CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 10
1
2
3
Last »
Search: Posts Made By: onebighitter
Showing results 1 to 25 of 246
Search took 1.33 seconds.
Forum: C6 Parts for Sale/Wanted
07-25-2016, 09:07 PM
Replies: 11
Views: 1,628
Posted By onebighitter

PM sent

PM sent
Forum: C5 Tech
03-23-2015, 08:44 PM
Replies: 4
Views: 582
Posted By onebighitter

oil cooler

I have the one from lingenfelter and am very pleased
Forum: C5 Tech
03-03-2015, 03:12 PM
Replies: 0
Views: 685
Posted By onebighitter

O2 Sensor plug

I am installing my motor back into my car and cannot figure out which plug goes into my sensors. The black and brown or green and blue plug?

It is knock sensor not o2 sensor and the other plug...
Forum: C5 Tech
02-08-2015, 09:50 PM
Replies: 4
Views: 16,388
Posted By onebighitter

Found it, was looking on the side of rail, looked...

Found it, was looking on the side of rail, looked on top and there it was.

Awesome help,
Dean
Forum: C5 Tech
02-08-2015, 06:18 PM
Replies: 4
Views: 16,388
Posted By onebighitter

Ground strap location?

Here is a picture of ground strap drivers side attached to the engine block. I cannot figure out where and how it attaches to car frame. Can someone post a picture?

Thanks Dean
Forum: C5 Parts for Sale/Wanted
11-07-2014, 08:43 PM
Replies: 1
Views: 327
Posted By onebighitter

ttt

ttt
Forum: C5 General
11-05-2014, 06:03 PM
Replies: 25
Views: 2,631
Posted By onebighitter

Nice ride, I would go with stroker

Nice ride, I would go with stroker
Forum: C5 Parts for Sale/Wanted
11-03-2014, 10:39 PM
Replies: 1
Views: 327
Posted By onebighitter

Motorsports Tech 7.4 pushrods

I have a set of 7.4 long, .080 thick set of pushrods. Came from used motor and was told there was about 10k miles.
$50 shipped
Forum: C5 General
07-06-2014, 10:21 PM
Replies: 8
Views: 1,029
Posted By onebighitter

I installed the Z06 shocks without cutting...

I installed the Z06 shocks without cutting anything. I did not notice a difference between the two shocks.
Forum: C5 General
04-27-2014, 09:17 PM
Replies: 41
Views: 3,132
Posted By onebighitter

That pictured you showed was the way it has to be...

That pictured you showed was the way it has to be set up. The Holley one you asked about is the one I am using. When I installed mine I put it all together and no leaks. I have driven it a few...
Forum: C5 General
04-23-2014, 09:42 PM
Replies: 41
Views: 3,132
Posted By onebighitter

I have the black Holley and an fittings, look...

I have the black Holley and an fittings, look real nice.
Forum: C5 General
04-12-2014, 09:10 PM
Replies: 29
Views: 3,022
Posted By onebighitter

Mine drives better than new. 6 liter motor with...

Mine drives better than new. 6 liter motor with several suspension upgrades and I have 133k miles.
Forum: C5 Tech
04-05-2014, 07:08 PM
Replies: 22
Views: 2,064
Posted By onebighitter

Earlier this year my battery kept going dead and...

Earlier this year my battery kept going dead and turned out to be short in alternator. I disconnected the alternator no more dead battery, alternator was still charging at 14.4 volts.
Forum: C5 General
04-02-2014, 09:47 PM
Replies: 24
Views: 1,201
Posted By onebighitter

Cool story and thanks for telling

Cool story and thanks for telling
Forum: C5 General
03-07-2014, 08:42 PM
Replies: 12
Views: 633
Posted By onebighitter

Feet of snow still here. Tomorrow I am going to...

Feet of snow still here. Tomorrow I am going to go snowmobiling, should be a nice 25 degrees.
Forum: C5 General
03-06-2014, 08:25 PM
Replies: 17
Views: 4,791
Posted By onebighitter

I did my garage floor 6 years ago and holding up...

I did my garage floor 6 years ago and holding up pretty good. The part of the garage that gets all the use from floor jacks, jack stands, where I do all the work is pretty beat up. The rest of the...
Forum: C5 General
02-24-2014, 07:48 PM
Replies: 7
Views: 2,210
Posted By onebighitter

I am pretty happy with the lingenfelter one.

I am pretty happy with the lingenfelter one.
Forum: C5 General
02-13-2014, 11:18 PM
Replies: 48
Views: 4,808
Posted By onebighitter

That is sweet, thanks for sharing

That is sweet, thanks for sharing
Forum: C5 General
02-05-2014, 10:56 PM
Replies: 293
Views: 22,622
Posted By onebighitter

Car looks real good, good luck with it.

Car looks real good, good luck with it.
Forum: Transactions Feedback
02-05-2014, 10:53 PM
Replies: 13
Views: 1,612
Posted By onebighitter

No they told me I was on my own and will not help...

No they told me I was on my own and will not help me out. There is no chance I would ever purchase anything from them again.

There is better supporting vendors out there than them!
Forum: Transactions Feedback
02-02-2014, 09:57 PM
Replies: 13
Views: 1,612
Posted By onebighitter

Used engine from Late Model Racecraft, Texas

In July I purchased a used motor with supposedly 10k from a daily driven 07 vette, purchased as is, forged pistons, rods and crank. They told me priced to sell and I say still was not cheap. I had...
Forum: C5 Parts for Sale/Wanted
07-29-2013, 10:46 PM
Replies: 9
Views: 588
Posted By onebighitter

motor

I have a long block with hole in the side of block. I will ship it to you for shipping plus $25.00. No clue what shipping would be.

Dean
Forum: C5 Parts for Sale/Wanted
07-21-2013, 05:39 PM
Replies: 2
Views: 412
Posted By onebighitter

I will take them, check pm

I will take them, check pm
Forum: C5 Parts for Sale/Wanted
07-05-2013, 11:57 PM
Replies: 10
Views: 1,014
Posted By onebighitter

I do not know anyone in Texas, I understand if...

I do not know anyone in Texas, I understand if you have no interest in shipping
Forum: C5 Parts for Sale/Wanted
06-30-2013, 10:32 PM
Replies: 10
Views: 1,014
Posted By onebighitter

If you decide to ship, I am looking for a...

If you decide to ship, I am looking for a replacement motor in green bay wi
Showing results 1 to 25 of 246
 
Page 1 of 10
1
2
3
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 12:27 PM.