Anyone have the OAl of an '82 Halfshaft?
#1
Drifting
Thread Starter
Member Since: Feb 2002
Location: Manchester, Dead Center in the Middle of TN 25 miles to Jack Daniels,10 miles to Geo Dickle, and .8 mile from the Liquor Store at I-24 Exit 114
Posts: 1,987
Likes: 0
Received 2 Likes
on
2 Posts
St. Jude Donor '05
Anyone have the OAl of an '82 Halfshaft?
I need the OAL of a '80 -'81 manual trans halfshaft or an Auto trans '82.
I have a halfshaft out in the shop, but can't remember if it is the '82 shaft I need to use for reference. I need this dimension to make the halfshafts for my conversion from auto to manual in my '80. I am going to resize a set of '86 Aluminum Halfshafts to go in the '80. Yes, I am using the big yokes and flanges from an '82 to match them. Thanks JIM :smash:
I have a halfshaft out in the shop, but can't remember if it is the '82 shaft I need to use for reference. I need this dimension to make the halfshafts for my conversion from auto to manual in my '80. I am going to resize a set of '86 Aluminum Halfshafts to go in the '80. Yes, I am using the big yokes and flanges from an '82 to match them. Thanks JIM :smash:
#3
Drifting
Thread Starter
Member Since: Feb 2002
Location: Manchester, Dead Center in the Middle of TN 25 miles to Jack Daniels,10 miles to Geo Dickle, and .8 mile from the Liquor Store at I-24 Exit 114
Posts: 1,987
Likes: 0
Received 2 Likes
on
2 Posts
St. Jude Donor '05
Re: Anyone have the OAl of an '82 Halfshaft? (Monty)
Thank You Monty! I knew someone would have access to this information.
I had tons of info I had accumalated in the last year lost when a Back Door Trojon Worm Killed my Computer last week while I was in Vegas. I fully recomend a Firewall for your computer. I have one now that it is too late!
THANKS! Jim
I had tons of info I had accumalated in the last year lost when a Back Door Trojon Worm Killed my Computer last week while I was in Vegas. I fully recomend a Firewall for your computer. I have one now that it is too late!
THANKS! Jim