FAST Intake+100mm MAF=10hp
04-22-2011, 05:18 PM
#1
Race Director
Thread Starter
Member Since: Dec 2006
Location: Fort Worth, Texas
Posts: 11,122
Received 2,054 Likes
on
1,306 Posts
FAST Intake+100mm MAF=10hp
Well after getting a similar result as the last go around with the FAST even with the addition of the 100mm MAF, I definitely believe the small cam is hindering the gains. Still feel it will be worth a .1/mph at the track though. Next up EWP and SNL V4 cam!
04-22-2011, 06:29 PM
#2
Le Mans Master
04-23-2011, 10:23 AM
#5
Race Director
Thread Starter
Member Since: Dec 2006
Location: Fort Worth, Texas
Posts: 11,122
Received 2,054 Likes
on
1,306 Posts
I agree, from 5k-7k(where it counts at the track) it's a solid 10/10 and that's without any assistance from the Vararam
04-25-2011, 01:11 PM
#7
Race Director
Thread Starter
Member Since: Dec 2006
Location: Fort Worth, Texas
Posts: 11,122
Received 2,054 Likes
on
1,306 Posts
06-01-2011, 11:33 AM
#8
Drifting
Member Since: Jan 2010
Location: Katy TX
Posts: 1,447
Likes: 0
Received 0 Likes
on
0 Posts
FAST 90/92 or 102?
06-01-2011, 06:52 PM
#10
Race Director
What does the Kpa look like now? I had to get rid of the stockish air bridge and go to a 4" tube setup. I was loosing 8-9 Kpa at WFO. Now I pull about 1 or 2.
06-10-2011, 06:30 PM
#11
Race Director
Thread Starter
Member Since: Dec 2006
Location: Fort Worth, Texas
Posts: 11,122
Received 2,054 Likes
on
1,306 Posts
06-10-2011, 06:32 PM
#12
Race Director
Thread Starter
Member Since: Dec 2006
Location: Fort Worth, Texas
Posts: 11,122
Received 2,054 Likes
on
1,306 Posts
06-10-2011, 09:35 PM
#13
fast and TB
I did the Fast and ported both by Vengeance Racing did not really care about the HP number But Really noticed the faster rpm gain throughout mid to high range rpm going down the 1/4 mile Well i think it was worth it for my track racing 
