A&A v3 Ti advice
#1
Heel & Toe
Thread Starter
A&A v3 Ti advice
I’m planning on putting a v3 Ti on my 2000 Frc with headers and ls6 intake. I want to run 7-8 lbs because everything else is stock but would the standard 3.8 pulley do 8 psi of boost? Or would I need 3.6? Also those with a Similar set up as mine, what are you running?
#2
Platinum Supporting Vendor
Since you mentioned Ti-trim, I'd start with the 3.8" pulley.
The following users liked this post:
XanBarclay07 (05-16-2024)
#3
Drifting
you can use a smaller pulley and adjust the boost with a restrictor after the filter. easy to change out.
(i have been running 20 psi with "everything else stock" for nearly 10 years now, except the fuel pump.)
(i have been running 20 psi with "everything else stock" for nearly 10 years now, except the fuel pump.)