYONE HAD THE CD UNIT REPAIRED OR REBUILT. ALSO WHAT WAS COST AND WHO DID THE...
12-25-2007, 06:18 PM
Replies: 2
Views: 1,205
Posted By jereo96

Radio Replacement

Hi all,
I have a 96 coupe with the bose am/fm cassette/cd radio. Naturally the cd player stopped working. (dont they all)?. Has anyone replaced this radio with another unit that has a dvd in it...
12-04-2007, 07:38 PM
Replies: 6
Views: 607
Posted By jereo96

Coolant temp sensor

quick question. where is the Coolant temp sensor located?? thanks in advance
11-20-2007, 07:35 PM
Replies: 146
Views: 5,494
Posted By jereo96

Buncha Kids--i Was 68 Last May. Old Body, Young...

Buncha Kids--i Was 68 Last May. Old Body, Young Head. Wave
10-13-2007, 11:35 AM
Replies: 9
Views: 647
Posted By jereo96

repaired yesterday

One of mine was bad also. Repaired it yesterday. Bushings were gone. Looked like grated cheese. Mid America has them for about $6 bucks. Watch the motor when you work the headlight switch. The knob...
10-13-2007, 11:18 AM
Replies: 1
Views: 324
Posted By jereo96

Thanks

Hey everyone,
thanks to all who helped me with info for replacing my bad headlight bushings. It took me 3 hours, but I dont think that was too bad for a 68 yr old fart. Working as good as new, now...
09-30-2007, 06:19 PM
Replies: 9
Views: 526
Posted By jereo96

Should I remove the whole assembly, or do it with...

Should I remove the whole assembly, or do it with the motor on the car?
09-30-2007, 09:17 AM
Replies: 9
Views: 526
Posted By jereo96

thanks for the info---I just ordered the bushings...

thanks for the info---I just ordered the bushings and a gear (just in case). Is this a very difficult job.? thanks again
09-29-2007, 09:27 PM
Replies: 9
Views: 526
Posted By jereo96

Headlight Motors Problem

Hi,
I'm having a problem that I can't solve. I use a battery disconnect switch to prevent battery rundown when the vette sits for more than a couple of weeks. When I turn on the battery, both of the...
08-28-2007, 09:49 AM
Replies: 1
Views: 314
Posted By jereo96

timing adjustment

Hi,
this question does'nt apply to my 96 collector edition, but I thought I would ask anyway. Timing is set correctly and car idles properly, but is low on performance. I advance timing to the point...
08-18-2005, 10:30 PM
Replies: 22
Views: 1,147
Posted By jereo96

opti

Guess I'm Another Lucky One. Replaced My Water Pump 3 Weeks Ago After The Old One Soaked My Opti. Still Running Smooth. Keep My Fingers Crossed.
...
08-01-2005, 10:29 PM
Replies: 4
Views: 380
Posted By jereo96

Coolant Info

Hi All,
I just installed a new waterpump in my 96 CE. I was just wondering if anyone uses a coolant additive (lubricant) or anything that will give a longer life.
...
07-21-2005, 01:52 PM
Replies: 10
Views: 351
Posted By jereo96

Oops

sorry---It's for a 1996 LT1
07-21-2005, 01:44 PM
Replies: 10
Views: 351
Posted By jereo96

Water Pump-where To Buy???

Water pump committed suicide and has to be replaced. Where should I buy one, and what is a REASONABLE price to pay
Thanks all
...
07-20-2005, 07:44 PM
Replies: 5
Views: 348
Posted By jereo96

Coolant Leak--need Advice

HELP !!
I have a 1996 with a LT1 motor.
While driving home I nearly wrecked it as I attempted to turn a corner--NO POWER STEERING !! I managed to get home (5minutes) and opened the hood. Coolant...
06-23-2005, 05:13 PM
Replies: 22
Views: 1,191
Posted By jereo96

96 vette

I'm looking for a model of the 1996 coupe in silver. Do you have one??
05-05-2005, 07:58 PM
Replies: 4
Views: 452
Posted By jereo96

acetone

Acetone works very well. I removed the adhesive with it after peeling off the tint.
04-14-2005, 08:09 PM
Replies: 13
Views: 697
Posted By jereo96

steering wheel shake

The reason your steering wheel shakes is this----your front wheels are out of balance. As one or both wheels (tires) goes up and down, the steering wheel will go back and forth. The steering wheel...
Showing results 1 to 25 of 29
 


 
Forum Jump


All times are GMT -4. The time now is 12:03 AM.