CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 2
1
2
Search: Posts Made By: JustCruzin
Showing results 1 to 25 of 47
Search took 0.87 seconds.
Forum: C4 Tech/Performance
07-13-2011, 01:04 PM
Replies: 13
Views: 552
Posted By JustCruzin

:iagree: however if you ohm check them and they...

:iagree: however if you ohm check them and they are out of spec. IE: 8ohms. The story is over. and there is no need to waste time shipping them out to be tested as an injector with 10 ohm coils is...
Forum: C4 Tech/Performance
07-13-2011, 10:26 AM
Replies: 13
Views: 552
Posted By JustCruzin

Ohming out an injector is not going to tell you...

Ohming out an injector is not going to tell you the whole story, get them up on a bench. IMO
Forum: C4 General Discussion
07-12-2011, 10:46 AM
Replies: 41
Views: 3,485
Posted By JustCruzin

:iagree: Lots of good info and advice here....

:iagree: Lots of good info and advice here. Nothing wrong with rebuilds. Take some suggestions and go with them..
Forum: C4 Tech/Performance
06-17-2011, 12:02 PM
Replies: 7
Views: 1,441
Posted By JustCruzin

Diaphragm should fit no problem. AFPR has a disc...

Diaphragm should fit no problem. AFPR has a disc that sits on top of the spring. After that put a gage on the rail and see if it holds pressure. Could still be a leaking injector Don't think a...
Forum: C5 General
06-08-2011, 02:15 PM
Replies: 10
Views: 1,731
Posted By JustCruzin

:iagree:

:iagree:
Forum: C4 Tech/Performance
06-02-2011, 12:55 PM
Replies: 22
Views: 1,669
Posted By JustCruzin

:iagree:

:iagree:
Forum: C4 Tech/Performance
05-26-2011, 12:06 PM
Replies: 33
Views: 2,146
Posted By JustCruzin

:iagree:

:iagree:
Forum: C4 Tech/Performance
05-26-2011, 12:05 PM
Replies: 33
Views: 2,146
Posted By JustCruzin

I used an empty can of corn nibblets, did'nt work...

I used an empty can of corn nibblets, did'nt work as well. :ack:
Forum: C4 Tech/Performance
05-24-2011, 10:00 AM
Replies: 9
Views: 1,532
Posted By JustCruzin

:iagree:

:iagree:
Forum: C4 Tech/Performance
05-23-2011, 03:10 PM
Replies: 33
Views: 2,146
Posted By JustCruzin

It was a good salesman to talk you out of Bosch...

It was a good salesman to talk you out of Bosch injectors and into Delphi, IMO. The Bosch d3 are 19lb injectors but at our psi of 43.5 they run 22lb. I would have left the pink tops in as you say the...
Forum: C4 Tech/Performance
05-14-2011, 06:38 PM
Replies: 8
Views: 1,581
Posted By JustCruzin

:iagree:

:iagree:
Forum: C4 Tech/Performance
05-13-2011, 10:50 AM
Replies: 24
Views: 2,502
Posted By JustCruzin

Everyone thinks changing injectors is a cure all,...

Everyone thinks changing injectors is a cure all, Go ahead, give it a shot. Worst case you'll have new injectors :willy:

ps. FIC is a good company...
Forum: C4 Tech/Performance
05-13-2011, 10:16 AM
Replies: 8
Views: 1,581
Posted By JustCruzin

Cal do you have this post on your clipboard or...

Cal do you have this post on your clipboard or just memorized :rofl:
Forum: C4 Tech/Performance
05-13-2011, 10:13 AM
Replies: 8
Views: 1,581
Posted By JustCruzin

:iagree: Injectors leak or they don't. Check the...

:iagree: Injectors leak or they don't. Check the system first. Pull the vac off the FPR to see if you see/smell gas. You don't wnat to chase this by buying parts you don't need.
Forum: C4 Tech/Performance
05-13-2011, 10:08 AM
Replies: 3
Views: 495
Posted By JustCruzin

Don't think it's injectors, pull the vac line...

Don't think it's injectors, pull the vac line from the reg. If the FPR is bad you should see/smell gas in it. Just a thought.
Forum: C5 Forced Induction/Nitrous
05-11-2011, 09:12 AM
Replies: 16
Views: 977
Posted By JustCruzin

:iagree: Let the shop change them out then they...

:iagree: Let the shop change them out then they will be responsible for the installation and tune. If you do it yourself they can come back and say you messed up the install.
Forum: C4 Tech/Performance
05-10-2011, 10:14 AM
Replies: 24
Views: 2,502
Posted By JustCruzin

:iagree: After two years of sitting the filters...

:iagree: After two years of sitting the filters in the injectors could dry rot, fall apart and restrict the flow...
Forum: C6 Forced Induction/Nitrous
04-28-2011, 05:27 PM
Replies: 84
Views: 13,401
Posted By JustCruzin

Excuse my referance Spacers, Adapters you know...

Excuse my referance Spacers, Adapters you know what I mean.

QUOTE=dmaxcamss;1577470912]Do you know if Siemens makes 80ish lb. injector that's a direct swap for the LS2 (correct...
Forum: C6 Forced Induction/Nitrous
04-28-2011, 04:36 PM
Replies: 84
Views: 13,401
Posted By JustCruzin

[QUOTE=dmaxcamss;1577470332]DSteck, I think we're...

[QUOTE=dmaxcamss;1577470332]DSteck, I think we're both misunderstanding each other. You stated that the ID850s are a direct swap for the LS3/LS7, which are shorter and use different o-rings. So if I...
Forum: C6 Forced Induction/Nitrous
04-28-2011, 02:32 PM
Replies: 84
Views: 13,401
Posted By JustCruzin

Maybe I don’t know squat. With that being said...

Maybe I don’t know squat. With that being said how much does the characteristics change by milling off the diffuser? IDK Bosch is pretty consistent when it comes to QC. I can’t see them changing much...
Forum: C6 Forced Induction/Nitrous
04-28-2011, 11:58 AM
Replies: 84
Views: 13,401
Posted By JustCruzin

IMO Don't get star struck over the ID injectors....

IMO Don't get star struck over the ID injectors. There’s a lot of yada yada. Other shops have been doing this mod for quite some time, no magic to it. Shop around. A matched set is still a matched...
Forum: C4 Tech/Performance
04-11-2011, 10:12 AM
Replies: 26
Views: 1,329
Posted By JustCruzin

Never heard of injectors increasing power. Match...

Never heard of injectors increasing power. Match the injectors to the power you have. If the stock injectors are bad you would know it in other ways, hard start, stumble, etc. Start with the basics...
Forum: C4 Tech/Performance
04-07-2011, 04:15 PM
Replies: 7
Views: 958
Posted By JustCruzin

I would stick with the 24's No improvement with...

I would stick with the 24's No improvement with the 30's unless you plan on some future mods IMO :flag:
Forum: C4 Tech/Performance
04-05-2011, 12:12 PM
Replies: 6
Views: 496
Posted By JustCruzin

:iagree: Car runs fine after it starts so I'm not...

:iagree: Car runs fine after it starts so I'm not thinking injectors. Leaking injectors would give you a hot start problem.
Forum: C4 Tech/Performance
04-04-2011, 02:20 PM
Replies: 44
Views: 3,181
Posted By JustCruzin

:iagree:

:iagree:
Showing results 1 to 25 of 47
 
Page 1 of 2
1
2


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 05:13 PM.