There are no stupid questions...
07-11-2008, 10:41 PM
#1
Instructor
Thread Starter
Member Since: May 2004
Location: Fort Drum New York
Posts: 187
Likes: 0
Received 0 Likes
on
0 Posts
There are no stupid questions...
But lots of inquisitive idiots..
So heres mine. I can account for all the connectors on makeing this LT1 Wiring harness stand alone....except this one. Any idea what this is or what it connects too? Im stumped.
The engine is a 1994 if that makes a difference.
Thanks again,
Bob
So heres mine. I can account for all the connectors on makeing this LT1 Wiring harness stand alone....except this one. Any idea what this is or what it connects too? Im stumped.
The engine is a 1994 if that makes a difference.
Thanks again,
Bob
Last edited by Iskenderian; 07-11-2008 at 10:48 PM.
07-11-2008, 11:37 PM
#2
Supporting Vendor
But lots of inquisitive idiots..
So heres mine. I can account for all the connectors on makeing this LT1 Wiring harness stand alone....except this one. Any idea what this is or what it connects too? Im stumped.
The engine is a 1994 if that makes a difference.
Thanks again,
Bob
So heres mine. I can account for all the connectors on makeing this LT1 Wiring harness stand alone....except this one. Any idea what this is or what it connects too? Im stumped.
The engine is a 1994 if that makes a difference.
Thanks again,
Bob
http://www.lt1swap.com/wiringharness.htm
07-12-2008, 01:05 AM
#3
Safety Car
Member Since: Oct 2007
Location: :45 minutes from everywhere / E-I-E-I-O
Posts: 3,816
Likes: 0
Received 0 Likes
on
0 Posts
I put my cash on interior, or chassis rear electrical harness; not engine, but maybe tranny.
FSM shows connector 'faces' - about 60 roughly, and the only 6-ways that are linear are for the 'radio receiver box' (not a weatherproof connector), a transmission position switch connector (not a w/p connector), and temperature door motor ((2 x 6,) not w/p).
It looks like an ignition switch harness connector...
FSM shows connector 'faces' - about 60 roughly, and the only 6-ways that are linear are for the 'radio receiver box' (not a weatherproof connector), a transmission position switch connector (not a w/p connector), and temperature door motor ((2 x 6,) not w/p).
It looks like an ignition switch harness connector...