Hydraulic Clutch Conversion....
#1
Burning Brakes
Thread Starter
Hydraulic Clutch Conversion....
Hey guys, I am about to finish up my Richmond six speed swap. I have been running a hydraulic clutch all this time with the Muncie.
I put the $4 rebuild in the Quartermaster hydraulic release bearing, but I guess I cut one of the seals, because it was leaking when I went to bleed it. I removed it, and confirmed my guess.
Anyway, I reinstalled the old mechanical linkage. We are up against a time table wall to have the Vette road worthy by Oct 11 (Octobervette in Kissimmee), and it is still sitting on the jackstands!
I am going to sell the complete hydraulic.
I have about $400 tied up in it for the lines, Quartermaster part, master cylinder, and custom rod with ball swivel to the clutch pedal.
Anybody interested in it at $200? You will need to get a $4 oring kit from Quartermaster, take your time installing it...and you are off and running!
Let me know.
Chris
chrisnikki@juno.com
I put the $4 rebuild in the Quartermaster hydraulic release bearing, but I guess I cut one of the seals, because it was leaking when I went to bleed it. I removed it, and confirmed my guess.
Anyway, I reinstalled the old mechanical linkage. We are up against a time table wall to have the Vette road worthy by Oct 11 (Octobervette in Kissimmee), and it is still sitting on the jackstands!
I am going to sell the complete hydraulic.
I have about $400 tied up in it for the lines, Quartermaster part, master cylinder, and custom rod with ball swivel to the clutch pedal.
Anybody interested in it at $200? You will need to get a $4 oring kit from Quartermaster, take your time installing it...and you are off and running!
Let me know.
Chris
chrisnikki@juno.com