ALUM Radiator for '80
#1
Drifting
Thread Starter
Member Since: Feb 2002
Location: Manchester, Dead Center in the Middle of TN 25 miles to Jack Daniels,10 miles to Geo Dickle, and .8 mile from the Liquor Store at I-24 Exit 114
Posts: 1,987
Likes: 0
Received 2 Likes
on
2 Posts
St. Jude Donor '05
ALUM Radiator for '80
Who makes,or has the best for the buck HD Alum. Radiator that actually fits like OEM and retains all of the original mounts and shrouds? Where & how much? JIM
#2
Melting Slicks
Member Since: Jul 1999
Location: Godspeed Mikey Hogsmak Invitational Spring Skyline Drive Corvette Cruise
Posts: 3,472
Likes: 0
Received 0 Likes
on
0 Posts
Cruise-In I Veteran
Cruise-In II Veteran
Re: ALUM Radiator for '80 (PROSOUTH)
My guess would be Dewitts but Griffin and BeCool make some good replacements.
#3
Burning Brakes
Member Since: Aug 2000
Location: Katy TX
Posts: 852
Likes: 0
Received 0 Likes
on
0 Posts
Re: ALUM Radiator for '80 (69shark)
My Griffin fit directly with trans cooler. Only had to get the HD radiator cushions (top and bottom) from dr rebuild. Mine was ~$500. You can get a generic w/o the trans cooler for a lot less but I am not dissapointed with my purchase. Car runs right on the thermostat year round even in 95°F heat. Don't remember the part no but Griffin makes one for our cars.
#4
Safety Car
Member Since: Jan 2001
Location: No longer a member
Posts: 3,990
Likes: 0
Received 0 Likes
on
0 Posts
Re: ALUM Radiator for '80 (PatG)
Give Tom DeWitt a call, I'm sold on a Griffin with dual spal fans as soon as I can get the spare cash. Look over on the right side of the forum page under "Restoration" or go here; http://www.dewitts.com/
#6
Drifting
Member Since: Sep 1999
Location: Wylie TX
Posts: 1,411
Likes: 0
Received 0 Likes
on
0 Posts
Re: ALUM Radiator for '80 (PROSOUTH)
I'm not sure if this is the info you are looking for, but I put in the 31" x19" 1 1/4" tube Griffin universal and dual 12" electrical fans. This allowed me to eliminate the shroud and clutch fan (does the '80 have electric fans?). It would cost about $460 for the rad/fan setup new (I bought the fans used). I was able to retain the stock support and mounts.
This was on my '69.
[Modified by Chris A, 12:12 AM 2/19/2002]
This was on my '69.
[Modified by Chris A, 12:12 AM 2/19/2002]