She's "done" - time for dyno!
01-21-2002, 12:36 AM
#1
Instructor
Thread Starter
Member Since: Jan 2001
Posts: 155
Likes: 0
Received 0 Likes
on
0 Posts
She's "done" - time for dyno!
Well, after some dirty :mad looks from a neighbor, I'm done. I worked a bit on dialing in the carb today. Running pretty darn good :D. Here's the engine:
All the top end stuff (per sig image below) is done. Going to a dyno on Thursday for a dyno tune :)- then I'll feel a fit better about whether the timing is right as it is still rather advanced (but the cam might be at non-zero setting too). Of course, you need to see this photo :D :D :D :
Thank to all those that provided tid-bits of advice along the way!
Jim :mad
[Modified by jimbr, 10:39 PM 1/20/2002]
All the top end stuff (per sig image below) is done. Going to a dyno on Thursday for a dyno tune :)- then I'll feel a fit better about whether the timing is right as it is still rather advanced (but the cam might be at non-zero setting too). Of course, you need to see this photo :D :D :D :
Thank to all those that provided tid-bits of advice along the way!
Jim :mad
[Modified by jimbr, 10:39 PM 1/20/2002]
01-21-2002, 09:23 AM
#4
Race Director
Member Since: Nov 2000
Location: Waterloo ontario Canada
Posts: 11,872
Likes: 0
Received 9 Likes
on
9 Posts
Re: She's "done" - time for dyno! (jimbr)
Looks really nice and clean. If it's a brand new rebuild don't you want to put some easy miles on it before it is subjected to a hard dyno pull?
Good luck
Good luck
01-21-2002, 10:45 AM
#5
Instructor
Member Since: Dec 2001
Location: Center Ossipee N.H.
Posts: 115
Likes: 0
Received 0 Likes
on
0 Posts
Re: She's "done" - time for dyno! (norvalwilhelm)
Yea , i was going to say put some break in miles on before dyno runs. Also change oil before dyno runs. Any ways it looks awsome, great combonation. :cheers: :seeya
01-21-2002, 08:56 PM
#7
Instructor
Thread Starter
Member Since: Jan 2001
Posts: 155
Likes: 0
Received 0 Likes
on
0 Posts
Re: She's "done" - time for dyno! (Jason Staley)
Please don't rain....Please don't rain....Please don't rain....Please don't rain....Please don't rain....Please don't rain....Please don't rain....Please don't rain....Please don't rain....Please don't rain....Please don't rain....Please don't rain....Please don't rain....
Thanks folks.
If the weather gods allow, the dyno is still on. Since I did not touch the bottom end (cylinder walls are good as new!), I should nto need to put lots of miles on before the test...and my neighbors can tell you it is pulling hard already :)
Never been on a dyno before - bringing in the camera....
Jim
Thanks folks.
If the weather gods allow, the dyno is still on. Since I did not touch the bottom end (cylinder walls are good as new!), I should nto need to put lots of miles on before the test...and my neighbors can tell you it is pulling hard already :)
Never been on a dyno before - bringing in the camera....
Jim
01-21-2002, 09:01 PM
#8
Team Owner
Re: She's "done" - time for dyno! (jimbr)
DIRTY LOOKS FROM A NEIGHBOR?? :mad :mad What the heck for?
If they are lucky enuf to be serenaded by your sweet engine tones they should be rushing over to feast their eyes on your accomplishments!!
As i am awakened at 7 on a Sunday morning by people putting their maniac dog out in their front yard, or the snow clearing crew that showed up with snowblowers at 12:30 a.m. the other night, or the daily assault of leaf blowers that goes on the entire fall.....etc ETC!!!!! :mad The sound of open headers would be a RELIEF!!!!!
MJ
If they are lucky enuf to be serenaded by your sweet engine tones they should be rushing over to feast their eyes on your accomplishments!!
As i am awakened at 7 on a Sunday morning by people putting their maniac dog out in their front yard, or the snow clearing crew that showed up with snowblowers at 12:30 a.m. the other night, or the daily assault of leaf blowers that goes on the entire fall.....etc ETC!!!!! :mad The sound of open headers would be a RELIEF!!!!!
MJ
