Search: Posts Made By: T5Mika
Showing results 1 to 25 of 345
Search took 1.70 seconds.
06-02-2023, 11:17 AM
Replies: 20
Views: 2,039
Posted By T5Mika

if you make the tune file based on the file...

if you make the tune file based on the file pulled from your PCM, it’s not detectable over OBD2. At least with hptuners the CALIDs won’t change. This applies to at least up to 2001 C5. Does not work...
05-12-2023, 02:59 PM
Replies: 13
Views: 2,570
Posted By T5Mika

UPDATE May 12, 2023: The 2001 LS1 passed smog at...

UPDATE May 12, 2023: The 2001 LS1 passed smog at a STAR station with a tune. The tune is made with HP Tuners, and based on a good file pulled out of the stock PCM. It does not seem to report CVNs,...
11-12-2021, 05:01 PM
Replies: 13
Views: 2,570
Posted By T5Mika

This is still aligned with your previous...

This is still aligned with your previous concusions about newer vehicles failing. CARB is getting CALID/CVN data for 2007 and newer directly from the manufacturers, and they 100% do check them at...
11-12-2021, 12:39 PM
Replies: 13
Views: 2,570
Posted By T5Mika

CVN is calibration verification number, i.e. a...

CVN is calibration verification number, i.e. a kind of a checksum. OBD-2 service mode #9 that is used the read the vehicle info in smog test has both in the data structure, but I have only been able...
11-04-2021, 05:48 PM
Replies: 12
Views: 1,906
Posted By T5Mika

with HP Tuners you can log pretty much everything...

with HP Tuners you can log pretty much everything on top of regular OBD-2 parameters.
about 20 something channels at a time with a reasonable sampling rate.
10-28-2021, 06:06 PM
Replies: 13
Views: 2,570
Posted By T5Mika

Does the C5 PCM even report the CVNs over OBD2?

HP Tuners shows the CVNs changing when anything in the calibration tables is touched. But when I read the PCM with Tech-2, it only shows CALIDs, which don't change with the tune.
Do these pre-2005...
09-05-2020, 02:18 PM
Replies: 1
Views: 348
Posted By T5Mika

Ttt

Still available, make an offer
11-23-2019, 09:05 PM
Replies: 1
Views: 348
Posted By T5Mika

2008 steering rack

I got a 2008 steering rack that I was going to use for a project but went to a different direction. It’s from a base coupe, 38k miles. It feels tight and I don’t see any evidence of leaks. There are...
05-22-2019, 11:26 AM
Replies: 3
Views: 6,023
Posted By T5Mika

Answering for myself: I tightened the ground...

Answering for myself: I tightened the ground point below the battery, and the idle O2 swing became normal. I had been mucking with that ground point before and probably did not tighten it enough...
05-21-2019, 11:51 AM
Replies: 3
Views: 6,023
Posted By T5Mika

O2 sensor issues

(2001 vert, auto, cam, UD pulley, tune, 57k miles)

I was getting wifs of sulphur when driving, and hooked up VCM scanner. Didn't spend much time on it, but noticed that bank 1 O2 sensor reading...
09-20-2018, 01:00 PM
Replies: 17
Views: 8,566
Posted By T5Mika

"Stock" engine with LS6 intake and '98 cam...

"Stock" engine with LS6 intake and '98 cam combination, dyno headers, no accessory drive, 101octane fuel with timing locked to 26 degrees.
SAE estimate 335 to 365hp at crank.
Forum: C5 General
09-06-2018, 11:31 AM
Replies: 7
Views: 1,010
Posted By T5Mika

Yes they flash together. I didn't actually expect...

Yes they flash together. I didn't actually expect them to, as I soldered them to the radioflyer harness white circuit, but the harness actually lights up both white and amber at the same time when...
Forum: C5 General
09-05-2018, 05:01 PM
Replies: 7
Views: 1,010
Posted By T5Mika

Those were $250, I think... But the light...

Those were $250, I think...
But the light pattern is not good and the projector swallows most of the light.
I don't almost ever drive where there's no street lights so they are for the looks only.
Forum: C5 General
09-05-2018, 02:59 PM
Replies: 7
Views: 1,010
Posted By T5Mika

Lighting updates

I played a little with my lights.

Mods:
- Clear blinker housings
- Cheapo eBay projectors
- Switchback LEDs
- Cheapo eBay LED strips (already dying, too blue).
- Hyperflash relay from...
05-24-2018, 11:55 AM
Replies: 17
Views: 2,191
Posted By T5Mika

As I mention in the original post, WB is not...

As I mention in the original post, WB is not connected in this log. You're looking at the A/C pressure sensor.
05-15-2018, 03:04 PM
Replies: 17
Views: 2,191
Posted By T5Mika

Why does spark retard vs torque reduction table...

Why does spark retard vs torque reduction table affect timing during the shift then? I can see a huge difference in shift time timing pull when I adjust this table.
05-03-2018, 04:37 PM
Replies: 17
Views: 2,191
Posted By T5Mika

You can see my cam and timing in the posts above....

You can see my cam and timing in the posts above.

I did not get any ping except during the shifts. The ping was caused by a transient condition from the torque jerk from the shift, coupled with...
04-21-2018, 05:03 PM
Replies: 17
Views: 2,191
Posted By T5Mika

Okay, so, I did a couple of things: I slowed down...

Okay, so, I did a couple of things: I slowed down the shift by 0.05, and I restored the stock spark correction tables for AFR, IAT, and ECT. The ping is gone, and no wonder, there's a significant...
04-16-2018, 05:50 PM
Replies: 17
Views: 2,191
Posted By T5Mika

Ambient 85 degrees, and IAT not much higher. I...

Ambient 85 degrees, and IAT not much higher. I direct cold air from the fog light screens to the air box. The logging run had no idling, where the IAT climbs quite bad.
04-15-2018, 09:17 PM
Replies: 17
Views: 2,191
Posted By T5Mika

Help with ping

(2001 A4, 55kmiles, Comp XR265HR-14, 25% UD, de-screened MAF, no other mods. 91 octane pump gas)

I made my own street tune with HPTuners and a WB a few months ago. I tuned the VE, MAF, spark, and...
12-14-2017, 03:06 PM
Replies: 5
Views: 1,861
Posted By T5Mika

Climate control interface reverse engineering

Has the dual zone A/C control module interface been reverse engineered? I could not find anything with quick googling.

I am starting to think of a windows carputer to replace the tape deck, and to...
12-07-2017, 04:11 PM
Replies: 21
Views: 6,466
Posted By T5Mika

Interesting stuff, isn't it? I am going through...

Interesting stuff, isn't it? I am going through exactly the same process now with LC-2 at rear bung. I got the VE almost tuned, and hoping to move to MAF this weekend. I got some false knock that's...
Forum: C5 Tech
11-13-2017, 01:59 PM
Replies: 4
Views: 2,879
Posted By T5Mika

I got a new stock radiator and thought the...

I got a new stock radiator and thought the fittings would thread out, but they were practically friction welded on and the threads broke off. The original fittings came off just fine. Unfortunately I...
Forum: C5 Tech
10-20-2017, 02:47 PM
Replies: 7
Views: 1,414
Posted By T5Mika

As an aside, I have had three racks in my car,...

As an aside, I have had three racks in my car, and all of them have had some play. The rack preload can be adjusted, and it helps for a while but will wear the rack down even faster eventually.
...
Forum: C5 Tech
10-20-2017, 02:42 PM
Replies: 34
Views: 10,272
Posted By T5Mika

I have Comp XR265HR-14 and I'm super happy with...

I have Comp XR265HR-14 and I'm super happy with the low end torque. But have an A4 and with stock TC I could not really use much more cam without other mods.
Showing results 1 to 25 of 345
 


 
Forum Jump


All times are GMT -4. The time now is 10:31 AM.