CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: Churchkey
Showing results 1 to 25 of 497
Search took 1.30 seconds.
Forum: C4 Tech/Performance
10-19-2019, 09:33 AM
Replies: 13
Views: 1,417
Posted By Churchkey

There is a procedure in the shop manual to set...

There is a procedure in the shop manual to set base idle = access to the throttle stop may be required.
Forum: C4 Tech/Performance
10-17-2019, 08:38 PM
Replies: 13
Views: 1,417
Posted By Churchkey

Look @ the boss on intake plenum @ the throttle...

Look @ the boss on intake plenum @ the throttle stop, on the back side of the boss you will see a very small cup plug that covers the throttle stop screw adjustment. To remove the plug use an awl,...
Forum: C4 Tech/Performance
09-10-2019, 09:06 PM
Replies: 26
Views: 3,311
Posted By Churchkey

Adding an external star washer & a ground wire to...

Adding an external star washer & a ground wire to each frame sensor helped my 90 but the right sensor went bad 6 months later they happen to be mounted under the AC evaporator = water. 90 frame...
Forum: C4 Tech/Performance
08-05-2019, 08:28 AM
Replies: 5
Views: 1,353
Posted By Churchkey

For easy access to RS plugs remove the rear...

For easy access to RS plugs remove the rear plastic inner wheel house (5 min) then use an extension & swivel plug socket.
Forum: C4 Tech/Performance
07-26-2019, 09:07 PM
Replies: 2
Views: 570
Posted By Churchkey

I like 1/8" high on the left side car should end...

I like 1/8" high on the left side car should end up level with driver seated.
Forum: C4 General Discussion
07-18-2019, 09:09 PM
Replies: 19
Views: 2,352
Posted By Churchkey

A member that lives in another country may see...

A member that lives in another country may see this thread & need my item if so then the Con US shipping disclosure eliminates international shipping.
Your information only applies if shipping PO...
Forum: C4 General Discussion
07-18-2019, 06:18 PM
Replies: 19
Views: 2,352
Posted By Churchkey

I have a good operational hatch latch if needed...

I have a good operational hatch latch if needed 40.00 includes Con US shipping. PM if interested.
BTW the solenoid is in the latch.
Forum: C4 General Discussion
07-14-2019, 09:19 PM
Replies: 3
Views: 650
Posted By Churchkey

Thanks, changed it.

Thanks, changed it.
Forum: C4 General Discussion
07-14-2019, 08:54 PM
Replies: 3
Views: 650
Posted By Churchkey

View the C8 7-18 @ 7:30PT

The livestream, scheduled for July 18 at 7:30 p.m. PT, will be shared on https://media.chevrolet.com/media/us/en/chevrolet/next-gen-corvette.html special...
Forum: C4 General Discussion
07-10-2019, 09:21 PM
Replies: 47
Views: 7,532
Posted By Churchkey

This show was just another DIY hack job my...

This show was just another DIY hack job my minimal interest was lost when they relocated the battery to the cockpit
instead of scoring the correct size battery.

I'm thanking Mother Nature & a new...
Forum: C4 Tech/Performance
06-22-2019, 07:57 AM
Replies: 7
Views: 1,077
Posted By Churchkey

Same here initially they were a PITA they would...

Same here initially they were a PITA they would get kicked & not stay in place when exiting the vehicle.
Velcro was my fix.
Forum: C4 Tech/Performance
05-10-2019, 01:33 PM
Replies: 9
Views: 1,354
Posted By Churchkey

What biankuski said... Stock exhaust...

What biankuski said...

Stock exhaust manifolds are a choke point as well as the TPI intake.

Suggest headers first then address the intake.
Forum: C4 Tech/Performance
04-10-2019, 08:30 AM
Replies: 9
Views: 2,600
Posted By Churchkey

Quick way to tell the difference between 12" or...

Quick way to tell the difference between 12" or 13" rotors look @ the front rotor thickness.

12" rotor is .72 thick.

13" rotor is 1.04 thick.
Forum: C4 Tech/Performance
04-09-2019, 06:50 PM
Replies: 5
Views: 849
Posted By Churchkey

90 right side radiator fan is controlled by AC...

90 right side radiator fan is controlled by AC high side pressure simply connect the fan relay ground wires together both fans will run when AC is in use or 228* coolant temp when the AC is not in...
Forum: C4 Tech/Performance
04-05-2019, 08:13 AM
Replies: 16
Views: 1,204
Posted By Churchkey

& the only corner you have to deal with is the 1...

& the only corner you have to deal with is the 1 for the return road?
Roundy round guy messin with ya HAHA.
Grats on making it to the finals-- that's a heck of launch!

Avatar pic is fast time on...
Forum: C4 Tech/Performance
04-01-2019, 09:45 PM
Replies: 15
Views: 3,753
Posted By Churchkey

AHA!! Firestone!!! Your fortunate they did not...

AHA!! Firestone!!! Your fortunate they did not sell you 4 ball joints, a rack & tie rod ends.

Shims on vehicles that require them and the installation or removal of them + setting the toe IS the...
Forum: C4 Tech/Performance
03-10-2019, 01:30 PM
Replies: 71
Views: 9,567
Posted By Churchkey

Front of the engine noise sounds like a pulley...

Front of the engine noise sounds like a pulley bearing use a mechanic's stethoscope to check the bearings the tensioner pulley bearing is favorite.
Also:
The belt may be dry check the belt ribs for...
Forum: C4 Tech/Performance
03-08-2019, 08:45 PM
Replies: 71
Views: 9,567
Posted By Churchkey

Looks to me like there is some moisture in the...

Looks to me like there is some moisture in the oil + it is normal to have some gray bearing overlay hiding in recesses.

Cut the oil filter open with what? A can opener? If you do not have an oil...
Forum: C4 Tech/Performance
02-01-2019, 08:20 AM
Replies: 6
Views: 783
Posted By Churchkey

ZZ4 & ZZ6 as well as L98 113, LT1 & LT4 aluminum...

ZZ4 & ZZ6 as well as L98 113, LT1 & LT4 aluminum heads have a raised "D" exhaust port it is 3/8" higher than the standard small block port.
The gasket pictured is for standard small block exhaust...
Forum: C4 General Discussion
01-30-2019, 08:40 PM
Replies: 15
Views: 4,897
Posted By Churchkey

A Z51 rack has a faster ratio = heavier steering....

A Z51 rack has a faster ratio = heavier steering.
Most alignment shops set the caster to the max positive = heavy steering but it will go straight @ 150 mph.
Setting the caster to minimum will...
Forum: C4 Tech/Performance
01-26-2019, 08:52 AM
Replies: 24
Views: 7,703
Posted By Churchkey

Have Total Seal rings in my 355 Gen 1 mill & like...

Have Total Seal rings in my 355 Gen 1 mill & like them.
Suggest bedding the rings in using dino oil check Google for a how to.
PCV: Had an issue with the PCV sucking oil it was due to the valve...
Forum: C4 General Discussion
01-19-2019, 08:53 PM
Replies: 28
Views: 2,944
Posted By Churchkey

Suggest 6" F-glass insulation in the roof trusses...

Suggest 6" F-glass insulation in the roof trusses + 2 of 4 or 5 blade 52" ceiling fans to blow the head down. When insulated a 150K torpedo heater will bring your 30 degree shop up to 65 degrees in...
Forum: C4 Tech/Performance
01-17-2019, 08:17 AM
Replies: 22
Views: 3,166
Posted By Churchkey

Mini starter mounting position: Close to the...

Mini starter mounting position:
Close to the engine block is for use with a 153 tooth flywheel. An auto trans car may have the 153 tooth wheel. For header clearance I use a 153 tooth wheel & mini...
Forum: C4 Tech/Performance
01-16-2019, 08:08 AM
Replies: 22
Views: 3,166
Posted By Churchkey

Aluminum roof flashing is easy to work = fashion...

Aluminum roof flashing is easy to work = fashion a cover.

If you happen to know someone that drinks from a can cut one open & make a cover.
Forum: C4 Tech/Performance
01-12-2019, 08:35 AM
Replies: 12
Views: 1,154
Posted By Churchkey

HA, happens all the time here. In a...

HA, happens all the time here.

In a nutshell: A device needs amperage to operate, volts push the amps to the device. The higher the amp load on the system the lower the charging voltage will read....
Showing results 1 to 25 of 497
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 12:33 AM.