Search: Posts Made By: aaronz28
Showing results 1 to 25 of 498
Search took 1.48 seconds.
11-09-2023, 05:58 PM
Replies: 35
Views: 2,804
Posted By aaronz28

I just did is - giant pain in the ass - but...

I just did is - giant pain in the ass - but doable.... I had the car up on a lift, so that made it somewhat easier other than hoisting that sucker up into the tunnel and supporting it will bolting...
10-28-2023, 12:15 PM
Replies: 10
Views: 680
Posted By aaronz28

original low mileage hi-value car - a gearbox...

original low mileage hi-value car - a gearbox swap is non-invasive - cutting a perfectly good original frame - I want no part of :D
10-28-2023, 12:14 PM
Replies: 10
Views: 680
Posted By aaronz28

The real query I have - how do you bolt the...

The real query I have - how do you bolt the clutch on, with that tight clearance?
I'm pretty confident if I remove both exhaust headpieces, I'll have room to get the bell housing attached to the...
10-24-2023, 05:14 PM
Replies: 10
Views: 680
Posted By aaronz28

Tko swap with engine in the car

Ok, who done it?
im trying! About to pull the motor but id really like to just get it up and in from underneath. Im not cutting the crossmember

i have the car on a lift - you might thing thats...
08-31-2023, 01:18 PM
Replies: 10
Views: 437
Posted By aaronz28

Using a stock delco rotor

Using a stock delco rotor
08-31-2023, 10:24 AM
Replies: 10
Views: 437
Posted By aaronz28

Yes the S/E kif i have 3 orher them in other...

Yes the S/E kif

i have 3 orher them in other cars - issue free! So im a huge fan for sure

but I did put new AC delco wires on the car last night - and same story - breaks up above 4000-4500. ...
08-31-2023, 09:54 AM
Replies: 10
Views: 437
Posted By aaronz28

Lectric Limited 1 Wire Points Kit

Has anyone had this unit fail or be intermittent?

i have three of them on one car and I can NOT eliminate a high rpm (4k and up) misfire

anyone exp this?
07-16-2023, 02:20 PM
Replies: 5
Views: 535
Posted By aaronz28

yes they do, and I edited the op, that was all...

yes they do, and I edited the op, that was all covered in grease

so I don't need a set - but I DO need the rubber isolators - those are rotted out.
07-16-2023, 01:16 PM
Replies: 5
Views: 535
Posted By aaronz28

shock rubber isolators???

I own an original low mile 64 Fuelie Coupe
that needs new rear shock rubber


the original rear shocks are in good shape, but the rubber is shot -

anyone know where I can get new upper and...
06-16-2023, 12:37 PM
Replies: 10
Views: 339
Posted By aaronz28

only info i have seen are copies of the service...

only info i have seen are copies of the service notes that John Hinckley shared about different resistors and the 087 coil but that wasn't dated until Jan of 64. So my Nov63 car would obviously...
Forum: C1 & C2 Parts
06-16-2023, 12:29 PM
Replies: 0
Views: 184
Posted By aaronz28

Dk Blue 1964 Seat(s) - drivers vinyl seat bottom - or leather pair

I need a survivor drivers seat bottom in dk blue for 64. A 63 would be ok too i think but im not 100% sure if the 3 and 4 bottoms are the same or not - i know the back is different….


or, id...
06-16-2023, 11:25 AM
Replies: 10
Views: 339
Posted By aaronz28

yea i assume that this one went in for...

yea i assume that this one went in for service/maintenance and was swapped sometime in the 60s and here it sits
06-16-2023, 10:50 AM
Replies: 5
Views: 521
Posted By aaronz28

Coil differences 202, 087,091 etc

While hunting for a correct original 091 coil -
it occurs to me that any of a number of other GM points coils would work

but what really was the difference between the various available part #s....
06-16-2023, 10:45 AM
Replies: 10
Views: 339
Posted By aaronz28

thats what I see as well - must've been an early...

thats what I see as well - must've been an early exchange or something

Thanks
06-16-2023, 09:53 AM
Replies: 10
Views: 339
Posted By aaronz28

correct. November 63 built car

correct. November 63 built car
06-16-2023, 09:25 AM
Replies: 10
Views: 339
Posted By aaronz28

64 L84 - #202 coil?

My 64 L84 has what appears to be its original
#202 coil - but the notes suggest #091 coil

my car is early, so i suspect this was an early service center replacement but is the 091 the correct...
06-13-2023, 08:03 AM
Replies: 12
Views: 726
Posted By aaronz28

yes. I do that very thing in my 66 radio delete...

yes. I do that very thing in my 66 radio delete car…. But there is something kinda familiar about reaching up and turning that dial lol

im replacing the stock radio’s guts with higher powered...
06-11-2023, 06:49 PM
Replies: 12
Views: 726
Posted By aaronz28

Room for a small sub under the seat C2??

Has anyone tried to fit or modify a pancacke sub under one if the seats?

i assume there just isnt enough room - and i wouldnt want to mess up the storage bays behind the seat
06-10-2023, 06:53 PM
Replies: 2
Views: 344
Posted By aaronz28

Steering column in/out play

My 64 - the steering column has about 1/2”-3/4” play - not side to side but in and out. As if you pull on the wheel - it feels like its gonna come toward you…. Is this just a weak rag joint? Or...
06-08-2023, 01:31 PM
Replies: 3
Views: 303
Posted By aaronz28

How is there an EGR in the exhaust system? i...

How is there an EGR in the exhaust system?
i just removed the cat back system and replaced it from there - there was no O2 or sensor in the cat or further back
06-08-2023, 11:19 AM
Replies: 3
Views: 303
Posted By aaronz28

Code 32 and code 36

Quick que gang 86, 4+3
aftermarket exh no cats

- For a few weeks - id get a CEL on if i were highway driving for 20-30 miles or so - i assumed Oxy Sensor but no code

yesterday, the cel came...
Forum: C1 & C2 Parts
06-06-2023, 10:31 AM
Replies: 0
Views: 128
Posted By aaronz28

Wtb - 64 dk blue survivor drivers seat bottom…

My original 64’s dk blue interior needs a drivers seat bottom in vinyl

id be open to a set of leather seats for it to drive, but id really like to fond an original dk blue vinyl seat for it!
...
05-15-2023, 01:29 PM
Replies: 0
Views: 202
Posted By aaronz28

86 Clutch Master - DRIVING ME CRAZY

So my 86 is now on its 3rd master - and I'm gonna loose my mind.
the guy who replaced the clutch before me could not get a pedal at all with the big 1" spacer as shown on all the diagrams...

he...
02-19-2023, 09:31 PM
Replies: 1
Views: 276
Posted By aaronz28

TPI engine Valve Stem Seals

Technically, this is for a Camaro, but I’m working on an 85 TPI engine.

we are swapping valve stem seals -

the OE intake and exhaust look different

the OE exhaust was just a maroon,...
11-14-2022, 08:46 PM
Replies: 0
Views: 109
Posted By aaronz28

84-88 clutch master and slave options

originals are not available

what repops have you guys had good/back luck with?

have a mcleod clutch in the car
Showing results 1 to 25 of 498
 


 
Forum Jump


All times are GMT -4. The time now is 10:02 PM.