Dyno day
#69
Advanced
#70
Racer
Thread Starter
Lol as long it's the rwd one its fine.. email Joe from wcc your info and I'll add you to the list
#71
Advanced
#74
Supporting Vendor
Hello guys,
We have reached the required 10 cars, thus, the discount will apply to $50 as long as everyone shows up.
If you didnt make the list, please still PM with name, number and I will make start a list for alternates.
Please review the requirments I list on the earlier pages and I hope you see you all there
- JOE@WCC
LIST OF MEMBERS THAT PM ME
Nathan R.- 02'
Joel L. - 06'
Kevin - 08'
Todd - 64'
George - GXP Pontiac
John - G/S
Mark - 00' camaro
Cesar - AMG
Steve M -
Andrain G - 07' Blazer
Wittleguy - 04'
We have reached the required 10 cars, thus, the discount will apply to $50 as long as everyone shows up.
If you didnt make the list, please still PM with name, number and I will make start a list for alternates.
Please review the requirments I list on the earlier pages and I hope you see you all there
- JOE@WCC
LIST OF MEMBERS THAT PM ME
Nathan R.- 02'
Joel L. - 06'
Kevin - 08'
Todd - 64'
George - GXP Pontiac
John - G/S
Mark - 00' camaro
Cesar - AMG
Steve M -
Andrain G - 07' Blazer
Wittleguy - 04'
Last edited by WCC JOE; 09-08-2012 at 01:13 PM.
#75
Racer
Member Since: Feb 2011
Location: Phillips Ranch California
Posts: 468
Received 0 Likes
on
0 Posts
Maybe we could all pre pay via paypal, credit card deposit etc to avoid any possibility of additional charges if someone doesnt make it?
#76
Supporting Vendor
This statement is a little troubling... I'm have a hard time with the though that a may have to pay double if someone doesnt show up for one reason or another.
Maybe we could all pre pay via paypal, credit card deposit etc to avoid any possibility of additional charges if someone doesnt make it?
Maybe we could all pre pay via paypal, credit card deposit etc to avoid any possibility of additional charges if someone doesnt make it?
This is why is require 10 cars and currently we are at 13. So I feel pretty confident that will be ok. We are willing to bend a little because we're all car people too.
However, we can't charge for labor we haven't performed yet.
JOE@WCC
#78
Racer
Thread Starter
#79
Le Mans Master
'64 Vette
>300 Hp
Note the ambient temperatures.
Since this run, I changed to underdrive pullies on a Gilmer belt system (reported to add 10 hp @ 5,500 RPM on the Car Craft dyno), did some porting at the intake, and did some tuning on the carb and ignition, but will probably not see the results at the expected temperature.
Approximately 80 degrees:
90+ degrees: (But I recognize that no two dynos read the same and these two runs have different "smoothing.")
At least I'll see if I corrected the dip in the A/F ratio.
Last edited by toddalin; 09-10-2012 at 05:01 PM.