CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 19
1
2
3
11
Last »
Search: Posts Made By: RedRiderZR1
Showing results 1 to 25 of 452
Search took 1.62 seconds.
Forum: C5 Tech
05-06-2023, 12:31 PM
Replies: 20
Views: 10,409
Posted By RedRiderZR1

A couple of things I will put in here on this...

A couple of things I will put in here on this issue. First is, if you do this job buy a solder sucker iron. Makes the job a breeze de-soldering this board. They are pretty cheap online. I can pull...
Forum: C5 Tech
07-17-2022, 07:34 PM
Replies: 3
Views: 329
Posted By RedRiderZR1

Below is the code from the service manual with...

Below is the code from the service manual with the wiring schematic.


https://cimg9.ibsrv.net/gimg/www.corvetteforum.com-vbulletin/1588x669/c1232a_a8b6da27d0b7920cf62bd731205da76904a4fc33.png...
Forum: C5 Tech
07-13-2022, 07:54 PM
Replies: 4
Views: 966
Posted By RedRiderZR1

Write down all the codes it is throwing. Open...

Write down all the codes it is throwing. Open HPTUNERS and select your tune, then under ENGINE DIAG select the DTCs tab, scroll down to the codes you wrote down and under the SES ENABLE check box...
Forum: C5 Tech
06-18-2022, 08:46 PM
Replies: 5
Views: 783
Posted By RedRiderZR1

I have a question about what you said on the...

I have a question about what you said on the first post (The harness was originally damaged, though I have also verified that the correct harness for the year and options was INSTALLED). So, you are...
Forum: C5 Tech
06-17-2022, 09:50 PM
Replies: 5
Views: 783
Posted By RedRiderZR1

Just for good measure to trace wiring... ...

Just for good measure to trace wiring...

https://cimg7.ibsrv.net/gimg/www.corvetteforum.com-vbulletin/727x583/ebcm_power_and_ground_25a65b59f1493703588b90d0ec7827ef61eab0e0.png...
Forum: C5 Tech
06-17-2022, 09:35 PM
Replies: 5
Views: 783
Posted By RedRiderZR1

Here are the schematics of the EBCM. NO COMM...

Here are the schematics of the EBCM. NO COMM usually is because of a power problem to the EBCM or the serial data has an issue talking with it or a bad EBCM (guessing with 2 EBCMs this isn't the...
Forum: C5 Tech
11-05-2021, 04:32 AM
Replies: 1
Views: 527
Posted By RedRiderZR1

Look at post 2 in this thread below. Long read,...

Look at post 2 in this thread below. Long read, but it has all the info your looking for. Also info on your code is in there.
...
Forum: C5 Tech
10-29-2021, 08:52 PM
Replies: 5
Views: 425
Posted By RedRiderZR1

And I thought I was the only one to have this...

And I thought I was the only one to have this issue. Gary was the one who pinned my hyperflash harness for the brake issue. There were only 2 open slots on my harness, he pinned those. After that,...
Forum: C5 Tech
10-28-2021, 07:14 PM
Replies: 22
Views: 1,500
Posted By RedRiderZR1

While C5Diag is working with you on your starting...

While C5Diag is working with you on your starting issues, I want to address the codes you are seeing. These are mostly tuning issue codes.
Let's start with the P1514 code.
This code refers to the...
Forum: Testing
10-27-2021, 02:32 PM
Replies: 0
Views: 289
Posted By RedRiderZR1

test

test
Forum: C5 Tech
10-26-2021, 11:51 PM
Replies: 10
Views: 5,930
Posted By RedRiderZR1

The ABS has stopped working because of the C1225...

The ABS has stopped working because of the C1225 code, (Left Front Wheel Speed Variation). The car is not receiving the correct information with wheel speed to know how to respond with ABS, TCS, or...
Forum: C5 Tech
10-14-2021, 04:29 PM
Replies: 2
Pcr
Views: 433
Posted By RedRiderZR1

Just like it was mentioned above, it plugs into...

Just like it was mentioned above, it plugs into your IAT sensor. It tricks your computer into thinking it is ingesting colder air. I provided below the table from hp tuners that show what your 2003...
Forum: C5 Tech
10-14-2021, 02:23 PM
Replies: 12
Views: 2,147
Posted By RedRiderZR1

Peter, Since you have a 1998 there are two...

Peter,
Since you have a 1998 there are two possible mounting locations for your module. Is the module located at the rear of the car or under the hood?
There are 2 different modules built for...
Forum: C5 Tech
10-11-2021, 09:33 PM
Replies: 9
Views: 4,512
Posted By RedRiderZR1

You are going to need tune work. The reason you...

You are going to need tune work. The reason you cant throttle up is the vehicle it came from is drive-by-cable, your vette is drive-by-wire. So you will not get past idle until tuning is done.
Forum: C5 Parts for Sale/Wanted
10-08-2021, 07:10 PM
Replies: 5
Views: 473
Posted By RedRiderZR1

There would have to be some codes set. Can you...

There would have to be some codes set. Can you post codes from the Driver Information Center? These codes would be under TCS.
You mention "every other startup", if true, probably not a bad EBCM. If...
Forum: C5 Tech
10-08-2021, 06:47 PM
Replies: 9
Views: 4,512
Posted By RedRiderZR1

You will need to rescale the fuel gauge info from...

You will need to rescale the fuel gauge info from the 97 ECM to the 411 ECM. If you go to HP TUNERS Repository, you can download a 02 corvette tune file and compare it to your 97 ECM. Under the "Fuel...
Forum: C5 Parts for Sale/Wanted
10-08-2021, 12:54 AM
Replies: 5
Views: 473
Posted By RedRiderZR1

What codes are you throwing? Post up your codes....

What codes are you throwing? Post up your codes. Does it do it all the time or just every so often? Might be repairable.
Forum: C5 Tech
10-07-2021, 09:33 PM
Replies: 5
Views: 641
Posted By RedRiderZR1

Yes, 99 is exactly the same. Are you getting...

Yes, 99 is exactly the same.
Are you getting DTC P0650?

https://cimg9.ibsrv.net/gimg/www.corvetteforum.com-vbulletin/2000x1550/0001_1ec8b06fd128230dcda7479604dabcf8c8592576.jpg
Forum: C5 Tech
10-06-2021, 05:45 PM
Replies: 15
Views: 2,934
Posted By RedRiderZR1

What version of the software is your TECH 2...

What version of the software is your TECH 2 running? You mentioned you only saw 8 to his 11 modules listed. If you power down your unit and power it back up, on the splash screen that says TECH 2,...
Forum: C5 Tech
08-19-2021, 06:49 PM
Replies: 4
Views: 1,133
Posted By RedRiderZR1

Welcome to the forum. That light can be caused...

Welcome to the forum.
That light can be caused by many things without it being a bad EBCM. It talks to sensors on the vehicle. If one of those sensors is having a reading problem then it will...
Forum: Southern California
07-29-2021, 10:56 PM
Replies: 34
Views: 1,951
Posted By RedRiderZR1

:thumbs::thumbs:

:thumbs::thumbs:
Forum: C5 Tech
07-21-2021, 07:05 PM
Replies: 9
Views: 685
Posted By RedRiderZR1

Been a while since I have been in there. This is...

Been a while since I have been in there. This is from a C5 dash removal thread. Shows the backside of the cigarette lighter before being removed. If so, looks like the wire for the ground is missing...
Forum: C5 Tech
07-19-2021, 03:15 PM
Replies: 9
Views: 685
Posted By RedRiderZR1

Here is a pic of a 1997-2004 lighter receptacle....

Here is a pic of a 1997-2004 lighter receptacle. Should have 2 slip-on plugs. One for the orange wire and one for the black one, unless it's been cut or lying loose under the radio somewhere.
...
Forum: C5 Tech
07-19-2021, 03:06 PM
Replies: 9
Views: 685
Posted By RedRiderZR1

I have the schematics I will add here. Not sure...

I have the schematics I will add here. Not sure about an eyelet for the ground wire though. The lighter should have a black wire coming off of it for ground. The ground goes to G202 which is at the...
Forum: Testing
07-14-2021, 10:24 PM
Replies: 2
Views: 433
Posted By RedRiderZR1

test

attachment
Showing results 1 to 25 of 452
 
Page 1 of 19
1
2
3
11
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 03:32 PM.