Search: Posts Made By: RonBrooksGA
Showing results 1 to 25 of 55
Search took 0.94 seconds.
08-26-2018, 04:56 PM
Replies: 16
Views: 834
Posted By RonBrooksGA

The radiator is only about 1.5yrs old and with...

The radiator is only about 1.5yrs old and with the water pump being changed about a year ago the coolant has been changed once since it went in. Stock air dam in place. Thank you all for the advice...
08-25-2018, 07:12 PM
Replies: 16
Views: 834
Posted By RonBrooksGA

The car is on an incline so I will try bleeding...

The car is on an incline so I will try bleeding again in the morning after I check the "steam pipes".
08-25-2018, 07:00 PM
Replies: 16
Views: 834
Posted By RonBrooksGA

Sorry. I meant when I open the bleed screw on...

Sorry. I meant when I open the bleed screw on top of the thermostat housing to get air out, I get a solid stream of coolant but only until about a cup or so comes out, then it goes to a trickle. ...
08-25-2018, 06:05 PM
Replies: 16
Views: 834
Posted By RonBrooksGA

Still Cooling Probs, soooo air bleeding question

I have been chasing the same cooling problem for several months. About a year ago my Opti was on the fritz so I had the shop change the water pump as well. Cooling symptoms are that the engine runs...
06-24-2018, 07:00 PM
Replies: 22
Views: 2,437
Posted By RonBrooksGA

Thank you so much! I read #1 and I feel a lot...

Thank you so much! I read #1 and I feel a lot better! I will re-check for any debris on radiator and condenser but I believe I cleared everything and even washed the fins.
06-24-2018, 04:05 PM
Replies: 22
Views: 2,437
Posted By RonBrooksGA

I read #1 and the info on that post is great! If...

I read #1 and the info on that post is great! If it's not a sticky it should be!
06-23-2018, 08:09 PM
Replies: 22
Views: 2,437
Posted By RonBrooksGA

I just came back from a 25mi drive and its 78...

I just came back from a 25mi drive and its 78 right now. The highest the temp goes now is 210. From what everyone has said that's not a high temp to worry about. When driving 50mph or under or at...
06-23-2018, 04:10 PM
Replies: 22
Views: 2,437
Posted By RonBrooksGA

Well unfortunately the thermostat that was in the...

Well unfortunately the thermostat that was in the water pump was the correct design. I installed the new one anyway because, hey, who knows? I've bled and bled the system with the heat on full hot....
06-23-2018, 12:48 PM
Replies: 22
Views: 2,437
Posted By RonBrooksGA

Great idea on the garbage bags! I will go with...

Great idea on the garbage bags! I will go with that and rags above them. I have a new and proper thermostat. Once I open up the and check the one that's installed I will report back but I am glad...
06-22-2018, 10:28 AM
Replies: 22
Views: 2,437
Posted By RonBrooksGA

On the highway the temps climb to 218-220 but...

On the highway the temps climb to 218-220 but around town or driving below 50mph I see 195. The thermostat was supposed to be a 180 degree. I will have to pull it to see if it's a correct design...
06-21-2018, 02:35 PM
Replies: 22
Views: 2,437
Posted By RonBrooksGA

What Happens if WRONG thermostat is used?

I had my OptiSpark changed and with it a new water pump and thermostat at the same time. Now that I have the car back, I have a problem I have never had before. The engine temp is going high...
08-09-2017, 11:11 PM
Replies: 12
Views: 1,757
Posted By RonBrooksGA

The CEL lamp is to the left of he connector. It...

The CEL lamp is to the left of he connector. It just isn't in the photo. The light comes on as soon as the ignition is turned passed aux to ignition on. Then as soon as you engage the starter it...
08-09-2017, 01:03 PM
Replies: 12
Views: 1,757
Posted By RonBrooksGA

All the work I listed was done at a local shop. ...

All the work I listed was done at a local shop. One that several people locally who have C4-C5 Corvettes recommended. I went with all GM parts this time because I was hoping that not only might...
08-09-2017, 02:15 AM
Replies: 12
Views: 1,757
Posted By RonBrooksGA

All the work in mentioned was done at one time...

All the work in mentioned was done at one time and the car has only done 82 miles before it died again.

Fuel pressure tests fine. I am assuming it's not a fuel issue only because when I pull the...
08-09-2017, 01:33 AM
Replies: 12
Views: 1,757
Posted By RonBrooksGA

I should also have added that the engine runs on...

I should also have added that the engine runs on speed density and both O2 sensors were replaced with Bosch units.
08-09-2017, 01:29 AM
Replies: 12
Views: 1,757
Posted By RonBrooksGA

Please HELP Random Complete Ignition Cut Out

HELP! I am at my wits end. If anyone has experienced this issue I would appreciate your advice and any suggestions are welcomed. I will lay out my one problem and then give you the story. Sorry...
04-18-2017, 10:38 PM
Replies: 6
Views: 694
Posted By RonBrooksGA

Unfortunately not. The dash readout doesn't...

Unfortunately not. The dash readout doesn't exist for me and while there is a port for an OBDII reader I don't have one that can read the OBD1 or 1.5 codes that might be stored in the PCM. I don't...
04-18-2017, 08:59 PM
Replies: 6
Views: 694
Posted By RonBrooksGA

I should also have said there is no Mass Air...

I should also have said there is no Mass Air Sensor. The engine runs on speed density. The air temp sensor was also changed as were both O2 sensors when the optispark was changed. The Opti is a GM...
04-18-2017, 08:57 PM
Replies: 6
Views: 694
Posted By RonBrooksGA

Sudden Stalling

I will admit up front to changing parts in the hope of solving the problem. Stupid thing to do without finding the root cause but that's what I did. Along the way I uncovered some things that were...
04-12-2015, 03:39 PM
Replies: 7
Views: 1,338
Posted By RonBrooksGA

That is PERFECT 1984Z51auto!!! $14.99 WELL spent...

That is PERFECT 1984Z51auto!!! $14.99 WELL spent at JEGS! Too bad the last shop I went to didn't know as much as YOU! These forums are such a great place to learn from. The saddest part is this: ...
04-11-2015, 10:43 PM
Replies: 7
Views: 1,338
Posted By RonBrooksGA

Question about oil pump and tack welding oil pump pick up

My pickup has fallen off for the 2nd time in 8k miles. Since the last shop said they welded it when they didn't I'd prefer to do this myself now. I figure I might just as well install a new pump as...
04-09-2015, 09:04 AM
Replies: 6
Views: 770
Posted By RonBrooksGA

ZERO oil pressure on right turns

I have a feeling that I know the answer but here are the symptoms. My '94 just this morning had oil pressure drop to ZERO while making right turns at any sort of decent speed. Oil level is fine and...
10-21-2014, 10:31 PM
Replies: 7
Views: 547
Posted By RonBrooksGA

I don't always have the clutch depressed when...

I don't always have the clutch depressed when braking. I've tried leaving the car in gear and tried different gears and the engine almost always cuts out. Then I tried downshifting while braking...
10-21-2014, 07:47 PM
Replies: 7
Views: 547
Posted By RonBrooksGA

ANY ideas on weird electrical issue?

I have a 1994 with manual transmission with a very weird ignition problem. Or I should say, what I believe to be an ignition problem. I have had her to 2 shops and neither could find the solution....
11-05-2013, 12:53 PM
Replies: 8
Views: 5,761
Posted By RonBrooksGA

That's what I was afraid of. In my installation...

That's what I was afraid of. In my installation the alternator is on the passenger side and the compressor is mounted low on the driver's side. I will take a picture and figure out how to post it...
Showing results 1 to 25 of 55
 


 
Forum Jump


All times are GMT -4. The time now is 10:27 AM.