MotorHead

Finishing up the cam install ( CC282 solid ) and I thought I'd snap a pic. I think it's a shame you have to cover the rockers up. They are Harland Sharp 1.5 ratio. Also won't be able to see more than the top of the Cloyes timing cover :cry

Anyway the picture shows the Victor Jr. intake that is going on and with a few more horsepower adding goodies I am taking it to a chassis dyno in a couple of weeks then I will put the RPM Air Gap intake back on for our very own Corvette Forum intake comparison, should be interesting to see which intake is better on the same engine. :D

*Click on the pic for larger version






[Modified by MotorHead, 2:58 PM 7/25/2003]

1Bad69

wayne..looks great :thumbs:

L-82kid

Motorhead,

That motor looks very good and i sure it will run really strong. How are you going to fit the victor Jr. under your hood? How does it compare in height to the RPM air-gap? I see that you have Sportsman II heads, how do you like them? I am thinking of running Sportsman II heads with a Magnum 270H or XE268 cam, comp 1.52 Roller Tip rockers, and a RPM intake.

Thanks
Kevin

cardo0

:eek: Wow! Looks like a serious performance effort. Nice work. :D

gdh

I like the sitckers, can you put more on your purdy engine sir, pls. Mr. MotorHead just a few more to make it go faster. :lol: Looking great Wayne now take a close up video of them now and post your mess err um beauty clip for us all to see. :rofl:

MotorHead

Greg the Dynomax sticker is there for a purpose, behind it is a hole in the fibreglass I put there when I was torquing down the heads, I don't have anything by Dynomax on the car.

Did Mike manage to get that red out of his his hair in your pool ? :lol:

Victor Jr. is the same height as the RPM Air Gap.... I hope and I had that under my hood already, the Sportman II heads are great they will support a lot more HP that I have now and they will go on the 400 stroker I a, going to build.




[Modified by MotorHead, 11:36 PM 7/24/2003]

BB wowbagger

I belive that Comp had some clear Polycarbonate valve covers.. :yesnod:

vette_c5c6

Tooo Baddd no one makes Clear rocker covers. To nice looking to cover-up

79corvetteTPI

http://www.cleargearz.com/NewProducts.htm :D

Kenzy

:cool:

dath

Awesome, clear valve covers... Hmmm, I have nice shiny chrome ones now, but clear... Guess you outta keep the oil changes up if you go that route:D

68shark

Have to admit....I'm impressed!! Your "old" combo posted somewhere around 280rwhp which I thought was awesome for an SBC. Obviously....not good enough!! Think you can cross the 300 mark now (non NOS)??

PyjamaSam

That looks wicked. Can't wait to see it. Good job.

chris.

MotorHead

Anything over 300 RWHP I'm a happy camper ! :D