CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 4
1
2
3
Last »
Search: Posts Made By: sunnfish
Showing results 1 to 25 of 96
Search took 1.20 seconds.
Forum: C4 General Discussion
08-20-2014, 04:11 AM
Replies: 12
Views: 1,014
Posted By sunnfish

I just did the full run down. You can read it...

I just did the full run down. You can read it just above your post Vader.
Forum: C4 Tech/Performance
08-20-2014, 03:51 AM
Replies: 11
Views: 1,733
Posted By sunnfish

I put coil over shocks on my 86 and ride is 110...

I put coil over shocks on my 86 and ride is 110 0/0 better. You ask about cornering I'm not a rode and track guy but it feels great on the street.
Forum: C4 General Discussion
08-19-2014, 10:59 AM
Replies: 12
Views: 1,014
Posted By sunnfish

I did rebuild the motor bored .030 over so the...

I did rebuild the motor bored .030 over so the heads and block have been boiled clean. Like I said its a new pump and radiator both over sized. I also pulled the the stat and run it without. I also...
Forum: C4 Tech/Performance
08-19-2014, 10:30 AM
Replies: 13
Views: 2,027
Posted By sunnfish

Trans leak

I have a 86 and the trans pan gasket leaks. I have tried cork rubber sealer and I get it to slow down but it still drips. I even bought a new pan. Any tricks that some one might have to help?
Forum: C4 Tech/Performance
08-19-2014, 09:36 AM
Replies: 8
Views: 945
Posted By sunnfish

Thanks for all your info. I did do just what you...

Thanks for all your info. I did do just what you wrote and when I went to give it that final one half to three quarter turn I could see the valve move. My last adjustment I did the feeler gage...
Forum: Wheels & Tires
08-18-2014, 03:24 AM
Replies: 3
Views: 1,181
Posted By sunnfish

I have used SOS pads just don't scuba to hard.

I have used SOS pads just don't scuba to hard.
Forum: C4 Tech/Performance
08-18-2014, 03:21 AM
Replies: 8
Views: 945
Posted By sunnfish

Lifter question

I have a 86 with cast iron heads. When I was putting my engine back together I was adjusting the lifters like normal tighten until the push rod is snug. Then you give it one half to three quarter...
Forum: C4 General Discussion
08-18-2014, 02:52 AM
Replies: 12
Views: 1,014
Posted By sunnfish

coolant

Hi guys I have a 86 and it gets hot when it gets over 80 degrees outside. Can't drive in traffic at all climbs to over 245 degrees. I have tried a lot of things bigger radiator, edelbrock high...
Forum: C4 Tech/Performance
08-17-2014, 11:01 PM
Replies: 21
Views: 1,186
Posted By sunnfish

I have a 86 and I took off all the pollution...

I have a 86 and I took off all the pollution junk. I also put in a bigger cam bored .030 over with some headers with Borla dual exhaust. I also put some roller lifters and now it goes pretty good....
Forum: C4 Tech/Performance
08-17-2014, 10:46 PM
Replies: 0
Views: 226
Posted By sunnfish

New ride

I have a 86 Coupe. I wanted to raise the front and I got little help from here. I almost replaced the front spring. I seen these coil over shocks at summit racing. Wow what a difference. They are...
Forum: C4 Tech/Performance
06-18-2012, 02:41 AM
Replies: 2
Views: 585
Posted By sunnfish

odd rear end

I have a 86. I noticed the rear wheels go way out on the bottom when I back up. They just spead. When I pull foward they straghten right up. This don't seem normal. Dose anybody have a idea of what's...
Forum: C4 Tech/Performance
06-18-2012, 02:20 AM
Replies: 23
Views: 9,616
Posted By sunnfish

Still hot

I had my engine rebuilt at that time the heads and block have been boiled clean. I have a 86. I bored it .030 over abigger cam headers removed all the pulution parts. I replaced the radiator with a...
Forum: C4 Tech/Performance
07-23-2011, 04:52 AM
Replies: 12
Views: 3,681
Posted By sunnfish

I had put 24lbs. in my 86. Iwas told I had to get...

I had put 24lbs. in my 86. Iwas told I had to get the ecm changed. I did and it runs great. I only get 16 mpg in city. I have done a lot of other things to the engine.
Forum: C4 Tech/Performance
07-10-2011, 09:16 PM
Replies: 1
Views: 430
Posted By sunnfish

A/C Control panal

I have a 86 and my heater A/C control panel is dead. The fuses are good but there is nothing. No ligths or motor. Dose anybody know Any place I should look?
Forum: C4 Tech/Performance
06-07-2011, 12:17 AM
Replies: 8
Views: 4,580
Posted By sunnfish

I have two sets off a 86 350. One is like chrome...

I have two sets off a 86 350. One is like chrome and the other is used. I took them off to put the chrome on and then bougth some headers.
Forum: C4 Tech/Performance
05-18-2011, 09:06 AM
Replies: 5
Views: 423
Posted By sunnfish

Injectors

86, I installed new ijectors from Jon. At the same time I had the mannifold off for a oil leak. The injectors are larger then stock. I had 22 lbs and now I have 24 lbs. I did put a bigger cam and...
Forum: C4 Tech/Performance
05-04-2011, 07:11 AM
Replies: 4
Views: 395
Posted By sunnfish

RE: Fuel injection

I have a 86 with some mods, bigger cam, headers nothing real major. I was looking into an ajustable fuel regulator. Does this make any horse power improment?
Forum: C4 Tech/Performance
05-03-2011, 07:22 AM
Replies: 16
Views: 6,691
Posted By sunnfish

I have a 86 and I was told to have it removed...

I have a 86 and I was told to have it removed from the computer. I had done many other things like cam and headers injectors. So I did send the computer to a place I can't remember ( There name was...
Forum: C4 Tech/Performance
05-03-2011, 07:10 AM
Replies: 5
Views: 736
Posted By sunnfish

Fuel Injection

Hi Guys
This is my second post. Thanks for giving me Jons web site on injectors. Sorry to say he couldn't help me. So I'm back looking for help.
I have a 86 with tpi. Last winter I pulled apart the...
Forum: C4 Tech/Performance
05-02-2011, 02:55 PM
Replies: 5
Views: 820
Posted By sunnfish

Fuel Injection

I got some of those injectors from this forum. The guy everyboby likes. He had a vedio of his injectors. the problem is I can't find his web site. Does anybody know his web site?
Forum: C4 Tech/Performance
04-20-2011, 10:18 AM
Replies: 9
Views: 907
Posted By sunnfish

86 auto, I just about give up on trying to keep...

86 auto, I just about give up on trying to keep this thing from getting hot. I think I'm going to put some kind of hood scoop to give he engine some cool air. Things I have tried. The engine was just...
Forum: C4 Tech/Performance
01-06-2011, 10:19 AM
Replies: 35
Views: 18,078
Posted By sunnfish

I DON'T HAVE THE 383 BUT i DID PUT IN A BIGGER...

I DON'T HAVE THE 383 BUT i DID PUT IN A BIGGER CAM. I KNOW WHAT YOU MEAN ABOUT THE 3:73 GEARS WOW!!!! IT'S LIKE A HOLE BEAST.
Forum: C4 Parts for Sale/Wanted
12-11-2010, 10:42 PM
Replies: 41
Views: 1,961
Posted By sunnfish

RE: looking

I'm looking for the targra top. What sahpe is it in. Im also looking for the inside rear view mirro, mine has some of the crome coming offf from te back of the glass. Send a price please.

Steve...
Forum: C4 Tech/Performance
09-18-2010, 08:31 AM
Replies: 25
Views: 8,420
Posted By sunnfish

I was thinking more air. I bought a bigger cmf...

I was thinking more air. I bought a bigger cmf fan. I still got hot in traffic. Then i pulled the thurmastate,still got hot. I pruchased the three core radiator off ebay.and the two small fans. I put...
Forum: C4 Tech/Performance
08-20-2010, 07:04 PM
Replies: 16
Views: 1,282
Posted By sunnfish

as far as the timing if I'm rolling I have no...

as far as the timing if I'm rolling I have no problem
I never heard of burpping. How is that done?
I did take my compressed air and blew both ways trew both cores.
I'm liking the dewitt radiator,...
Showing results 1 to 25 of 96
 
Page 1 of 4
1
2
3
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 02:37 AM.