CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: MrForce
Showing results 1 to 25 of 492
Search took 1.45 seconds.
Forum: C6 Parts for Sale/Wanted
06-20-2016, 10:12 AM
Replies: 5
Views: 1,065
Posted By MrForce

Just as advertised and shipped very quickly. ...

Just as advertised and shipped very quickly.

Thanks!
Forum: C3 Tech/Performance
06-10-2016, 07:43 PM
Replies: 17
Views: 1,916
Posted By MrForce

3000 in neutral, there is no to very little load...

3000 in neutral, there is no to very little load on the motor, so it doesn't take a lot of throttle opening to achieve that RPM, so you have engine vacuum, and advance. At the same RPM, in gear,...
Forum: C3 Tech/Performance
04-13-2016, 04:20 PM
Replies: 13
Views: 969
Posted By MrForce

Vapor lock? What are your underhood temps like?...

Vapor lock? What are your underhood temps like? Think about adding a heat shield or phenolic spacer between the carb and intake.

as MelWff asks, what does it take to get it restarted?

Rob
Forum: C3 Tech/Performance
03-14-2016, 09:50 PM
Replies: 35
Views: 7,060
Posted By MrForce

You might want to swap to a 4 speed auto at the...

You might want to swap to a 4 speed auto at the same time. Helps keep the smaller engines in their best torque range. I'll bet most of the engines you look at will have the matching OD trans...
Forum: C3 Tech/Performance
11-23-2015, 12:36 PM
Replies: 48
Views: 22,066
Posted By MrForce

It uses the O2 sensor to tune for performance at...

It uses the O2 sensor to tune for performance at big throttle/ high RPM and leans it out of lower RPM, high vacuum (cruising mode)
Forum: C3 Tech/Performance
10-08-2015, 09:04 AM
Replies: 14
Views: 1,395
Posted By MrForce

Have you considered going to an 18" wheel? Tire...

Have you considered going to an 18" wheel? Tire selection is much better at this point and handling is greatly improved.
Forum: C3 Tech/Performance
09-22-2015, 05:22 PM
Replies: 21
Views: 2,270
Posted By MrForce

The TPI intake will probably cost you HP and...

The TPI intake will probably cost you HP and limit your RPM range. Back in the day, almost every part of the system was replaced or upgraded in an effort to increase airflow. If you know what you are...
Forum: C3 Tech/Performance
09-22-2015, 05:14 PM
Replies: 55
Views: 8,867
Posted By MrForce

OEM fans in OEM shrouds will usually outperform...

OEM fans in OEM shrouds will usually outperform anything else. Chinese aftermarket junk is, well, Chinese aftermarket junk.
Forum: C3 Tech/Performance
08-15-2015, 11:34 AM
Replies: 40
Views: 2,345
Posted By MrForce

duct tape. What else can be used for interior...

duct tape. What else can be used for interior repair, bodywork, and oil leaks...
Forum: C3 Parts for Sale/Wanted
07-23-2015, 12:38 PM
Replies: 14
Views: 531
Posted By MrForce

Order placed, thanks. Rob

Order placed, thanks.

Rob
Forum: C3 Parts for Sale/Wanted
06-02-2015, 07:30 PM
Replies: 4
Views: 495
Posted By MrForce

Shipped quickly and received in good order. Easy...

Shipped quickly and received in good order. Easy seller to do business with.

Thanks,

Rob
Forum: C3 Parts for Sale/Wanted
05-28-2015, 09:19 AM
Replies: 20
Views: 1,993
Posted By MrForce

windows

PM sent on windows.

Thanks,

Rob
Forum: C3s for Sale/Wanted
02-27-2015, 12:13 PM
Replies: 0
Views: 914
Posted By MrForce

1969 IMSA Greenwood Project - Body Only

No frame, drivetrain, interior, etc. i bought this 4 years ago and haven't touched it since. Stored indoors on a steel dolly that goes with the car. New glass rear bumper cover with LED taillights....
Forum: C3 General
01-26-2015, 04:09 PM
Replies: 61
Views: 25,989
Posted By MrForce

https://cimg2.ibsrv.net/gimg/www.corvetteforum.com...

https://cimg2.ibsrv.net/gimg/www.corvetteforum.com-vbulletin/1920x1440/80-imsabody_8458e3d0d97932b5a8a9a776165f338851c63657.jpg

A work in progress, with no progress
Forum: C3 Parts for Sale/Wanted
01-16-2015, 05:12 PM
Replies: 72
Views: 7,173
Posted By MrForce

Parts received

Bump for good seller! All parts as described and well packed.

Rob
Forum: C3 Tech/Performance
01-09-2015, 03:56 PM
Replies: 5
Views: 1,049
Posted By MrForce

Replica wheels are famous (or infamous) for...

Replica wheels are famous (or infamous) for quality and safety issues. The ones you show have a 6.6" backspacing which means you will need adapters. OEM wheels or American made aftermarket will...
Forum: C3 Tech/Performance
01-06-2015, 02:21 PM
Replies: 15
Views: 1,143
Posted By MrForce

I did away with all my other mods once I got a...

I did away with all my other mods once I got a magnet to align all the molecules in my gasoline...
Forum: C3 Parts for Sale/Wanted
12-30-2014, 07:08 PM
Replies: 4
Views: 1,200
Posted By MrForce

First name is Rob...

First name is Rob...
Forum: C3 Parts for Sale/Wanted
12-29-2014, 04:11 PM
Replies: 4
Views: 1,200
Posted By MrForce

This guy might... ...

This guy might...

https://www.corvetteforum.com/forums/c3-tech-performance/3576516-10-month-build-pictures-24hr-daytona-2.html
Forum: C3 Tech/Performance
12-14-2014, 01:36 PM
Replies: 34
Views: 5,877
Posted By MrForce

Great pics and story. Thanks

Great pics and story. Thanks
Forum: C3 Tech/Performance
12-05-2014, 08:05 AM
Replies: 7
Views: 1,483
Posted By MrForce

What ECU are you planning to use? Have you...

What ECU are you planning to use? Have you considered using a dual sync in the stock distributor location?

http://www.summitracing.com/parts/maa-77100d
Forum: C3 Tech/Performance
12-02-2014, 08:55 AM
Replies: 16
Views: 5,561
Posted By MrForce

brackets

The aftermarket kits like the one referenced seem to use a dedicated rotor with a high offset hat. Expensive to buy/replace. A bracket only kit that uses the OEM C6 Z06 rotors would allow those of us...
Forum: C3 Tech/Performance
12-01-2014, 03:10 PM
Replies: 16
Views: 5,561
Posted By MrForce

I would be in for a set. ...

I would be in for a set.

https://www.corvetteforum.com/forums/c3-tech-performance/2934269-c6-z06-brakes-on-my-c3.html
Forum: C3 Tech/Performance
11-24-2014, 05:18 PM
Replies: 35
Views: 3,573
Posted By MrForce

Holley install

https://cimg6.ibsrv.net/gimg/www.corvetteforum.com-vbulletin/2000x1504/80-dsc07770_0b6e3b5a175cdf000b7c8bf9c378b79a5e86cd08.jpg
We installed a Holley HP TBI system on a customers 72 with a ZZ3 crate...
Forum: C3 Parts for Sale/Wanted
11-24-2014, 01:57 PM
Replies: 2
Views: 436
Posted By MrForce

I will take them. PM inbound. Thanks, ...

I will take them. PM inbound.

Thanks,

Rob
Showing results 1 to 25 of 492
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 10:43 AM.