FS - (Houston) C6 Z06 Shocks and Leaf Springs
#1
Racer
Thread Starter
Member Since: Apr 2011
Location: Houston TX
Posts: 259
Likes: 0
Received 0 Likes
on
0 Posts
FS - (Houston) C6 Z06 Shocks and Leaf Springs
C6 Corvette Z06 OEM Suspension parts:
- Shocks (x4) - $175
- Leaf Springs with lowering bolts (front and rear) - $200
The parts were taken off my 2007 Z06 with 38000 miles on them. Bundle price $350.
Note: These prices are for pick-up only. I'm willing to ship at the buyer's expense.
- Shocks (x4) - $175
- Leaf Springs with lowering bolts (front and rear) - $200
The parts were taken off my 2007 Z06 with 38000 miles on them. Bundle price $350.
Note: These prices are for pick-up only. I'm willing to ship at the buyer's expense.
#6
Racer
Thread Starter
Member Since: Apr 2011
Location: Houston TX
Posts: 259
Likes: 0
Received 0 Likes
on
0 Posts
FS - (Houston) C6 Z06 Shocks and Leaf Springs
Curt at C&C's Northside Motors (also known as C&C's Tracktime Performance) just north of 290 on 1960. He is very experienced in suspension setups for track and offroad. He did the full spectrum - corner balance, alignment, ride height, rake. Unfortunately, he just retired and the shop is closed!
#7
Curt at C&C's Northside Motors (also known as C&C's Tracktime Performance) just north of 290 on 1960. He is very experienced in suspension setups for track and offroad. He did the full spectrum - corner balance, alignment, ride height, rake. Unfortunately, he just retired and the shop is closed!
So now I need someone who knows WTF their doing in regards to car setup. Ugh.
#8
Melting Slicks
http://www.lucasracinginc.com/
#9
What about Greg over at Lucas Racing? I know they do a lot of SCCA, NASA, etc... prep as well as roll cage and chassis work.
http://www.lucasracinginc.com/
http://www.lucasracinginc.com/
Last edited by Nick996; 09-03-2015 at 11:43 AM.
#11
Racer
Thread Starter
Member Since: Apr 2011
Location: Houston TX
Posts: 259
Likes: 0
Received 0 Likes
on
0 Posts
FS - (Houston) C6 Z06 Shocks and Leaf Springs
I go to Victor Sellens at VZ Autoworks for most things. Can definitely install suspension components, but not experienced in suspension tuning per se. Jim at the shop @ MSR Houston would probably be a decent try for road course setup. Assuming you are installing coilovers and heavier rate sways for HPDE or TT and not just street, it might be worth a trip to LG for them to do the initial setup. Texas Track Works, LG, and the shop at MSR Cresson would all be good options in the DFW area.