CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 18
1
2
3
11
Last »
Search: Posts Made By: Xssesive
Showing results 1 to 25 of 438
Search took 1.97 seconds.
Forum: C4 Tech/Performance
03-06-2004, 12:34 PM
Replies: 2
Views: 273
Posted By Xssesive

Re: Replacing radiator in the '84....any tips??? (s15laynrubba)

I have had to use vice grips in the past, just make sure the line doesn't start to twist when you are loosening it. Good Luck!
Forum: C4 Tech/Performance
03-06-2004, 12:29 PM
Replies: 35
Views: 5,267
Posted By Xssesive

Re: Vortex Rammer Cold Air System?? (kman0066)

I dynoed my 98 with a Vortex breather on it the first run and had 306HP, thinking the breather might be costing me HP, removed it and actually lost 6HP! That was with the car not moving! I think...
Forum: C4 Tech/Performance
03-06-2004, 04:21 AM
Replies: 17
Views: 2,076
Posted By Xssesive

Re: Descreening MAF (1985vette)

DO IT! Very easy free mod! I have done this on my 86 IROC, 87 Trans AM, and now my 86 C-4. Helps them breathe on the big end, and as long as you run an air filter the MAF internal wires will be...
Forum: C4 Tech/Performance
03-01-2004, 08:01 PM
Replies: 3
Views: 477
Posted By Xssesive

Re: Correct way to tune a modified 86 (JAKE)

No codes, sounds like the plan. THX Jake
Forum: C4 Tech/Performance
03-01-2004, 07:22 AM
Replies: 2
Views: 330
Posted By Xssesive

Re: Super Ram Gaskets? (scorp508)

thanks!
Forum: C4 Tech/Performance
03-01-2004, 12:49 AM
Replies: 9
Views: 648
Posted By Xssesive

Re: Roller Rockers (C490Vette)

Jegs or Summit have plenty to chose from. I'm pretty sure you will need taller vavle covers also. Mine did.
Forum: C4 Tech/Performance
03-01-2004, 12:41 AM
Replies: 2
Views: 330
Posted By Xssesive

Super Ram Gaskets?

Where is the best place to get new gaskets?
Forum: C4 Tech/Performance
03-01-2004, 12:39 AM
Replies: 3
Views: 357
Posted By Xssesive

Re: SUPER RAM removal info (Xssesive)

THX, just checking before I got started. Super Ram was already installed when I bought the car. I think I'm going to paint it when I get it off though.
Forum: C4 Tech/Performance
02-29-2004, 12:52 PM
Replies: 3
Views: 357
Posted By Xssesive

SUPER RAM removal info

Hey guys need to take off plenum to repair burn't vaccum lines any help would be appreciatted. THX
Forum: C4 Tech/Performance
02-28-2004, 08:20 PM
Replies: 3
Views: 710
Posted By Xssesive

OBD I or OBD 2?

Hey guys new to this scanning stuff, could somebody tell me the difference? THX
Forum: C4 Tech/Performance
02-28-2004, 03:37 AM
Replies: 3
Views: 477
Posted By Xssesive

Correct way to tune a modified 86

I recently purchased an 86 that has an Accel Super Ram, AFR Heads, and a roller cam motor. Seems to not run up to its potential, checked plugs, fuel pressure, replaced O2 sensor, and checked timing...
Forum: C4 Tech/Performance
02-20-2004, 08:38 PM
Replies: 5
Views: 377
Posted By Xssesive

Re: Almost forgot... picked up the car tonight... final dyno numbers. (MyRedC4)

Is that with a custom chip or programming? Curious, not sure if a 95 has a removable chip or not.
Forum: C4 Tech/Performance
02-15-2004, 10:11 AM
Replies: 3
Views: 344
Posted By Xssesive

Fuel Pump Relay?

I know there is a relay that provides line pressure that comes on when the key is on, not working on my car. Trying to locate and figure out the problem, having to crank the car many times to start...
Forum: C4 Tech/Performance
02-14-2004, 04:19 PM
Replies: 3
Views: 476
Posted By Xssesive

Remove catalytic converter?

My 86 has headers that flow into a single cat, should I just remove it and install a pipe in its place? Just curious to see what you guys thought. If I had dual cats I wouldn't worry about it, but...
Forum: C4 Tech/Performance
02-14-2004, 04:14 PM
Replies: 7
Views: 380
Posted By Xssesive

Re: Engine fan problems (vinnies87)

Thanks for all your help guys!
Forum: C4 Tech/Performance
02-12-2004, 10:49 PM
Replies: 7
Views: 380
Posted By Xssesive

Engine fan problems

Need help with both fans on this 86 Corvette. Neither one comes on even at temps at 232 degrees. Tried the AC on, still no response. Where is the fuse for engine fans? Can't read fuse block on...
Forum: C4 Tech/Performance
02-03-2004, 07:14 PM
Replies: 11
Views: 963
Posted By Xssesive

Re: Should you replace HEI module ? (scorp508)

Thanks for your replys.
Forum: C4 Tech/Performance
02-02-2004, 10:03 PM
Replies: 11
Views: 963
Posted By Xssesive

Should you replace HEI module ?

I recently purchased an 86 Corvette with a slightly modified motor(AFR Heads and Accel Super Ram Plenum and Runners). I bought a new dist. cap and bug for it as the other looked stock and very old. ...
Forum: C5 Tech
08-25-2003, 09:50 PM
Replies: 5
Views: 390
Posted By Xssesive

Re: Leaking transmission fluid - any other experiences? (SDVette)

If it were me I would crawl under the back and take a look see to find where the fluid is coming from. To add fluid the car has to be running and warmed up, the fluid level goes up when the car is...
Forum: C5 Tech
08-19-2003, 09:30 PM
Replies: 5
Views: 469
Posted By Xssesive

Re: cartek dynoed my 98 (howies98)

Anything over 300HP is REAL GOOD! Mine makes 326HP with mods listed below. Have fun modding!
Forum: C5 Tech
08-18-2003, 09:08 PM
Replies: 33
Views: 1,383
Posted By Xssesive

Re: Going to change plugs and wires... Which wires? (Highroller)

I know they work with the Magnecor's not sure about the others mentioned.
Forum: C5 Tech
08-18-2003, 08:47 PM
Replies: 15
Views: 899
Posted By Xssesive

Re: Stinger horsepower gain? (SpinMonster)

Not too long ago one of the vendors claimed the Stinger system was one of the few to show gains in Hp. They tested the Borla and claimed gains of 8-10Hp over stock and that it even out performed the...
Forum: C5 Tech
08-15-2003, 07:26 PM
Replies: 13
Views: 1,093
Posted By Xssesive

Re: Plugs and Wires (cporantes)

If you still have the stock wires and plugs, they will definetly help! The stock plugs lose there pucks and the stock wires were causing some misfires on an Autotap read. Don't believe GM's claim...
Forum: C5 Tech
08-15-2003, 06:57 PM
Replies: 17
Views: 1,580
Posted By Xssesive

Re: Flowmaster Mufflers Installed (mdhmi@yahoo.com)

When I had my Flowmasters if I remember right you can shim one side up with some washers using the rubber grommet they fit into. Hope this helps.
Forum: C5 Tech
08-15-2003, 06:44 PM
Replies: 5
Views: 439
Posted By Xssesive

Re: Looking for quicker throttle response..Do I need more HP? (MiamiDave)

I'm with MiamiDave on this one, you need to reprogram and adjust Torque Managment so it does't engage. It's a real killer on an A4 car. If you need more than that a 3.42 gear TC swap should really...
Showing results 1 to 25 of 438
 
Page 1 of 18
1
2
3
11
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 06:28 AM.