CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 6
1
2
3
Last »
Search: Posts Made By: infinity4life
Showing results 1 to 25 of 145
Search took 1.28 seconds.
Forum: C5 General
10-13-2009, 02:51 AM
Replies: 20
Views: 2,342
Posted By infinity4life

The genius who designed my oil pan (Canton) on my...

The genius who designed my oil pan (Canton) on my cobra put a front and rear sump on it, so I get to jack up the rear, let the front drain, then jac up the front and let the rear drain. Lol - thank...
Forum: C5 General
10-12-2009, 07:28 PM
Replies: 38
Views: 1,157
Posted By infinity4life

If you can figure out how to remove them after...

If you can figure out how to remove them after sticking them in (without jamming a screw driver and forcing them out), you're a smarter man than i :D
Forum: Canadian Events
10-12-2009, 03:18 PM
Replies: 27
Views: 842
Posted By infinity4life

no and no (only mommy & daddy *sucks on thumb* )...

no and no (only mommy & daddy *sucks on thumb* ) =)

Okay, now that it's Monday I will say '"Happy Thanksgiving' :D :lol:
Forum: Canadian Events
10-12-2009, 03:10 PM
Replies: 40
Views: 1,653
Posted By infinity4life

:thumbs: When I finally get rid of my daily...

:thumbs:

When I finally get rid of my daily driver (g35 coupe) I'll be replacing it with a c6 coupe as my daily (including winter) beater - cheap insurance, great mpg, cheap to repair...
Forum: C5 General
10-12-2009, 02:30 AM
Replies: 22
Views: 1,254
Posted By infinity4life

Just keep pouring techron (or similar) additive...

Just keep pouring techron (or similar) additive into the tank; it will eventually fix itself. Also, a lot of times (but not all) if you drive around for a few days (no techron or anything added), it...
Forum: C5 General
10-12-2009, 02:27 AM
Replies: 38
Views: 1,157
Posted By infinity4life

BMW pucks here for a year, and they havn't backed...

BMW pucks here for a year, and they havn't backed out. I even tried to remvoe 1 once and couldn't figure out HTF to do it for the life of me. They're in there good. :willy:
Forum: C5 General
10-12-2009, 02:26 AM
Replies: 36
Views: 1,179
Posted By infinity4life

Nothing - these cars arn't exactly from 1970...

Nothing - these cars arn't exactly from 1970 anymore, where if you break down on the side of the road, chances are you could fix it with a screwdriver and wrench.
Forum: Canadian Events
10-11-2009, 03:52 PM
Replies: 27
Views: 842
Posted By infinity4life

Thanksgiving is Monday, not Sunday? :confused:

Thanksgiving is Monday, not Sunday? :confused:
Forum: C5 General
10-11-2009, 03:08 AM
Replies: 25
Views: 18,904
Posted By infinity4life

When you guys talk about the stock shifter not...

When you guys talk about the stock shifter not being precise, what do you mean? Also, how can you be missing 3rd (??the shifter centers over 3/4??)

I'm nowhere near a competent manual driver, but...
Forum: C5 General
10-11-2009, 03:05 AM
Replies: 43
Views: 3,153
Posted By infinity4life

Illegal street race in progress? :toetap:

Illegal street race in progress? :toetap:
Forum: C5 General
10-11-2009, 03:03 AM
Replies: 35
Views: 10,009
Posted By infinity4life

I drove around ~2yrs lowered max on stock bolts....

I drove around ~2yrs lowered max on stock bolts. i could usually angle-creep over most (not all) speedbumps, but every so often my cats or headers would WHACK against them going over. Got some good...
Forum: Canadian Events
10-11-2009, 01:29 AM
Replies: 40
Views: 1,653
Posted By infinity4life

Me too - markets havn't been too kind to me this...

Me too - markets havn't been too kind to me this year, so I had to go with a less-motorized version. Hopefully Co-Op has sled parking stalls available this year.
...
Forum: C5 Forced Induction/Nitrous
10-09-2009, 08:09 PM
Replies: 30
Views: 1,929
Posted By infinity4life

Stupid question since I don't know much...

Stupid question since I don't know much (anything) About engine building - how much $$$ would it take to have a complete engine pushing around 600RWhp with that block?
Forum: Canadian Events
10-09-2009, 02:22 PM
Replies: 40
Views: 1,653
Posted By infinity4life

Okay, I'll admit it - it's now fricken cold...

Okay, I'll admit it - it's now fricken cold outside! :willy:
Forum: Canadian Events
10-08-2009, 01:16 AM
Replies: 40
Views: 1,653
Posted By infinity4life

I don't think it was that cold today - moreover...

I don't think it was that cold today - moreover just a total mind f*k - one minute it's snowing, next minute it's sunny, next minute it's snowing again.

Supposed to be -20* (low) on Friday though...
Forum: Canadian Events
10-07-2009, 06:49 PM
Replies: 124
Views: 11,734
Posted By infinity4life

The runway with the ram does weigh a crap-ton....

The runway with the ram does weigh a crap-ton. When I set mine up, i did it with myself, my dad (70), and my engine hoist. basically scooted the runway ramps around with the hoist to get them into...
Forum: Canadian Events
10-07-2009, 06:47 PM
Replies: 8
Views: 512
Posted By infinity4life

All garage doors have a manual type of emergy...

All garage doors have a manual type of emergy release so you can take it off the chain and lift/close the door manually. There should be some red cord dangling somewhere.
Forum: C6 Tech/Performance
10-07-2009, 01:54 PM
Replies: 13
Views: 4,954
Posted By infinity4life

Shooting for a bit more than stock :leaving:

Shooting for a bit more than stock :leaving:
Forum: C6 Tech/Performance
10-06-2009, 03:40 PM
Replies: 13
Views: 4,954
Posted By infinity4life

Good to cover all grounds :lol: Btw,...

Good to cover all grounds :lol:

Btw, speaking of ignition, how exactly does that work with an LS engine? I see there's something called an ignition controller, but it comes with stuff like MAF, 02...
Forum: C6 Tech/Performance
10-06-2009, 03:17 PM
Replies: 13
Views: 4,954
Posted By infinity4life

I know that's the theory (and at these hp levels,...

I know that's the theory (and at these hp levels, who really cares about MPG, hehe), but I have no idea if the same concepts apply with a modern engine like an LS. (this may be a stupid...
Forum: C6 Tech/Performance
10-06-2009, 01:42 PM
Replies: 13
Views: 4,954
Posted By infinity4life

It's going into my superlite (havn't received...

It's going into my superlite (havn't received mine yet, but it looks like the one on the right (not the left ;) ) )
http://i708.photobucket.com/albums/ww89/efnfast/slc1.jpg


In terms of power,...
Forum: C6 Tech/Performance
10-06-2009, 12:46 AM
Replies: 13
Views: 4,954
Posted By infinity4life

:willy:

:willy:
Forum: C6 Tech/Performance
10-05-2009, 04:30 PM
Replies: 13
Views: 4,954
Posted By infinity4life

Question about doing a carb'd LS3

If you have an LS3 bare black and wanted to build it up to 700-800hpish, in the end would it be more effective (in terms of cost, reliability, and power) to use a carb or go EFI?

The past car...
Forum: Car Care Discussion
10-05-2009, 12:47 PM
Replies: 23
Views: 1,942
Posted By infinity4life

I think I'm spending too much time on autpia -...

I think I'm spending too much time on autpia - while I do agree it's harder to see them than swirls, I'm more than hilling to tilt my head at every angle, while holding a brinkman and sun gun, to...
Forum: C5 General
10-05-2009, 12:37 PM
Replies: 15
Views: 1,121
Posted By infinity4life

Oh, I know i'm not slammed by any means. I did...

Oh, I know i'm not slammed by any means. I did try removing the front bolts for the hell of it, which left me at just a hair over 25 1/2'', but after I scrapped going up my 4post lift and banged the...
Showing results 1 to 25 of 145
 
Page 1 of 6
1
2
3
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 06:18 PM.