CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: navy_vette
Showing results 1 to 25 of 493
Search took 1.17 seconds.
Forum: C4 Parts for Sale/Wanted
09-13-2018, 04:29 PM
Replies: 4
Views: 644
Posted By navy_vette

No, but it's really close to that part. It...

No, but it's really close to that part. It actually sits on it. If you were to remove the cancel cam, it sits right behind it.

Probably would have been easier if I took a picture, huh...

That,...
Forum: C4 Parts for Sale/Wanted
08-23-2018, 11:00 PM
Replies: 4
Views: 644
Posted By navy_vette

Indicator cancel plate

If anything, I'm looking for a place to buy the party because it's a tiny little thing and I can't find it anywhere.

Suddenly, I couldn't turn off my left blinker. Steering cancel didn't work and...
Forum: C4s for Sale/Wanted
05-11-2015, 04:58 PM
Replies: 1
Views: 1,043
Posted By navy_vette

Bump. No takers? Well, I hope I can give her a...

Bump.
No takers? Well, I hope I can give her a new home before I have to store it...
Forum: C4s for Sale/Wanted
05-01-2015, 02:53 PM
Replies: 1
Views: 1,043
Posted By navy_vette

1991 Coupe Auto

127,000 miles (<8,000 since the new engine was put in)

I have had her since early 2007 and I've had a blast. But, it's time to let her go. On to the next project. That, and the good old United...
Forum: C4 Tech/Performance
12-21-2014, 02:42 AM
Replies: 15
Views: 1,031
Posted By navy_vette

I'll test out the MAP. I have a vacuum test gun....

I'll test out the MAP. I have a vacuum test gun. I didn't even think about checking the resistance on the MAP while using the tester. Great idea! The MAP is holding vacuum, but I don't know if it is...
Forum: C4 Tech/Performance
12-20-2014, 05:15 PM
Replies: 15
Views: 1,031
Posted By navy_vette

DOUBLE POST I know, it's annoying... but......

DOUBLE POST

I know, it's annoying... but... I did the test I should have done from the beginning. I threw a multimeter against the Throttle Position Sensor. Open. Completely open. So, the computer...
Forum: C4 Tech/Performance
12-20-2014, 02:12 PM
Replies: 15
Views: 1,031
Posted By navy_vette

I'll have to look at putting that tape on the...

I'll have to look at putting that tape on the balancer. Looks very useful. Then again, getting it on isn't easy, I'm sure.

So, I did basic maintenance, just to be sure, and took some steps to...
Forum: C4 Tech/Performance
12-12-2014, 10:43 AM
Replies: 15
Views: 1,031
Posted By navy_vette

I don't have a logger, but my mechanic does. I...

I don't have a logger, but my mechanic does. I already talked to him about doing by today, but I will have to wait for this rain to stop. I'm on San Diego and it is pretty insane right now. I'll also...
Forum: C4 Tech/Performance
12-10-2014, 02:48 PM
Replies: 15
Views: 1,031
Posted By navy_vette

Very strange timing issue

1991 with ZZ4, Miniram, Stage 3 TPIS tune, Miniram, Edelbrock heads.

This is freaking me out. I started getting misses and bumbling under load. When accelerating, it starts. It happens across...
Forum: C4 Tech/Performance
09-16-2014, 03:25 AM
Replies: 12
Views: 1,483
Posted By navy_vette

That is exactly what I need. Thank you very much.

That is exactly what I need. Thank you very much.
Forum: C4 Tech/Performance
09-15-2014, 06:55 PM
Replies: 12
Views: 1,483
Posted By navy_vette

I found out what the issue was. I wired a 10...

I found out what the issue was. I wired a 10 gauge jumper from pin-30 (primary power) on the starter allow relay to the start pin on the starter itself. She started up with zero issue. No delay, no...
Forum: C4 Tech/Performance
09-13-2014, 07:26 PM
Replies: 12
Views: 1,483
Posted By navy_vette

Cliff, Did the ECM drop power when this...

Cliff,

Did the ECM drop power when this happened? I've been getting other replies involving the batter cable, so it is something I will try.
Correct me if I am wrong, but doesn't the primary +...
Forum: C4 Tech/Performance
09-13-2014, 01:02 AM
Replies: 12
Views: 1,483
Posted By navy_vette

Strange electrical issue

Well, I'll start with what is happening and then tell the story.

Key on works normally. My fans are constant on. Everything works. I turn the key to start, a loud click possibly from the ECM and...
Forum: C4 Tech/Performance
09-07-2014, 03:44 AM
Replies: 2
Views: 389
Posted By navy_vette

Harness installation

I know there are plenty of posts related to this and I have searched them, but I haven't really gotten the answer.

Should I pull the engine to remove and install a new/refurbished wiring harness,...
Forum: C4 Tech/Performance
08-24-2013, 11:51 AM
Replies: 19
Views: 917
Posted By navy_vette

Causes of high idle: Vacuum leak - Sucking...

Causes of high idle:
Vacuum leak - Sucking sound.
Bad IAC valve - It's a vacuum leak. You'll hear it.
Low Fuel Pressure/bad injectors - running lean
Junk Throttle Position Sensor - I believe the...
Forum: C4 Tech/Performance
08-24-2013, 11:47 AM
Replies: 9
Views: 1,706
Posted By navy_vette

Drone is annoying, but it's something that really...

Drone is annoying, but it's something that really isn't that big of a deal.

The "performance" pipe is probably just bigger with smoother bends. Unless the one you have currently is rusted out, out...
Forum: C4 General Discussion
07-16-2013, 04:01 PM
Replies: 127
Views: 4,953
Posted By navy_vette

Well, you need 3 things for you motor to run...

Well, you need 3 things for you motor to run correctly (well, mainly at least...)
Air : Dirty plenum - It's easy to take off the throttle body, but make sure you have the gaskets ready to go....
Forum: C4 General Discussion
07-09-2013, 03:02 PM
Replies: 11
Views: 1,693
Posted By navy_vette

Pull codes If the voltage regulator on the...

Pull codes

If the voltage regulator on the alternator is going bad it can fry your battery as well as cause a multitude of other problems. I would guess that the problem has something to do with...
Forum: C4 Tech/Performance
07-09-2013, 02:54 PM
Replies: 25
Views: 1,605
Posted By navy_vette

Blue smoke is oil White smoke is coolant ...

Blue smoke is oil
White smoke is coolant
black smoke is too much fuel (rich)

Stem seals are your most likely culprit. Not simple, but not the most difficult or expensive thing ever to fix. It's...
Forum: C4 Tech/Performance
07-09-2013, 02:41 PM
Replies: 16
Views: 5,425
Posted By navy_vette

Welcome to the forum! Yes, an FSM is almost...

Welcome to the forum!

Yes, an FSM is almost required when doing work on these cars. The repair manuals from places like Chilton's can help, but the service manual will tell you just about...
Forum: C4 General Discussion
07-05-2013, 01:25 AM
Replies: 41
Views: 2,392
Posted By navy_vette

Congrats and welcome to the Forum! Post some...

Congrats and welcome to the Forum!
Post some pictures!

Does anyone else find it mildly hilarious that whenever someone posts that they are about to get their first C4 that we all start posting...
Forum: C4 General Discussion
07-05-2013, 01:21 AM
Replies: 16
Views: 945
Posted By navy_vette

Well.......I guess I know what I will be doing...

Well.......I guess I know what I will be doing this weekend......

Looks great!
Forum: C4 Parts for Sale/Wanted
07-05-2013, 01:18 AM
Replies: 2
Views: 538
Posted By navy_vette

Done..... That was quicker than I thought it...

Done.....
That was quicker than I thought it would be.

Thanks CF :D
Forum: C4 Tech/Performance
07-05-2013, 12:58 AM
Replies: 14
Views: 2,205
Posted By navy_vette

:iagree: The old Multecs don't seem to like the...

:iagree:
The old Multecs don't seem to like the cool new fuels we use these days. Mine went out pretty hard and it's fairly common. No real use trying to clean them.

I would just go ahead and do...
Forum: C4 Tech/Performance
07-05-2013, 12:43 AM
Replies: 14
Views: 2,405
Posted By navy_vette

New shells are definately much easier. However,...

New shells are definately much easier. However, if the contacts themselves are junk, then you have to replace those as well. Make sure the shells come with new contacts. And even on that same point,...
Showing results 1 to 25 of 493
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 10:30 PM.