CorvetteForum - Chevrolet Corvette Forum Discussion

Search: Posts Made By: vettenuts

Showing results 1 to 25 of 489
Search took 0.83 seconds.

Forum: C5 Tech

11-10-2023, 08:53 AM

Replies: 56

Low compression in Cylinder 4, 2002 LS6

Views: 1,935

Posted By vettenuts

Are you going to document your installation into...

Are you going to document your installation into the C3? It would be interesting to follow along.

Forum: C5 Tech

11-10-2023, 08:12 AM

Replies: 21

Cracked block or headgasket?

Views: 756

Posted By vettenuts

Was the coolant line to the throttle body still...

Was the coolant line to the throttle body still connected? If so, I would also make sure there isn't leakage through the throttle body with some compressed air. That would answer why all cylinders...

Forum: C5 Tech

11-01-2023, 11:55 AM

Replies: 21

Cracked block or headgasket?

Views: 756

Posted By vettenuts

Need more information, is the engine stock or...

Need more information, is the engine stock or modified?

Forum: C5 Tech

11-01-2023, 11:08 AM

Replies: 14

Dreaded 02 codes with Longtubes

Views: 397

Posted By vettenuts

I would trace the wiring. Those codes are...

I would trace the wiring. Those codes are showing no O2 activity so any data from the sensors aren't reaching the ECM. Also check for any vacuum or exhaust leaks. I would also put the original...

Forum: C5 Tech

10-31-2023, 10:04 AM

Replies: 7

Top dead center

Views: 478

Posted By vettenuts

Yes, should be a TDC. It's for rocker tightening...

Yes, should be a TDC. It's for rocker tightening sequence later when you are re-assembling the valve train. I would set it and mark your damper with a dab of paint.

Forum: C5 Tech

06-01-2022, 10:37 AM

Replies: 23

Need assistance in selecting clutch

Views: 1,192

Posted By vettenuts

While it's apart, I would pull the drive shaft...

While it's apart, I would pull the drive shaft out and change the rubber guibo's. The car is basically 20 years old so they may be aging out if they haven't been changed previously.

Forum: C5 Tech

08-11-2021, 09:00 PM

Replies: 11

Harmonic balancer replacement and engine balance questions

Views: 3,146

Posted By vettenuts

The manual states to mark and transfer the...

The manual states to mark and transfer the weights (if any) to the new OEM harmonic balancer. Personally, I would at least mark it if going with another brand/type. Then at least you have the...

Forum: C5 Tech

12-12-2020, 09:40 AM

Replies: 6

Rear end noise

Views: 617

Posted By vettenuts

Could either be the half shaft CV joint or the...

Could either be the half shaft CV joint or the shaft spline is dry where it goes through the rear wheel bearing. Use a stethoscope to pinpoint the location. The shaft spline in the rear bearings...

Forum: C5 Tech

12-12-2020, 09:38 AM

Replies: 10

Shredded belt (Tensioner tapping noise and Balancer seating)

Views: 1,257

Posted By vettenuts

Your balance sounds like it is toast. Don't...

Your balance sounds like it is toast. Don't drive because if it moves too far forward it will damage the steering rack.

Search Results