Mirror Leds
#1
Team Owner
Thread Starter
Mirror Leds
I think we can light all Leds and have them bright. There appears to be 1 positive and 2 current limited negs furnished to the PCB. I divided up to load to have 3 each Leds lit off each circuit. I've had this installed for a while without any problems. It does require opening the etched circuit in 2 places and 3 jumpers. Excuse the cold solder joints as I was in a hurry.
Hope these pics load as I changed ISP recently.
Hope these pics load as I changed ISP recently.
Last edited by ben dover; 03-08-2005 at 05:39 PM. Reason: pic load
#4
Team Owner
Thread Starter
fixed
#5
Safety Car
Member Since: Dec 2002
Location: SE Idaho
Posts: 4,010
Likes: 0
Received 0 Likes
on
0 Posts
St. Jude Contributor
One way. I have designed a new board doing basically the same thing; three LEDs per circuit. Just waiting to run up to the electronics store and purchase the bare boards, then etch the new diagram into place. Then I'll just transfer the small connector over to the new board.
Your way is faster, mine will be more fun....
Your way is faster, mine will be more fun....
Last edited by WhiteC5Vette; 03-08-2005 at 05:56 PM.
#7
Team Owner
Thread Starter
In these pics I am using 4 white and 2 blue 5mm leds