CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 3
1
2
3
Search: Posts Made By: c3sleeper
Showing results 1 to 25 of 63
Search took 0.81 seconds.
Forum: C3 Tech/Performance
12-04-2012, 10:31 PM
Replies: 52
Views: 7,117
Posted By c3sleeper

How does it look?

http://i1172.photobucket.com/albums/r567/c3sleeper/72153_10151328196326383_271070129_n.jpg
http://i1172.photobucket.com/albums/r567/c3sleeper/305949_10151329848071383_1025774637_n.jpg
Forum: C3 Tech/Performance
11-01-2012, 01:49 PM
Replies: 20
Views: 2,280
Posted By c3sleeper

The best part of waking up

Kick that Chinese rip off and install a tried and tested folgers can. Previous owner replaced my car with one and it's been sealed tight and tough for 20 years!
Forum: C3 Parts for Sale/Wanted
08-30-2012, 01:43 PM
Replies: 2
Views: 356
Posted By c3sleeper

Mufflers

1978-1982 Magnaflow Mufflers are included. No catalytic convertors.
Forum: C3 Parts for Sale/Wanted
08-30-2012, 01:40 PM
Replies: 2
Views: 356
Posted By c3sleeper

FS 1980-1981 True Dual Exhaust

Full dual exhaust including O2 sensor and all needed brackets. No rust or dings of any kind. Headers are not included. Removing to install side exhaust. $200 O.B.O.
Forum: C3 Tech/Performance
05-28-2012, 07:31 PM
Replies: 12
Views: 1,127
Posted By c3sleeper

I'm with the computer guys. Pulling that...

I'm with the computer guys. Pulling that electronic q-jet will make the computer very angry and that angry computer is what bosses your dizzy around. If you want here to run well with that catbpull...
Forum: C3 Tech/Performance
05-22-2012, 10:03 PM
Replies: 19
Views: 1,049
Posted By c3sleeper

From someone who has made the same mistake please...

From someone who has made the same mistake please for all glories sake simply slide under the car and have someone roll the throttle in and out. I had the same sound when I installed a new starter...
Forum: C3 Tech/Performance
05-04-2012, 05:39 PM
Replies: 52
Views: 7,117
Posted By c3sleeper

Any ideas on how the cut the ride height back...

Any ideas on how the cut the ride height back down? Cutting a couple pounds from the engine compartment has made even these old springs sit high in the front.
Forum: C3 Tech/Performance
05-04-2012, 11:04 AM
Replies: 122
Views: 11,349
Posted By c3sleeper

Jut a little piece of my dewitts experience and...

Jut a little piece of my dewitts experience and why they truly have the best quality and value product out there.

"Well guys she touched ground and rolled for the first time today and I'll give...
Forum: C3 Tech/Performance
05-04-2012, 11:00 AM
Replies: 52
Views: 7,117
Posted By c3sleeper

Well guys she touched ground and rolled for the...

Well guys she touched ground and rolled for the first time today and I'll give you a quick rundown...holy s@$! is the only term that seems appropriate ha beautiful loping idle on the bottom end and...
Forum: C3 Tech/Performance
05-01-2012, 03:21 PM
Replies: 52
Views: 7,117
Posted By c3sleeper

Ya Cody got hit pretty hard. One of his horses...

Ya Cody got hit pretty hard. One of his horses got picked up and moved about a half mile but didn't scuff him up to terrible. Windows got knocked out of his house too. Crazy that I just talked to...
Forum: C3 Tech/Performance
05-01-2012, 02:24 PM
Replies: 52
Views: 7,117
Posted By c3sleeper

I actually live in Norman now as i'm attending OU...

I actually live in Norman now as i'm attending OU but every weekend is spent at home working on the car. A few of our friends barns were blown away and I thank the lucky stars that months of my hard...
Forum: C3 Tech/Performance
04-30-2012, 04:24 PM
Replies: 52
Views: 7,117
Posted By c3sleeper

http://i1172.photobucket.com/albums/r567/c3sleeper...

http://i1172.photobucket.com/albums/r567/c3sleeper/th_IMG_0077.jpg (http://s1172.photobucket.com/albums/r567/c3sleeper/?action=view&current=IMG_0077.mp4)
Forum: C3 Tech/Performance
04-30-2012, 04:23 PM
Replies: 52
Views: 7,117
Posted By c3sleeper

Heres a little video of her starting up for the...

Heres a little video of her starting up for the second time. I know the sound is terrible but better video will come. This video is with headers on and no exhaust but later one will be uploaded...
Forum: C3 Tech/Performance
04-30-2012, 04:17 PM
Replies: 52
Views: 7,117
Posted By c3sleeper

http://i1172.photobucket.com/albums/r567/c3sleeper...

http://i1172.photobucket.com/albums/r567/c3sleeper/IMG_0309.jpg
http://i1172.photobucket.com/albums/r567/c3sleeper/IMG_5540.jpg
http://i1172.photobucket.com/albums/r567/c3sleeper/IMG_3794.jpg
...
Forum: C3 Tech/Performance
04-23-2012, 10:40 AM
Replies: 52
Views: 7,117
Posted By c3sleeper

See I thought it would be as well but when I set...

See I thought it would be as well but when I set the hood on to test it closed almost completely and when the nut was removed from the lid there were no issues so go figure. If it didn't fit I was...
Forum: C3 Tech/Performance
04-22-2012, 07:46 PM
Replies: 52
Views: 7,117
Posted By c3sleeper

Is there anyone out there who reinforces the rear...

Is there anyone out there who reinforces the rear ends for 81s? I dont figure the stock aluminum will hold out for very long with 460hp and 490ftlbs twistings on 275's.
Forum: C3 Tech/Performance
04-22-2012, 07:42 PM
Replies: 52
Views: 7,117
Posted By c3sleeper

http://i1172.photobucket.com/albums/r567/c3sleeper...

http://i1172.photobucket.com/albums/r567/c3sleeper/Engine1.jpg
http://i1172.photobucket.com/albums/r567/c3sleeper/Engine2.jpg
http://i1172.photobucket.com/albums/r567/c3sleeper/Engine3.jpg...
Forum: C3 Tech/Performance
04-17-2012, 09:58 PM
Replies: 52
Views: 7,117
Posted By c3sleeper

Yet despite all this it is completely unrelated...

Yet despite all this it is completely unrelated to this thread as it was merely mentioned in passing. I appreciate the underhanded sarcasm but if you could I would appreciate it if you would simply...
Forum: C3 Tech/Performance
04-16-2012, 04:14 PM
Replies: 52
Views: 7,117
Posted By c3sleeper

http://i1172.photobucket.com/albums/r567/c3sleeper...

http://i1172.photobucket.com/albums/r567/c3sleeper/522635_10150813059926383_640131382_11683718_15264460_n.jpg
Forum: C3 Tech/Performance
04-09-2012, 02:08 PM
Replies: 52
Views: 7,117
Posted By c3sleeper

Since taking those pictures I have cleaned out...

Since taking those pictures I have cleaned out the entire engine bay, painted the bay, completed an overhaul of the front suspension, removed and replaced all hoses, and installed the engine...
Forum: C3 Tech/Performance
04-09-2012, 02:04 PM
Replies: 52
Views: 7,117
Posted By c3sleeper

• 4 BOLT MAIN 1 PIECE REAR SEAL BLOCK • NEW...

• 4 BOLT MAIN 1 PIECE REAR SEAL BLOCK
• NEW STROKER CRANKSHAFT
• PERFORMANCE CONNECTING RODS
• HYPEREUTECTIC PISTONS 10 TO 1 COMPRESSION
• RUNS ON PUMP GAS
• SPEED PRO MOLY RINGS
• CUSTOM...
Forum: C3 Tech/Performance
04-09-2012, 01:19 AM
Replies: 52
Views: 7,117
Posted By c3sleeper

Not sure on the exact model but just by...

Not sure on the exact model but just by eyeballing it the only difference seems to be a deeper drop once it clears the steering rod. The manufacturer of the engine approved the specs and as good as...
Forum: C3 Tech/Performance
04-08-2012, 06:05 PM
Replies: 52
Views: 7,117
Posted By c3sleeper

http://i1172.photobucket.com/albums/r567/c3sleeper...

http://i1172.photobucket.com/albums/r567/c3sleeper/002-5.jpg
http://i1172.photobucket.com/albums/r567/c3sleeper/001-5.jpg
Forum: C3 Tech/Performance
04-08-2012, 05:59 PM
Replies: 52
Views: 7,117
Posted By c3sleeper

http://i1172.photobucket.com/albums/r567/c3sleeper...

http://i1172.photobucket.com/albums/r567/c3sleeper/014.jpg
http://i1172.photobucket.com/albums/r567/c3sleeper/013.jpg
http://i1172.photobucket.com/albums/r567/c3sleeper/012.jpg...
Forum: C3 Tech/Performance
04-07-2012, 02:20 PM
Replies: 52
Views: 7,117
Posted By c3sleeper

Just for a new guy how does one go about posting...

Just for a new guy how does one go about posting pictures on here?
Showing results 1 to 25 of 63
 
Page 1 of 3
1
2
3


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 02:59 AM.