CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 4
1
2
3
Last »
Search: Posts Made By: leviathan125
Showing results 1 to 25 of 84
Search took 1.09 seconds.
Forum: C5 Tech
04-26-2012, 03:22 PM
Replies: 8
Views: 968
Posted By leviathan125

I have and the code comes back. :(

I have and the code comes back. :(
Forum: C5 Tech
04-25-2012, 03:59 PM
Replies: 8
Views: 968
Posted By leviathan125

If you are talking about the ground wire on the...

If you are talking about the ground wire on the left side frame rail, just above the muffler, then yes. If not, I'm not sure which one you are talking about then.
Forum: C5 Tech
04-25-2012, 03:14 PM
Replies: 8
Views: 968
Posted By leviathan125

I checked that at the wheel and it was plugged...

I checked that at the wheel and it was plugged in. I don't think the sensor would of went out by just sitting there during the install of the clutch, what would be the chances? Where does the harness...
Forum: C5 Tech
04-25-2012, 02:37 PM
Replies: 8
Views: 968
Posted By leviathan125

Problem after clutch install

I installed a clutch in my 02 Z06. Prior to the install, there were no warning lights on. Now, the check engine light is on and the "service traction sys", "service ABS", "service active handling"...
Forum: C5 Tech
04-25-2011, 03:22 PM
Replies: 30
Views: 15,404
Posted By leviathan125

Three weekends ago we dropped the rear end,...

Three weekends ago we dropped the rear end, transmission, and torque tube for the second time to figure out why the clutch wasn't disengaging. When we pulled the torque tube, the pressure plate was...
Forum: C5 Tech
04-02-2011, 02:19 PM
Replies: 30
Views: 15,404
Posted By leviathan125

No, I don't have a remote bleeder, but I was...

No, I don't have a remote bleeder, but I was wishing I did. I might go ahead and order one since it looks like I'm going to have to take it all apart again. Yes, each time I would open the bleeder...
Forum: C5 Tech
04-02-2011, 12:51 AM
Replies: 30
Views: 15,404
Posted By leviathan125

I can't get the car into gear while it's running,...

I can't get the car into gear while it's running, with the clutch pushed all the way down. I have to start it in gear and with the clutch still all the way down the car moves, it actually starts...
Forum: C5 Tech
04-02-2011, 12:23 AM
Replies: 30
Views: 15,404
Posted By leviathan125

Am I right in thinking that the throw out bearing...

Am I right in thinking that the throw out bearing can only travel so far, not matter how much fluid is pushing, and may even cause damage to it if it does travel to far?



There is an...
Forum: C5 Tech
04-01-2011, 03:55 PM
Replies: 30
Views: 15,404
Posted By leviathan125

I used the stock flywheel bolts with locktite. I...

I used the stock flywheel bolts with locktite. I also used the stock pressure plate bolts. I installed a brand new LS7 flywheel, brand new LS7 pressure plate, and a brand new LS7 clutch, as well as...
Forum: C5 Tech
03-31-2011, 12:32 PM
Replies: 30
Views: 15,404
Posted By leviathan125

From all the reading I have done, it seems that...

From all the reading I have done, it seems that most are in agreement that a shim is Not needed with an LS7 kit. Surely I didn't put the clutch in backwards after looking at what side goes to the...
Forum: C5 Tech
03-30-2011, 10:45 AM
Replies: 30
Views: 15,404
Posted By leviathan125

Clutch won't disengage after install

I have an 02 Z06. I just installed an LS7 clutch and flywheel, new slave cylinder, and a ram adjustable master cylinder. The car moves if you have it in gear with the clutch in when you start it. ...
Forum: C5 Tech
02-17-2011, 12:43 AM
Replies: 4
Views: 619
Posted By leviathan125

Does the LS7 Clutch Kit include the throw out...

Does the LS7 Clutch Kit include the throw out bearing?
Forum: C5 Parts for Sale/Wanted
02-16-2011, 02:47 PM
Replies: 5
Views: 300
Posted By leviathan125

Payment has been sent to mrm1149. So I no longer...

Payment has been sent to mrm1149. So I no longer need a console. Thanks again, Mike!
Forum: C5 Parts for Sale/Wanted
02-16-2011, 12:09 PM
Replies: 5
Views: 300
Posted By leviathan125

I assume it's in good shape and it's like the...

I assume it's in good shape and it's like the console linked above? If so, do you take paypal?
Forum: C5 Parts for Sale/Wanted
02-15-2011, 02:26 PM
Replies: 5
Views: 300
Posted By leviathan125

WTB: Center Console

I am wanting to buy a black center console since the lid hinge busted mine. I don't need the lid. I also don't need the hinges, latch, fuel switch etc. unless you just want to leave them on. Let...
Forum: C5 Parts for Sale/Wanted
02-15-2011, 02:21 PM
Replies: 11
Views: 581
Posted By leviathan125

I will take the left hand side (driver side). ...

I will take the left hand side (driver side). Sending payment now...

EDIT: Payment sent for driver side.
Forum: C5 Parts for Sale/Wanted
02-14-2011, 10:27 PM
Replies: 76
Views: 5,846
Posted By leviathan125

I will take the center console if it is black.

I will take the center console if it is black.
Forum: C5 Parts for Sale/Wanted
11-04-2008, 04:49 PM
Replies: 0
Views: 158
Posted By leviathan125

WTB: Chrome Z06 Center Cap

I need one (1) center cap for a set of chrome Z06 wheels with the colored Corvette logo. Pics and price shipped to 74701 please.:thumbs:
Forum: Southwest
10-31-2008, 05:42 PM
Replies: 46
Views: 1,408
Posted By leviathan125

I don't have any experience with anyone except...

I don't have any experience with anyone except for Corvettes of Dallas. I just had my 02 Z06 dyno tuned by them yesterday. I made an appointment with them and was rather surprised that they started...
Forum: C5 Parts for Sale/Wanted
10-16-2008, 01:32 AM
Replies: 1
Views: 237
Posted By leviathan125

Is this the newest generation, the VR-B2? How...

Is this the newest generation, the VR-B2? How many miles are on it? Any pictures? Thanks.
Forum: C5 General
06-03-2008, 06:34 PM
Replies: 13
Views: 2,255
Posted By leviathan125

Here is a pic of mine. I kinda like the one...

Here is a pic of mine. I kinda like the one above with the oval being silver better. Hmmm.

http://i137.photobucket.com/albums/q219/leviathan125/Picture2965.jpg
Forum: C5 Tech
06-02-2008, 12:47 PM
Replies: 3
Views: 469
Posted By leviathan125

I will pull my driver seat sometime this week and...

I will pull my driver seat sometime this week and check the connections, as well as the door panel. Where is the BCM located?

As for the mpg issue, I ran Techron through a couple of months ago. ...
Forum: C5 Tech
06-01-2008, 06:39 PM
Replies: 3
Views: 469
Posted By leviathan125

A few problems I need help with

I have an 02 Z06. Here are the 3 problems that I have.

1. The average mpg display is not accurate. I have compared it to the actual mpg and it's not close. One time I was getting 26 mpg on the...
Forum: C5 Parts for Sale/Wanted
05-02-2008, 12:51 PM
Replies: 27
Views: 4,882
Posted By leviathan125

I have a few people that will trade for their...

I have a few people that will trade for their stock lights, but I would like to give this one more shot at trying to get someone's stock lights with HID's in them.

If anyone is interested, if they...
Forum: C5 Parts for Sale/Wanted
04-30-2008, 11:08 PM
Replies: 27
Views: 4,882
Posted By leviathan125

The last PM I got from you was saying you were...

The last PM I got from you was saying you were still interested, but your husband's truck was going in the shop and you couldn't remove your lights until after it was out of the shop and that I could...
Showing results 1 to 25 of 84
 
Page 1 of 4
1
2
3
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 08:09 AM.