Search: Posts Made By: dukecebrelli
Showing results 1 to 25 of 77
Search took 1.05 seconds.
05-26-2017, 02:41 PM
Replies: 22
Views: 45,642
Posted By dukecebrelli

Ok, was able to get mine out also, figured I'd...

Ok, was able to get mine out also, figured I'd post so anyone with my questions will know as well. The advise above is all correct. What I missed was that the "prop shaft" bit was for the...
05-23-2017, 10:05 AM
Replies: 22
Views: 45,642
Posted By dukecebrelli

I know this is an old thread, but I am in the...

I know this is an old thread, but I am in the process of pulling my LS2 (manual trans) now. Accessories, heads, exhaust, radiator/fan, & A/C removed. Bolts removed from bell-housing and TT, and 3...
03-15-2010, 12:29 PM
Replies: 15
Views: 651
Posted By dukecebrelli

Holes drilled Thanks!:thumbs: I turned the...

Holes drilled Thanks!:thumbs:

I turned the key to ON, with the IAC pulled from the TB. No movement.
I'm not sure this is causing the original problem because when it is warm it will die while...
03-15-2010, 10:48 AM
Replies: 15
Views: 651
Posted By dukecebrelli

Are the trottle bodies replaceable with those off...

Are the trottle bodies replaceable with those off of other TPI's? Maybe I can save some time by finding one at a junkyard?
03-14-2010, 08:53 PM
Replies: 15
Views: 651
Posted By dukecebrelli

Update: Had it towed to a shop for...

Update:

Had it towed to a shop for diagnostics. They couldn't get their tech scanner to read the computer. They said it was the computer causing the problems and it'd be $500 to replace. I said...
03-10-2010, 11:07 AM
Replies: 15
Views: 651
Posted By dukecebrelli

22 tps sensor signal voltage low 36 ignition...

22 tps sensor signal voltage low
36 ignition system circuit error

I guess the 22 means replace the TPS, but where should I start looking for 36?
03-10-2010, 11:05 AM
Replies: 15
Views: 651
Posted By dukecebrelli

Thank you, it did not turn on when the key is...

Thank you, it did not turn on when the key is turned to on. I removed the instument panel and I guess there is a bad connection. Light is working now!

If I did this right, I got codes 22 and...
03-10-2010, 10:26 AM
Replies: 15
Views: 651
Posted By dukecebrelli

Will verify ECM control of the IAC in a few...

Will verify ECM control of the IAC in a few minutes.

Um, I just jumped A and B, the service engine light did not flash or come on, but the cooling fan did??? When I removed the jumper, the fan...
03-10-2010, 10:08 AM
Replies: 17
Views: 1,825
Posted By dukecebrelli

SAME problem here too...

SAME problem here too...
03-10-2010, 09:28 AM
Replies: 15
Views: 651
Posted By dukecebrelli

IAC- done when I replaced it. Just...

IAC- done when I replaced it.

Just wondering, If the TPS and IAC were not set properly, I would still have the problems during winter months too, right?

Can't check codes- attached code reader...
03-10-2010, 08:20 AM
Replies: 15
Views: 651
Posted By dukecebrelli

Thank you so much for the steps- going outside...

Thank you so much for the steps- going outside now!
03-10-2010, 07:41 AM
Replies: 15
Views: 651
Posted By dukecebrelli

Same problem, 3rd year in a row!

1987(late)
Problem:

Every spring for the last 3 years, my corvette dies at idle.

At the start of spring (45-50 degrees, humid St. Louis climate) the motor stops running at idle. If I give it...
05-13-2008, 06:36 PM
Replies: 0
Views: 214
Posted By dukecebrelli

1987 wtb smoked bronze top...

Looking for a smoke bronze top for my 87- found a few, but the years were 89+....

I've heard there are retro-fit kits- anyone know anything about it?
04-15-2008, 07:25 PM
Replies: 13
Views: 11,819
Posted By dukecebrelli

ok- newbie question here.... what is FSM? Thank...

ok- newbie question here.... what is FSM?
Thank you for the info everyone
04-09-2008, 07:27 PM
Replies: 13
Views: 11,819
Posted By dukecebrelli

thanks a lot guys! New switch it is... as for the...

thanks a lot guys! New switch it is... as for the chilton... I really did use it to sop up some spilled beer last night
04-04-2008, 06:38 PM
Replies: 13
Views: 11,819
Posted By dukecebrelli

location? headlight relay...

I don't have my chilton handy- the headlights wont turn on- all fuses look good- I think the switch is ok- before this happened they would work for a while- after some time of driving they would...
03-25-2008, 10:23 PM
Replies: 5
Views: 328
Posted By dukecebrelli

:( alright- thanks a lot guys

:( alright- thanks a lot guys
03-25-2008, 10:20 PM
Replies: 1
Views: 305
Posted By dukecebrelli

new info- looks like its just the guts under the...

new info- looks like its just the guts under the hood "skin" that is different- has anyone tackled this before - to make the 84 fit 85 and up?
03-25-2008, 08:17 PM
Replies: 5
Views: 328
Posted By dukecebrelli

Do you know if it is in any way able to be...

Do you know if it is in any way able to be modified? I found a great deal and it would def. be worth the extra work- thanks a lot
03-25-2008, 07:56 PM
Replies: 5
Views: 328
Posted By dukecebrelli

quick hood fitment question...

Finally found a hood I can afford... my '87 sliced through a deer @ just under 80mph.... I really f'ed it up... repairing slowly-
The hood I found was taken off of an 84, does anyone know if I can...
03-25-2008, 06:08 PM
Replies: 1
Views: 305
Posted By dukecebrelli

Quick hood fitment question...

I have been given 2 diff facts....
I need to know if an 84 hood will fit the same on my 87
Thanks!
03-21-2008, 06:07 PM
Replies: 24
Views: 1,247
Posted By dukecebrelli

hmm good food for thought

hmm good food for thought
03-20-2008, 06:22 PM
Replies: 3
Views: 389
Posted By dukecebrelli

I had the same problem- soon as I got her goin, I...

I had the same problem- soon as I got her goin, I stepped on the brakes before shifting to drive- and shed run like poop, and/or just go out completely

I checked every one of those fuseable links-...
03-20-2008, 06:11 PM
Replies: 3
Views: 330
Posted By dukecebrelli

Check the terminals on the batt- check for...

Check the terminals on the batt- check for corrosion on the power distribution block behing the battery- also make sure that nut is tight- mine was loose and screwed up all kinds of stuff... then...
03-20-2008, 05:33 PM
Replies: 24
Views: 1,247
Posted By dukecebrelli

I'm really liking the sound of this.... I am...

I'm really liking the sound of this....
I am wondering why the coice to the TH350?
Showing results 1 to 25 of 77
 


 
Forum Jump


All times are GMT -4. The time now is 06:37 PM.