Search: Posts Made By: hendedj
Showing results 1 to 9 of 9
Search took 1.05 seconds.
09-20-2009, 11:45 PM
Replies: 1
Views: 743
Posted By hendedj

Coolant temp sender wiring

I have a 1986 that the previous owner unhooked the coolant temp sensor. This is the one that is on the engine block passenger side that sends the signal for the dash gauge. They have unhooked the...
08-28-2009, 11:50 PM
Replies: 0
Views: 241
Posted By hendedj

Latch lever pin

I have a 1986 vert. The drivers side front latch for the top rattles when I go over bumps. I found the reason why is the bushing(?) that the latch lever pin goes into the two round protrusions that...
08-24-2009, 09:21 PM
Replies: 5
Views: 534
Posted By hendedj

Followed the procedure for adjusting the TV...

Followed the procedure for adjusting the TV cable. It now shifts 1-2 at about 16-18, 2-3 at about 25-27, and 3-OD at about 45-49 all depending on how deep I get into the throttle. Thanks again for...
08-23-2009, 11:57 PM
Replies: 5
Views: 534
Posted By hendedj

Thanks to all, you headed me in the right...

Thanks to all, you headed me in the right direction. The tranny is also shifting between first and second too quickly. After reading your posts I found this helpful link on adjusting the TV cable ona...
08-23-2009, 04:10 PM
Replies: 5
Views: 534
Posted By hendedj

Overdrive performance

I bought my first Corvette about a month ago. I purchased a 1986 convertible with 39,000 miles on it. I decided to take it out on the road this weekend. The automatic transmission shifts into...
08-15-2009, 09:43 AM
Replies: 6
Views: 3,089
Posted By hendedj

Thanks everyone for the information. I may just...

Thanks everyone for the information. I may just do it. I like a challenge:)
08-15-2009, 01:08 AM
Replies: 12
Views: 2,688
Posted By hendedj

I have an 86 and have the chance to buy a 90...

I have an 86 and have the chance to buy a 90 hardtop that has been in storage for 20 years. What would I have to do to make it fit?
08-15-2009, 12:48 AM
Replies: 6
Views: 3,089
Posted By hendedj

Thanks, I will look for the thread. I had done...

Thanks, I will look for the thread. I had done some research and found the latch levers and pins that a soft top uses. The levers are $119ea and the latch pins are $113ea. I just am not sure if this...
08-14-2009, 09:10 PM
Replies: 6
Views: 3,089
Posted By hendedj

C4 Removable Hardtop

I have the opportunity to buy a removable hardtop from an 89 for my 86. I have heard that these hardtops are interchangeable between any C4. My soft top has latch levers with pins. The hard top I am...
Showing results 1 to 9 of 9


 
Forum Jump


All times are GMT -4. The time now is 04:31 PM.