CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 3
1
2
3
Search: Posts Made By: Freebird427
Showing results 1 to 25 of 57
Search took 0.90 seconds.
Forum: C6 Corvette ZR1 & Z06
03-12-2017, 11:50 AM
Replies: 316
Views: 43,292
Posted By Freebird427

I'll be coming out with my own 'HCI Mamo build'...

I'll be coming out with my own 'HCI Mamo build' thd here in a few weeks. That said, I can confirm everything Jayfabs said and then some. You'll have a hard time finding a better / smarter...
Forum: C6 Corvette ZR1 & Z06
03-04-2017, 09:04 PM
Replies: 316
Views: 43,292
Posted By Freebird427

Stating the obvious but, ARP bolt for the H/B ...

Stating the obvious but, ARP bolt for the H/B

On the injectors, I went FIC bosch 60lb-ls3-ls7-ls9. It'll be less cam than what you'll be running.
Forum: C6 Corvette ZR1 & Z06
06-07-2016, 01:02 PM
Replies: 47
Views: 4,375
Posted By Freebird427

What he said :thumbs:

What he said :thumbs:
Forum: C6 Corvette ZR1 & Z06
06-07-2016, 12:54 PM
Replies: 1
Views: 3,071
Posted By Freebird427

Carbon and not that expensive: Amazon.com:...

Carbon and not that expensive:

Amazon.com: Gorilla carbonworksTM Carbon fiber composites repair kit: Automotive
Forum: C6 Corvette ZR1 & Z06
01-16-2016, 12:46 PM
Replies: 12
Views: 1,531
Posted By Freebird427

Bill Dearborn: "Low sensor batteries can...

Bill Dearborn:

"Low sensor batteries can cause incorrect readings such as reading 0 instead of the correct pressure."

Bill, Can Low sensor batteries also cause low tire psi readings, say 35...
Forum: C6 Corvette ZR1 & Z06
01-10-2016, 07:38 PM
Replies: 16
Views: 1,810
Posted By Freebird427

I've seen the same result in the past with a cam...

I've seen the same result in the past with a cam change. It was a pretty big change in engine braking. I put it down to dynamic compression change.

FB
Forum: C7 Z06 Discussion
01-09-2016, 04:03 PM
Replies: 20
Views: 5,064
Posted By Freebird427

To Dans point. My previous car was a 95 F body. ...

To Dans point. My previous car was a 95 F body. When I built up the engine and added good tires, It took shocks, aftermarket control arms on revised geometry, urethane suspension bushings, and a...
Forum: C6 Corvette ZR1 & Z06
12-24-2015, 03:50 PM
Replies: 49
[Z06] Shifter kart
Views: 6,148
Posted By Freebird427

Something to aspire to : ...

Something to aspire to :

https://www.youtube.com/watch?v=C6rXSjpdLz0
Forum: C6 Corvette ZR1 & Z06
12-03-2015, 12:55 PM
Replies: 64
Views: 5,515
Posted By Freebird427

Nicely done Bill. Welcome to the dark side...

Nicely done Bill. Welcome to the dark side (black). Not sure you know how much work you just signed up for to keeping that car looking good.

Small request, can you keep that C6 avatar of...
Forum: C6 Corvette ZR1 & Z06
11-18-2015, 10:36 AM
Replies: 2,877
Views: 930,518
Posted By Freebird427

Fixed with a different adhesive as part of a...

Fixed with a different adhesive as part of a recall. Probably a 2 hr job at the dealer. On mine you could hear things moving around up there as you drove over uneven surfaces. after the fix, no...
Forum: C6 Corvette ZR1 & Z06
11-08-2015, 03:41 PM
Replies: 38
Views: 4,611
Posted By Freebird427

Nicely Done !! FB

Nicely Done !!

FB
Forum: C6 Corvette ZR1 & Z06
11-04-2015, 01:10 PM
Replies: 2,877
Views: 930,518
Posted By Freebird427

Added some new shoes and anchors to the Beast...

Added some new shoes and anchors to the Beast over the summer

FB
Forum: C6 Corvette ZR1 & Z06
11-01-2015, 01:44 PM
Replies: 10
Views: 870
Posted By Freebird427

Got to stop here as part of the 2010 Hot rod...

Got to stop here as part of the 2010 Hot rod Power Tour. Very nicely done I thought. It is cool to stand there and watch new owners get checked out / drive out in their new Vett's

Was driving...
Forum: C6 Corvette ZR1 & Z06
10-21-2015, 01:42 PM
Replies: 61
Views: 20,286
Posted By Freebird427

I've been surprised how much wind up or lack of...

I've been surprised how much wind up or lack of steering precision there is on the front end of these cars when the front is under side load. This goes to what LD mentioned earlier on control arm...
Forum: Autocrossing & Roadracing
10-10-2015, 04:15 PM
Replies: 40
Views: 1,715
Posted By Freebird427

I believe the highest revving V10's to actually...

I believe the highest revving V10's to actually hit the track were the Suzuka Specials. The highest rev's I remember run the track were 19,600 for Honda, 19,200 for Ferrari, high 18K for Merc. I...
Forum: C6 Corvette ZR1 & Z06
09-25-2015, 01:14 PM
Replies: 28
Views: 5,169
Posted By Freebird427

Added CAI (HALTECH MF107), ported TB (Pete...

Added CAI (HALTECH MF107), ported TB (Pete Incaudo), and ARH long tubes (1 7/8) at the same time. Before tune I noticed a huge improvement on response over stock. After tune from DynoTune Speed &...
Forum: Autocrossing & Roadracing
08-29-2015, 01:25 PM
Replies: 6
Views: 1,254
Posted By Freebird427

Nicely driven kotik. Had a rental car loose...

Nicely driven kotik.

Had a rental car loose on here last April. Would have been a lot more fun in the Beast as not that many cars on the track at the time.

The track was a lot smoother than...
Forum: C7 Z06 Discussion
08-17-2015, 08:13 AM
Replies: 13
Views: 4,820
Posted By Freebird427

Check with Halltech and Katech.

Check with Halltech and Katech.
Forum: C7 Z06 Discussion
08-16-2015, 05:53 PM
Replies: 13
Views: 4,820
Posted By Freebird427

Gunmetal Forgeline CF-1's on ZR1 sizing.

Gunmetal Forgeline CF-1's on ZR1 sizing.
Forum: C7 Z06 Discussion
08-16-2015, 12:52 PM
Replies: 13
Views: 4,820
Posted By Freebird427

To the OP, I've recently installed a CCM set up...

To the OP, I've recently installed a CCM set up on a C6Z. I asked all the same questions as you are asking. For me the parts were a strait bolt on and all the sensors for wheel speed were upstream...
Forum: Autocrossing & Roadracing
07-23-2015, 12:50 PM
Replies: 15
Views: 2,596
Posted By Freebird427

2nd on Solofast's comment. Also, practice on...

2nd on Solofast's comment. Also, practice on public roads any chance you get.
Forum: Autocrossing & Roadracing
07-18-2015, 12:42 PM
Replies: 22
Views: 3,921
Posted By Freebird427

" I have seen some posts that think there is...

"
I have seen some posts that think there is interference with the sensor system in some way from either plugging an accessory into the cigarette lighter instead of the plug on the console or some...
Forum: C6 Corvette ZR1 & Z06
06-30-2015, 12:53 PM
Replies: 157
Views: 22,365
Posted By Freebird427

Hey Darin, Add me to the growing list of...

Hey Darin,

Add me to the growing list of people appreciating your time and input here.

Two questions:

Playing off Michael D's question a little. Related to the issues were seeing on GM LS&...
Forum: C6 Corvette ZR1 & Z06
06-21-2015, 12:02 PM
Replies: 38
Views: 6,631
Posted By Freebird427

To build on this thought. Working for an...

To build on this thought.

Working for an OEM I see how many times endurance tests are conducted with non prod (prototype) parts or parts that are built to nominal. The GM reliability /...
Forum: C6 Corvette ZR1 & Z06
06-08-2015, 12:54 PM
Replies: 10
Views: 1,131
Posted By Freebird427

Just started noticing this a few weeks ago. ...

Just started noticing this a few weeks ago. Already have skirts. Clear bra about to go on.

FB
Showing results 1 to 25 of 57
 
Page 1 of 3
1
2
3


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 12:12 PM.