Cannot get into gear
#1
Drifting
Thread Starter
Member Since: Mar 2003
Location: Canberra AUSTRALIA
Posts: 1,608
Likes: 0
Received 2 Likes
on
2 Posts
St. Jude Donor '05-'06
Cannot get into gear
Heres the baseline:
Rebuilt motor
New CentreForce Clutch & all linkages/TO bearing etc
Rebuilt Muncie M20
New Hurst Comp Shifter with repro vette handle
Before we put the engine/clutch/gearbox in the car it shifted into gear real nice. Now in the car we cannot consistently get it into reverse or out if it is in.
Is this a clutch or a linkage problem?
I added extra washers to the hurst linkages like HOTROD magazine talked about. Could this cause bind?
Any help appreciated. (out of town till friday so thanks in advance)
Pete
Rebuilt motor
New CentreForce Clutch & all linkages/TO bearing etc
Rebuilt Muncie M20
New Hurst Comp Shifter with repro vette handle
Before we put the engine/clutch/gearbox in the car it shifted into gear real nice. Now in the car we cannot consistently get it into reverse or out if it is in.
Is this a clutch or a linkage problem?
I added extra washers to the hurst linkages like HOTROD magazine talked about. Could this cause bind?
Any help appreciated. (out of town till friday so thanks in advance)
Pete
#2
Melting Slicks
Member Since: Feb 2004
Location: largo florida
Posts: 2,435
Likes: 0
Received 0 Likes
on
0 Posts
Re: Cannot get into gear (stingry)
This was asked yesterday http://forums.corvetteforum.com/zerothread?id=780536