Search: Posts Made By: GlennS87
Showing results 1 to 25 of 497
Search took 1.03 seconds.
03-20-2013, 10:02 PM
Replies: 123
Views: 13,761
Posted By GlennS87

Surprised nobody has posted this. ...

Surprised nobody has posted this.
http://www.corvettereport.com/wp-content/uploads/2010/01/Falconer12cylinder.jpg
09-08-2012, 02:08 PM
Replies: 25
Views: 11,862
Posted By GlennS87

I have used a 58mm BBK for the last 10 years with...

I have used a 58mm BBK for the last 10 years with no problems/
08-15-2012, 07:29 AM
Replies: 31
Views: 15,587
Posted By GlennS87

I use Vredestein Ultrac Sessanta. I really like...

I use Vredestein Ultrac Sessanta. I really like them. I have used Dunlop SP8000 and Yokohama AVS in the pas and so far I have the Vred's at the top.
08-10-2012, 02:32 PM
Replies: 17
Views: 1,131
Posted By GlennS87

I had KYB's for a number of years and I felt that...

I had KYB's for a number of years and I felt that they rode harshly. In addition they scared the heck out of me when I went over some wavy pavement at the point the road butted up to a certain...
11-29-2010, 10:30 PM
Replies: 3
Views: 1,469
Posted By GlennS87

Yes, I had a custom chip burned when the motor...

Yes, I had a custom chip burned when the motor was built back in 2001. It's been fine since then. ECM has been changed 3 times since then (not recently) but I have used the same modded chip.
11-29-2010, 09:48 PM
Replies: 3
Views: 1,469
Posted By GlennS87

Flashing check engine light

When I turn the ignition key on I get a steady flashing of the check engine light and the motor will crank but not start. After a few times of turning the key off and then back on again it stops...
04-25-2010, 05:12 PM
Replies: 3
Views: 944
Posted By GlennS87

Frankly, your BLM numbers are not that bad. These...

Frankly, your BLM numbers are not that bad. These cars never just sit at 128. Atmospheric onditions and fuel quality alone can explain what you're seeing.
04-25-2010, 09:19 AM
Replies: 4
Views: 816
Posted By GlennS87

Bosch # 13077 3 wire heated o2

Bosch # 13077 3 wire heated o2
04-23-2010, 10:18 AM
Replies: 35
Views: 2,001
Posted By GlennS87

The fact that he said it would perform "best"...

The fact that he said it would perform "best" shows he's a little clueless. The main difference in plugs isn't performance but longevity based on what it's made of. OEM's went platinum so they could...
04-22-2010, 08:37 PM
Replies: 6
Views: 4,791
Posted By GlennS87

I believe the Callaway's also used a completely...

I believe the Callaway's also used a completely different block. One with four bolt mains.
04-22-2010, 08:35 PM
Replies: 35
Views: 2,001
Posted By GlennS87

Nothing personal about the Advance auto guy but I...

Nothing personal about the Advance auto guy but I would hesitate to take anyone's advice that works behind the counter of one of these parts stores. Try to buy a part that didn't come originally on...
04-22-2010, 06:06 PM
Replies: 81
Views: 4,421
Posted By GlennS87

While I have no issue with someone who wants to...

While I have no issue with someone who wants to use more octane than is stated in the manual, the reality is in a l98 all you need is 87 octane. It doesn't matter how many cylinders or what type of...
04-21-2010, 06:14 PM
Replies: 72
Views: 14,480
Posted By GlennS87

Bring a GPS, I wouldn't trust the speedo.

Bring a GPS, I wouldn't trust the speedo.
04-21-2010, 06:04 PM
Replies: 2
Views: 903
Posted By GlennS87

I use Bosch 13077 (three wire). I just bought one...

I use Bosch 13077 (three wire). I just bought one at Advance a couple weeks ago to replace my 8 yr old one.
04-15-2010, 09:48 PM
Replies: 16
Views: 602
Posted By GlennS87

If it isn't GM, don't bother. I spent $1800 on...

If it isn't GM, don't bother. I spent $1800 on top warranty from a top aftermarket company (bought a 2001 Aurora in 2003) and they went insolvent 5 days later. Lesson learned, I won't do that again....
04-10-2010, 08:29 AM
Replies: 28
Views: 12,249
Posted By GlennS87

I use the EASE program (serial cable, got it...

I use the EASE program (serial cable, got it years ago) and I have no problem scanning the 1985 ECM. Did it for another member a few years back. If memory serves me right, there are fewer things that...
04-02-2010, 09:16 PM
Replies: 28
Views: 12,433
Posted By GlennS87

The vettaid dash is being used in that magazine...

The vettaid dash is being used in that magazine project C4force. I see prices on the website and you can't get any below like $700. As long as my digital dash can be fixed, I'm sticking with it.
03-25-2010, 02:07 PM
Replies: 10
Views: 512
Posted By GlennS87

This is quoted from my "How to Tune and Modify...

This is quoted from my "How to Tune and Modify Chevrolet Fuel Injection" by Ben Watson.

For a code 34 fault


" Clear the codes and run the engine until the check engine light comes back on or...
03-25-2010, 08:42 AM
Replies: 10
Views: 512
Posted By GlennS87

Try changing the MAF relays. They are relatively...

Try changing the MAF relays. They are relatively inexpensive.
03-24-2010, 08:51 PM
Replies: 5
Views: 603
Posted By GlennS87

I know what you mean about the KYB's. That's what...

I know what you mean about the KYB's. That's what I have and I don't like them. I will eventually just go with HD Bilsteins.
03-24-2010, 11:05 AM
Replies: 195
Views: 11,389
Posted By GlennS87

I hate the fact that my car seems to have an...

I hate the fact that my car seems to have an appetite for eating ECM's. I have had to replace mine every other year for like 6 years.
03-23-2010, 10:45 AM
Replies: 6
Views: 5,628
Posted By GlennS87

I use the Comp Pro Magnum 1.6 rr's

I use the Comp Pro Magnum 1.6 rr's
03-22-2010, 07:58 PM
Replies: 117
Views: 6,174
Posted By GlennS87

Thanks Dogfish. I live in Middletown so I don't...

Thanks Dogfish. I live in Middletown so I don't get up by that area all that much.
03-22-2010, 07:55 PM
Replies: 39
Views: 1,358
Posted By GlennS87

What do you rest your arm on?

What do you rest your arm on?
03-22-2010, 05:31 PM
Replies: 117
Views: 6,174
Posted By GlennS87

Hey Dogfish, Where is that Cobra located in...

Hey Dogfish,

Where is that Cobra located in the picture?
Showing results 1 to 25 of 497
 


 
Forum Jump


All times are GMT -4. The time now is 03:27 AM.