CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: Vette @ 71
Showing results 1 to 25 of 477
Search took 1.25 seconds.
Forum: C6 Corvette ZR1 & Z06
09-02-2022, 10:26 AM
Replies: 6
Views: 507
Posted By Vette @ 71

Actually it's a simple question, can these cars...

Actually it's a simple question, can these cars run w/o a battery.? I know how to diagnose it.
Forum: C6 Corvette ZR1 & Z06
09-01-2022, 10:49 AM
Replies: 6
Views: 507
Posted By Vette @ 71

The car was running fine, meaning the wires and...

The car was running fine, meaning the wires and cables feeding the starter and solenoid were not under load? The loss of all power, lights, dash etc seems to point to battery going south,
The...
Forum: C6 Corvette ZR1 & Z06
08-31-2022, 03:08 PM
Replies: 6
Views: 507
Posted By Vette @ 71

Car suddenly died

2006 C6 Z06, driving along and car suddenly, no warning just dies. No lights or power. Does the car require a battery (replaced about 6 months ago) to run?TIA
Forum: C6 Corvette ZR1 & Z06
11-22-2019, 12:23 PM
Replies: 10
Views: 2,524
Posted By Vette @ 71

Good Grief Hib, this procedure sounds more like...

Good Grief Hib, this procedure sounds more like an April Fools joke. What the hell was GM thinking?
Forum: C6 Corvette ZR1 & Z06
11-20-2019, 09:07 PM
Replies: 10
Views: 2,524
Posted By Vette @ 71

Thanks Hib I took the car to dealer and using...

Thanks Hib I took the car to dealer and using their Code reader , the car was communicating?? What goes?
Forum: C6 Corvette ZR1 & Z06
11-19-2019, 01:40 PM
Replies: 10
Views: 2,524
Posted By Vette @ 71

OBD not ready ?

Took my 2006 in for emissions check and OBD says no data ? Car sat for a while. How much driving is required for it to wake up and speak? TIA
Forum: C6 Corvette ZR1 & Z06
04-12-2019, 03:48 PM
Replies: 35
Views: 7,484
Posted By Vette @ 71

Toeque

75 lb/ft
Forum: C6 Corvette ZR1 & Z06
01-23-2019, 04:16 PM
Replies: 42
Views: 8,157
Posted By Vette @ 71

I was hoping mid Atlantic area.

I was hoping mid Atlantic area.
Forum: C6 Corvette ZR1 & Z06
01-22-2019, 12:34 PM
Replies: 42
Views: 8,157
Posted By Vette @ 71

AHP Locations

Do u presently have a list of east coast locations? What future east coast locations ?
Forum: C6 Corvette ZR1 & Z06
12-21-2018, 02:48 PM
Replies: 26
Views: 2,573
Posted By Vette @ 71

Any rotating mass down stream of the crankshaft...

Any rotating mass down stream of the crankshaft output will reduce the Tq as measured at the wheels including
the wheels.
Forum: C6 Corvette ZR1 & Z06
12-21-2018, 01:13 PM
Replies: 26
Views: 2,573
Posted By Vette @ 71

The loss or losses are in the engines Torque not...

The loss or losses are in the engines Torque not Hp. Dyno's measure Tq and converted to Hp which is a totally made up and unitless number based upon what a HORSE could pull vs a steam engine.To give...
Forum: C6 Corvette ZR1 & Z06
10-16-2018, 01:59 PM
Replies: 60
Views: 9,055
Posted By Vette @ 71

The part that failed was the intake valve, the...

The part that failed was the intake valve, the question is , what caused it to fail.?
Forum: C6 Corvette ZR1 & Z06
10-02-2018, 03:12 PM
Replies: 65
Views: 6,556
Posted By Vette @ 71

Yep , more than 1. I worked the problem my friend...

Yep , more than 1. I worked the problem my friend .
Forum: C6 Corvette ZR1 & Z06
10-02-2018, 12:23 PM
Replies: 65
Views: 6,556
Posted By Vette @ 71

The o rings saw 5000 deg F temp when the joint...

The o rings saw 5000 deg F temp when the joint opened. No rubber material can withstand this temperature. The joint was thought to be 2 fault tolerant against failure, However , the joint flexed...
Forum: C6 Corvette ZR1 & Z06
10-02-2018, 11:17 AM
Replies: 65
Views: 6,556
Posted By Vette @ 71

Challenger

No it was a design failure. The design of the joint between the 2 casings was thought to have been redundant as to preventing gas from escaping during initial pressure buildup. It was not redundant,...
Forum: C6 Corvette ZR1 & Z06
08-27-2018, 04:50 PM
Replies: 21
Views: 1,882
Posted By Vette @ 71

Clutch

Clutch recall 14714
Forum: C6 Corvette ZR1 & Z06
06-24-2018, 11:18 AM
Replies: 29
Views: 8,899
Posted By Vette @ 71

heads

Do you know what condition your heads were in?
Forum: C6 Corvette ZR1 & Z06
03-08-2018, 05:42 PM
Replies: 18
Views: 1,464
Posted By Vette @ 71

Indication of a H2 leak. Does not take but a 2%...

Indication of a H2 leak. Does not take but a 2% by volume for H2 to explode in presence of a source. The battery cable looks to have some corrosion? and when it began discharging jumped a...
Forum: C6 Corvette ZR1 & Z06
10-19-2017, 03:02 PM
Replies: 10
Views: 1,591
Posted By Vette @ 71

Bridgestone comparison of brake...

Bridgestone comparison of brake materials..https://www.bridgestonetire.com/tread-and-trend/drivers-ed/ceramic-vs-metallic-brake-pads
Forum: C6 Corvette ZR1 & Z06
10-19-2017, 12:25 PM
Replies: 10
Views: 1,591
Posted By Vette @ 71

Brakes Pads

Hawk Performance Ceramic Brakes, dustless front and back.:thumbs:
Forum: C6 Corvette ZR1 & Z06
04-13-2017, 03:07 PM
Replies: 26
Views: 5,422
Posted By Vette @ 71

You appear to be a moron..

You appear to be a moron..
Forum: C6 Corvette ZR1 & Z06
04-13-2017, 11:05 AM
Replies: 26
Views: 5,422
Posted By Vette @ 71

[QUOTE=MTPZ06;1594516497]Sounds like the...

[QUOTE=MTPZ06;1594516497]Sounds like the procedure right out of the GM service manuals... :thumbs:

(before they recently revised them for some odd reason) :rofl:[/QUOTE

They were revised...
Forum: C6 Corvette ZR1 & Z06
04-12-2017, 10:30 AM
Replies: 26
Views: 5,422
Posted By Vette @ 71

Did they tell u what/how wiggle test method they...

Did they tell u what/how wiggle test method they used? Results
Forum: C6 Corvette ZR1 & Z06
02-15-2017, 04:51 PM
Replies: 421
Views: 119,517
Posted By Vette @ 71

Valve guides

Do u know if they were out of spec and by how much??
Forum: C6 Corvette ZR1 & Z06
12-23-2016, 11:04 AM
Replies: 45
Views: 5,714
Posted By Vette @ 71

Mean man Mean!!:smash::smash:

Mean man Mean!!:smash::smash:
Showing results 1 to 25 of 477
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 01:37 AM.