Search: Posts Made By: cam355aro
Showing results 1 to 25 of 136
Search took 1.14 seconds.
11-08-2009, 02:02 AM
Replies: 0
Views: 318
Posted By cam355aro

WTB 1984 Factory Service Manual

Looking to buy a 1984 Corvette Factory Service Manual. Anyone have one for sale? Contact me best by email or simply reply or PM me.

Thanks.
11-07-2009, 10:06 PM
Replies: 9
Views: 666
Posted By cam355aro

Have you removed the thermostat or someone...

Have you removed the thermostat or someone previously before you? If so, you will not get the heat you desire. To check, if you temperature is not getting up past 150 or so, you need to get one.
11-07-2009, 06:50 PM
Replies: 2
Views: 378
Posted By cam355aro

Heres to the start of diagnosing my problem: ...

Heres to the start of diagnosing my problem:

1. Checked to see if it is throwing a code, none.
2. Double checked all spark plug wires, all tight and away from heat.

My next step is to check...
11-07-2009, 04:47 PM
Replies: 2
Views: 378
Posted By cam355aro

Car is running like ****

My car ran perfectly fine, until.....

First noticed when I had the transmission rebuilt. The only change that was made was the transmission. The outer insulation for the tv cable is worn off in...
10-17-2009, 12:59 AM
Replies: 3
Views: 592
Posted By cam355aro

bump

bump
10-16-2009, 04:03 PM
Replies: 3
Views: 592
Posted By cam355aro

Everything of the two units are the exact same...

Everything of the two units are the exact same except the pumps and the two things I circled in the picture. I mainly just want to know what the things is in the blue circle in the picture. (the...
10-16-2009, 03:01 PM
Replies: 3
Views: 592
Posted By cam355aro

Pics! Sending Unit Differences --- Help!!

So the sending unit in the picture is originally out of a 1986 corvette, that I am preparing to put into my 1984. I have changed the fuel pump out for the 1984 fuel pump and now I am stumped on the...
10-14-2009, 07:39 PM
Replies: 4
Views: 395
Posted By cam355aro

C4 Dash HELP!!!

Can someone post a picture of what the gas guage should look like with an empty tank on an early C4. The last of the three gas gauge bars are not disappearing when the lever is all the way down....
10-08-2009, 08:26 PM
Replies: 26
Views: 2,888
Posted By cam355aro

To Frizlefrak...or anyone who knows The...

To Frizlefrak...or anyone who knows

The sending unit's float arm's contact that touches the windings; what is it supposed to look like? Mine is about a 1/4 inch too short to touch the windings,...
10-08-2009, 08:10 PM
Replies: 26
Views: 2,888
Posted By cam355aro

My guess is that the float level is stuck all the...

My guess is that the float level is stuck all the way up. You will see what I am talking about if you look down at it while you lift the unit out. Make sure that the level is all the way pushed...
10-07-2009, 04:36 PM
Replies: 5
Views: 1,359
Posted By cam355aro

So I got the ribbon from GM and removed the old...

So I got the ribbon from GM and removed the old broken ribbon out of the housing. When I install the new ribbon, it will run up and down but then slip out of the inside spool and cease to work. ...
10-06-2009, 05:35 PM
Replies: 26
Views: 2,888
Posted By cam355aro

Fuel tank sending unit

I am looking for a fuel tank sending unit for a 1984 Corvette. I do not need the fuel pump or strainer along with the sending unit because that has been replaced recently. I would greatly...
10-06-2009, 05:25 PM
Replies: 0
Views: 287
Posted By cam355aro

WTB - 1984 fuel tank sending unit

I need a fuel tank sending unit for a 1984 corvette. If anyone knows a place for a good deal, that would help too. Post here or send me a message on details. Thanks.
10-06-2009, 04:46 PM
Replies: 5
Views: 1,359
Posted By cam355aro

Power Antenna Rebuild

I have a 1984 and I removed the power antenna because it would no longer go up and down. I have a few questions though...

It has the tubular rivets (hole in the center) that rivet the motor...
09-17-2009, 11:14 PM
Replies: 3
Views: 486
Posted By cam355aro

Power antenna malfunctions/replacing

I plan on replacing the power antenna on my 1984 corvette. The mast looks slightly bent, but hardly noticeable unless you look directly down on it. The antenna itself will only go down about half...
07-28-2009, 05:50 PM
Replies: 13
Views: 1,617
Posted By cam355aro

I need some bearings for my 84 as well. Any...

I need some bearings for my 84 as well. Any deals going on right now?
05-26-2009, 09:38 AM
Replies: 2
Views: 424
Posted By cam355aro

ttt

ttt
05-26-2009, 02:12 AM
Replies: 2
Views: 424
Posted By cam355aro

Air Conditioning Compressor

On the back of the Air Conditioning Compressor, there is the electrical connector that plugs into the back. After pulling the connector out, there is a fitting that screws into the back of the...
05-25-2009, 09:55 PM
Replies: 81
Views: 23,812
Posted By cam355aro

I don't understand why the converter kits they...

I don't understand why the converter kits they sell only have the high and low pressure fittings and the refrigerant if you need to replace all of this other stuff. It seems like every year I have...
05-25-2009, 09:01 PM
Replies: 81
Views: 23,812
Posted By cam355aro

Ok so lets recap. After some research and...

Ok so lets recap.

After some research and reading everyone's replys, I am going to have to get:

- a new drier
- a new orifice tube
- new fittings and O-rings
- flush out and change the oil...
05-25-2009, 06:44 PM
Replies: 81
Views: 23,812
Posted By cam355aro

Calling all Air Conditioning Gurus!

I was completely out of refrigerant in my 84 and the gf wanted some cool air blowing. I had opened up the lines at one point and let all of the refrigerant out and I am sure had the lines full of...
05-25-2009, 01:09 AM
Replies: 33
Views: 17,748
Posted By cam355aro

Both my camaro and corvette do this, if you mean...

Both my camaro and corvette do this, if you mean the loud clunk is like a jerk when putting it into gear. I thought this was just normal for older chevrolets or at least the 700r4s?
05-23-2009, 01:45 AM
Replies: 22
Views: 966
Posted By cam355aro

Total investments

I was curious to how much I had invested into the vette so I decided to create a spreadsheet earlier today. I got all of my receipts and added them all up...

Including the base price of 3,400......
05-22-2009, 01:03 AM
Replies: 4
Views: 519
Posted By cam355aro

Do you mean as soon as you they flip, they delay....

Do you mean as soon as you they flip, they delay. Or are you saying in the process of them flipping, they hit a delay midway?

I had this same problem and fixed it easily (midway flip would get...
05-22-2009, 12:55 AM
Replies: 59
Views: 3,234
Posted By cam355aro

Do you have lights in the fender scoops or is...

Do you have lights in the fender scoops or is that just how bright the lights are? If so, post some pics of your installation there please.
Showing results 1 to 25 of 136
 


 
Forum Jump


All times are GMT -4. The time now is 06:25 PM.