Search: Posts Made By: rlane5
Showing results 1 to 25 of 489
Search took 1.61 seconds.
03-07-2024, 10:18 AM
Replies: 5
Views: 231
Posted By rlane5

I did a LS swap over 10 years ago, you can still...

I did a LS swap over 10 years ago, you can still use the factory gauges as long as use the factory correct sending units. I've went from a Ls factory harness to an after market harness and ECU to a...
10-15-2023, 07:33 PM
Replies: 3
Views: 262
Posted By rlane5

Driveshaft limit

How much HP can a C4 automatic driveshaft handle
Randy
10-12-2023, 09:57 AM
Replies: 12
Views: 590
Posted By rlane5

With my 95 LBS injector, I data log a hit and ...

With my 95 LBS injector, I data log a hit and the duty cycle was 126 and the AFR was 15.0 without the TI pump. I have a Holley Terminator X max on my Vette, and in the VE table it showed that I...
10-11-2023, 02:46 PM
Replies: 12
Views: 590
Posted By rlane5

KingC6 you're going to need bigger injectors with...

KingC6 you're going to need bigger injectors with that 416 and YSI. I have a 403 with a A&A YSI with 95 LBS Deatswerk injector and an Aeromotive 340 fuel pump and was running out of injector and...
07-17-2023, 12:22 PM
Replies: 2
Views: 237
Posted By rlane5

A/C bracket

I want to buy an air conditioner bracket for a 06 Lane53099@yahoo.com
Randy
07-17-2023, 12:16 PM
Replies: 154
Views: 10,673
Posted By rlane5

How much for the A/C bracket bracket shipped to...

How much for the A/C bracket bracket shipped to 07103
Randy
07-05-2023, 02:13 PM
Replies: 16
Views: 959
Posted By rlane5

I have a 300 lbs. coil over spring, and it ride...

I have a 300 lbs. coil over spring, and it ride nice and transfer weight good, along with the right trialing arm adjustments.
Randy
06-26-2023, 02:03 PM
Replies: 16
Views: 959
Posted By rlane5

Where are the coilover located on your Vette in...

Where are the coilover located on your Vette in front or behind the rear, Will and vett383? because that makes a difference in spring rate as I'm finding out when I changed my spring mounts around....
04-04-2023, 10:51 AM
Replies: 8
Views: 1,938
Posted By rlane5

do the car have a c-beam or a cross member with...

do the car have a c-beam or a cross member with it
Randy
03-29-2023, 07:24 PM
Replies: 9
Views: 1,269
Posted By rlane5

Rob what's the length of your 9" rear, mine is...

Rob what's the length of your 9" rear, mine is 62" from rotor to rotor
Randy
03-29-2023, 02:52 PM
Replies: 9
Views: 1,269
Posted By rlane5

It depends on what you start off with, but I'd...

It depends on what you start off with, but I'd say $4000-$5000 and it depends whether you can do some of the work yourself.. I'm putting a 9'' back in my car now. I had it in my vette about 14 years...
03-29-2023, 02:09 PM
Replies: 22
Views: 1,768
Posted By rlane5

What kind of power are you making, to brake a...

What kind of power are you making, to brake a Dana 44 like that?
Randy
02-13-2022, 12:19 PM
Replies: 7
Views: 912
Posted By rlane5

Thanks for all the input, I'm putting a turbo on...

Thanks for all the input, I'm putting a turbo on the LS and I want to run E85, because its easier than Race gas, octane boost, and Meth. My son blew up his Trackhawk the last day of the track season...
02-10-2022, 09:31 AM
Replies: 7
Views: 912
Posted By rlane5

E85 86 Vette gas tank compatibility

Hi C4 Gurus' I have an 86 Vette and I want to run E85 in it, will it corrode the tank, and is the tank line. with a protective coating.. I've change the the fuel system, but did nothing with the tank...
03-07-2021, 10:54 AM
Replies: 74
Views: 4,054
Posted By rlane5

How much for the driver side pillar trim to 07103

How much for the driver side pillar trim to 07103
01-01-2021, 05:40 PM
Replies: 20
Views: 9,444
Posted By rlane5

I just had a set of 243 heads ported by Tommy,...

I just had a set of 243 heads ported by Tommy, for my C6.that I've just installed with a cam in the car this week. He also ported a set of 706 heads I have on my LS swap C4. Tommy has been doing...
10-11-2020, 04:56 PM
Replies: 19
Views: 1,013
Posted By rlane5

Before you start on a swap think about if that's...

Before you start on a swap think about if that's what you really want to do. The reason I said that is because you stated you were bored with the car and when you start a swap it can get annoying....
Forum: C5 General
04-05-2020, 11:37 AM
Replies: 87
Views: 7,025
Posted By rlane5

Nice car, and great mods. The car should and will...

Nice car, and great mods. The car should and will run, mid to low 11s in the 1/4
Randy
04-03-2020, 09:30 AM
Replies: 11
Views: 2,883
Posted By rlane5

Port the heads and a good intake, and it should...

Port the heads and a good intake, and it should go low 11s with traction
07-17-2019, 04:40 PM
Replies: 607
Views: 100,929
Posted By rlane5

use your original oil sender with a autometer...

use your original oil sender with a autometer adapter fitting as far as a temperature sender I took in to a machine shop and had it mill down and rethreaded. when you do it that way you can use your...
03-22-2019, 09:00 AM
Replies: 607
Views: 100,929
Posted By rlane5

I have a Camaro oil pan on my swap and I paid...

I have a Camaro oil pan on my swap and I paid $125 for it used with sump tube included. I original had a Corvette pan with a Batwing, but when I put the Melrose Headers on I had to change, the pan. I...
02-25-2019, 01:07 PM
Replies: 14
Views: 3,499
Posted By rlane5

When ever I'm doing ANY type of fuel replacement...

When ever I'm doing ANY type of fuel replacement or changing on a C4, I take the line loose from the gas tank. You will still have what ever is in the line, but it won't pull any more gas from the...
01-21-2019, 11:06 AM
Replies: 1
Views: 1,260
Posted By rlane5

What kind of setup do you have in you Vette. ...

What kind of setup do you have in you Vette.
Randy
01-11-2019, 11:21 AM
Replies: 15
Views: 1,700
Posted By rlane5

I have a set of M/T Drag Radials, and I get...

I have a set of M/T Drag Radials, and I get 1.5X's 60ft, and on the street tires (Sumitomo) If the track is prep, I get 1.6X's You're not far from Atco , they always prep the track.
Randy
01-11-2019, 09:26 AM
Replies: 607
Views: 100,929
Posted By rlane5

Mike is that a Fuel Pressure regulator at the...

Mike is that a Fuel Pressure regulator at the bottom of the picture?
Randy
Showing results 1 to 25 of 489
 


 
Forum Jump


All times are GMT -4. The time now is 10:10 AM.