CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 8
1
2
3
Last »
Search: Posts Made By: thiatt
Showing results 1 to 25 of 176
Search took 1.18 seconds.
Forum: C3 Tech/Performance
05-05-2013, 11:54 PM
Replies: 11
Views: 2,712
Posted By thiatt

I agree it'll still be a dog with the stock heads...

I agree it'll still be a dog with the stock heads and cam. The stock stuff falls out real early in low 4000 rpm range. You'll hardly notice the difference. Not worth the effort.
Forum: C3 Tech/Performance
01-31-2013, 11:23 PM
Replies: 8
Views: 1,116
Posted By thiatt

Thanks for the advice I think I will. The Vette...

Thanks for the advice I think I will. The Vette could use a pro set up too it works but probably be better if some that really knew what they are doing did it:lol:
Forum: C3 Tech/Performance
01-31-2013, 11:12 PM
Replies: 8
Views: 1,116
Posted By thiatt

Thanks Mike the van part is what I needed. How'd...

Thanks Mike the van part is what I needed. How'd you figure that part out?
Forum: C3 Tech/Performance
01-31-2013, 10:49 PM
Replies: 8
Views: 1,116
Posted By thiatt

Qjet id lars please

Its stamped 7045218 yn 2754. What the heck is this off of? Trying to get rebuild kit and all the parts stores systems are so dumb they can't find it. Its on my new 67' impala 327 ci now. I check thru...
Forum: C3 Tech/Performance
12-17-2012, 10:29 PM
Replies: 60
Views: 2,445
Posted By thiatt

Almost everyone has a childhood dream about these...

Almost everyone has a childhood dream about these cars, with that dream you just have to accept the fact you will occasionally ride home with the tow truck driver.
Forum: C3 Tech/Performance
12-17-2012, 10:19 PM
Replies: 73
Views: 4,410
Posted By thiatt

Not sure about mpg but the fuel gauge drops half...

Not sure about mpg but the fuel gauge drops half as fast as the tac goes up ha ha ha ha
Forum: C3 Tech/Performance
09-25-2012, 11:14 PM
Replies: 20
Views: 6,375
Posted By thiatt

P.s all this info is about early 77's, which have...

P.s all this info is about early 77's, which have alarm key switch in fender, late 77's combined door lock and alarm switch. If thats your case it's all different. Fuse link A feeds all except light...
Forum: C3 Tech/Performance
09-25-2012, 10:48 PM
Replies: 20
Views: 6,375
Posted By thiatt

Looking more at ETM, fuse link B is tapped in...

Looking more at ETM, fuse link B is tapped in below master cylinder.it's a setup of four connectors single wire closest to wheel side on back of fuse block is going to fuse link B single wire on...
Forum: C3 Tech/Performance
09-25-2012, 10:28 PM
Replies: 20
Views: 6,375
Posted By thiatt

You've got a good short witch fuse link is...

You've got a good short witch fuse link is blowing? If it's A it's running blower relay head lights then goes to alt on two red wires. Between blower relay and alt fuse link B taps in. this feeds...
Forum: C3 Tech/Performance
09-25-2012, 09:32 PM
Replies: 11
Views: 741
Posted By thiatt

I take the driver seat out when working in this...

I take the driver seat out when working in this area. Makes it comfy lay on your back throw legs up in cargo area.
Forum: C3 Tech/Performance
09-10-2012, 09:45 PM
Replies: 14
Views: 2,581
Posted By thiatt

I would also check ignition. A failing coil will...

I would also check ignition. A failing coil will stop working when heated, when it cools it will work fine.

You can test a coil at home its easy. All you need is a multimeter with ohm meter, and a...
Forum: C3 Tech/Performance
09-10-2012, 09:07 PM
Replies: 24
Views: 1,684
Posted By thiatt

Oh man, I haven't laughed that hard in a long...

Oh man, I haven't laughed that hard in a long time. You guys terrible.
Forum: C3 Tech/Performance
09-03-2012, 06:54 PM
Replies: 8
Views: 17,552
Posted By thiatt

Then quick put the plug in before the sh%#'s...

Then quick put the plug in before the sh%#'s everywhere. Ha ha ha
Forum: C3 Tech/Performance
08-13-2012, 08:50 PM
Replies: 27
Views: 7,730
Posted By thiatt

Also check to see if bubba wired the choke ahead...

Also check to see if bubba wired the choke ahead of the ignition switch. This would take a few days on a good battery, but a half dead one would go over night.
Forum: C3 Tech/Performance
08-06-2012, 09:15 PM
Replies: 25
Views: 3,101
Posted By thiatt

I agree remove ignition switch,and touch purple...

I agree remove ignition switch,and touch purple and white to any red. If it turns over consistently, it's the ignition switch if not it's a connection. First one is at bottom of d steering column....
Forum: C3 Tech/Performance
08-04-2012, 09:53 PM
Replies: 13
Views: 1,436
Posted By thiatt

Double check that car is level or slightly lower...

Double check that car is level or slightly lower in rear.
Forum: C3 Tech/Performance
07-29-2012, 09:31 PM
Replies: 7
Views: 675
Posted By thiatt

The vac line to tranny is disconneted or leaking...

The vac line to tranny is disconneted or leaking is my guess. Causes hard shift vac leaks cause stalls.
Forum: C3 Tech/Performance
07-27-2012, 10:33 PM
Replies: 18
Views: 1,209
Posted By thiatt

The rings on side of cb are lock releases. ...

The rings on side of cb are lock releases. Squeeze them toward the cb and pull.
Forum: C3 Tech/Performance
07-27-2012, 06:43 PM
Replies: 6
Views: 2,031
Posted By thiatt

If none of these fix it use remote trigger...

If none of these fix it use remote trigger starter, or jump solenoid on starter to see if it will start every time. If so start checking connections under dash see if loose. They are on steering...
Forum: C3 Tech/Performance
07-24-2012, 10:08 PM
Replies: 30
Views: 1,353
Posted By thiatt

I use chain hoist hung from ceiling, then roll...

I use chain hoist hung from ceiling, then roll chaise out from under motor.
Forum: C3 Tech/Performance
07-24-2012, 09:39 PM
Replies: 12
Views: 765
Posted By thiatt

I would plug the vac line if cruise system won't...

I would plug the vac line if cruise system won't turn off even with switch off it's a l leak cause issue with idle
Forum: C3 Tech/Performance
07-24-2012, 08:58 PM
Replies: 28
Views: 3,433
Posted By thiatt

I also think rebuild went wrong get vacuum...

I also think rebuild went wrong get vacuum diagram make sure all lines are connected in proper place some ports are timed. I also agree about sounds, like vac leak...but float improper set or float...
Forum: C3 Tech/Performance
07-24-2012, 08:50 PM
Replies: 28
Views: 3,433
Posted By thiatt

Passenger side linkage is for choke lockout lots...

Passenger side linkage is for choke lockout lots of people took those off thinking it was a performance enhancement.
Forum: C3 Tech/Performance
07-23-2012, 09:22 PM
Replies: 14
Views: 2,032
Posted By thiatt

Seeing an open dash panel brings back nightmares...

Seeing an open dash panel brings back nightmares make it go away;(
Forum: C3 Tech/Performance
07-23-2012, 08:43 PM
Replies: 4
Views: 541
Posted By thiatt

Might be a loose pinion flange bolt or worn...

Might be a loose pinion flange bolt or worn pinion bairing. Or brake rotor warped with slightly sticking calipers
Showing results 1 to 25 of 176
 
Page 1 of 8
1
2
3
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 12:55 AM.