Fiberglass repair manual
#1
Safety Car
Thread Starter
Member Since: Oct 2000
Location: Lake Wylie, South Carolina
Posts: 4,253
Received 161 Likes
on
49 Posts
Fiberglass repair manual
Has anyone purchased the Eckler's fiberglass repair manual? Is it worth the money? Now that I have all the suspension done on my vette and it is sitting on the ground I am going to start preparing the body. I don't have any real bad areas just pin holes and small cracks through out. I bought all of my supplies Monday. Any last words of advice or warning before I start sanding,grinding,bonding,filling, etc? :smash:
#2
Team Owner
Member Since: Jun 2000
Location: Southbound
Posts: 38,928
Likes: 0
Received 1,469 Likes
on
1,248 Posts
Cruise-In II Veteran
Re: Fiberglass repair manual (wadew10)
Sand, yes. Grind? I wouldn't. I have Eckler's book and waited a long, long time for it. Eckler had trouble getting it to the printer so it was not available for a long time after they first listed it in their catalogue. It's helpful. I also have the Glas-Ra series for Sharks. Pricey, but also helpful.
:)
[Modified by Easy Mike, 8:26 AM 11/14/2001]
:)
[Modified by Easy Mike, 8:26 AM 11/14/2001]
#5
Safety Car
Member Since: Nov 1999
Location: Paducah KY
Posts: 4,466
Likes: 0
Received 0 Likes
on
0 Posts
Cruise-In I Veteran
Cruise-In II Veteran
Cruise-In III Veteran
Cruise-In IV Veteran
St. Jude Donor '03
Re: Fiberglass repair manual (wadew10)
I highly recommend the Ecklers book. :yesnod:
Dave
Dave