Somebody chime in
10-14-2003, 07:40 PM
#1
Instructor
Thread Starter
Member Since: May 2001
Location: Yorktown Va Usa
Posts: 229
Likes: 0
Received 0 Likes
on
0 Posts
Somebody chime in
After 29 days staight at work i finally will be offthi weekend.My mental capacity is a bit fuzzy so staight forward the bolt that is in line with fuel pump to hold pushrod up on small block is that 3/8 x 2 .Thanks it has been a while.
10-14-2003, 10:48 PM
#2
Safety Car
Re: Somebody chime in (hiyosilver)
Try doing a search under fuel pump replacement. No one seems to be chompin at the bit right now, and have never tackled this job yet.
10-14-2003, 10:52 PM
#3
Le Mans Master
Member Since: Aug 2000
Location: Semper ubi, sub ubi
Posts: 9,662
Likes: 0
Received 6 Likes
on
6 Posts
Cruise-In VI Veteran
Cruise-In VII Veteran
Re: Somebody chime in (hiyosilver)
I didn't use a bolt, I just put a big glob of grease on the rod and that held it in place.
10-14-2003, 11:35 PM
#4
Drifting
Re: Somebody chime in (Smokehouse69)
DING DONG!!!
Sorry, I just had to beat Desertdawg to it. :jester
Just found this thread
http://forums.corvetteforum.com/zerothread?id=650620
[Modified by 72GACRZR, 11:41 PM 10/14/2003]
[Modified by 72GACRZR, 11:41 PM 10/14/2003]
Sorry, I just had to beat Desertdawg to it. :jester
Just found this thread
http://forums.corvetteforum.com/zerothread?id=650620
[Modified by 72GACRZR, 11:41 PM 10/14/2003]
[Modified by 72GACRZR, 11:41 PM 10/14/2003]
10-16-2003, 03:52 AM
#6
Race Director
Member Since: Jun 2001
Location: The Only Corvette in Gila Bend, Az.
Posts: 16,483
Likes: 0
Received 1 Like
on
1 Post
St. Jude Donor '09
Re: Somebody chime in (72GACRZR)
DING DONG!!!
Sorry, I just had to beat Desertdawg to it. :jester
Sorry, I just had to beat Desertdawg to it. :jester
[Modified by Desertdawg, 1:53 AM 10/16/2003]