CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 6
1
2
3
Last »
Search: Posts Made By: JP_80
Showing results 1 to 25 of 150
Search took 1.15 seconds.
Forum: C3 Tech/Performance
03-08-2016, 11:28 AM
Replies: 6
Views: 742
Posted By JP_80

Thanks guys. I'll check them out.

Thanks guys. I'll check them out.
Forum: C3 Tech/Performance
03-07-2016, 03:40 PM
Replies: 6
Views: 742
Posted By JP_80

DFW Speed Shops

I've gone as far as I can with my modifications and need to let the professionals finish it. Does anyone know of a good Speed and/or Hot Rod shop that can finish a custom build in the Dallas-Fort...
Forum: C3 Tech/Performance
11-11-2014, 12:35 PM
Replies: 6
Views: 3,603
Posted By JP_80

Hydroboost with Borgeson Steering Box

I recently installed a Borgeson Steering Box. I already had a hydroboost installed and worked fine. I've been trying to bleed the system but can’t seem to get all the air out. Has anyone else had...
Forum: C3 Tech/Performance
09-19-2014, 03:46 PM
Replies: 0
Views: 745
Posted By JP_80

Corbeau Seats

I've seen several post of people using Corbeau A4 seats but has anyone used the FX1 or know if they would fit?
Forum: C3 General
04-11-2014, 01:39 PM
Replies: 2
Views: 2,365
Posted By JP_80

Lokar Throttle Cable

I want to replace my throttle cable with a Lokar one but I can't find anything that list the length. Can someone who has made this change tell me the Lokar part number or the length I need.
Forum: C3 Tech/Performance
05-15-2013, 10:56 AM
Replies: 3
Views: 465
Posted By JP_80

Made changes now hydroboost is jittery

I just installed a Borgeson steering box and new steering pump. Now my hydroboost feels jittery and whines (not much) when I apply the brakes. Is this a result of not having enough flow or too much...
Forum: C3 Tech/Performance
04-19-2013, 04:08 PM
Replies: 1
Views: 607
Posted By JP_80

Dewitts - How much will it hold

I just finished installing a Dewitts rad-Daul Elec fan set up. I filled it but only got approximately 2-1/2 to 3 gallons in it. I realize the block still had some fluid but 2-1/2 to 3 gallons seem...
Forum: C3 Tech/Performance
02-10-2013, 08:43 PM
Replies: 3
Views: 845
Posted By JP_80

Hydro Boost with Borgeson

Has anyone on here switch out to a hydro boost and Borgeson steering? If so, how did you route your hoses? The hydro boost high pressure out and the Borgeson HP in make a hell of an angle with only...
Forum: C3 Tech/Performance
07-25-2012, 12:51 PM
Replies: 1
Views: 1,011
Posted By JP_80

Power Steering Control Valve Fittings

Has anyone switched their power steering hoses (pressure & return) to steel braided. What size are the fittings on the control valve. I think they are 3/8 - 18 inverted flare and 1/4 - ?? inverted...
Forum: C3 Tech/Performance
06-02-2012, 10:03 PM
Replies: 6
Views: 562
Posted By JP_80

If the green wire activates the switched side of...

If the green wire activates the switched side of the relay can I wire it to the positive side of the ignition coil?
Forum: C3 Tech/Performance
06-02-2012, 07:01 PM
Replies: 6
Views: 562
Posted By JP_80

Dewitts Dual Fan Question

Where exactly does the green (Ignition) wire go??? Ignition switch, tie into something that gets power when key is turned, etc.??? Since there is another wire (orange) with a fuse that ties into...
Forum: C3 Tech/Performance
06-02-2012, 04:25 PM
Replies: 1
Views: 1,008
Posted By JP_80

Summit Stainless Flexable Radiator Hose

Has anyone used the Summit Stainless Flexable Radiator hose kit? If so do you just insert the flexable hose into the largest hose adapter and clamp it down? It seems a little to loose. It didn't...
Forum: C3 Tech/Performance
03-28-2012, 12:36 PM
Replies: 10
Views: 4,812
Posted By JP_80

Does anyone have any routing tips and pics?

Does anyone have any routing tips and pics?
Forum: C3 Tech/Performance
03-26-2012, 01:23 PM
Replies: 10
Views: 4,812
Posted By JP_80

Hydroboost Routing

For those that have swapped over to a hydroboost… how did you route your lines to and from the control valve. Any pics would be greatly appreciated.
Forum: C3 General
03-21-2012, 10:36 PM
Replies: 1
Views: 2,516
Posted By JP_80

Help with Alternator Plug

I got a new one-wire alternator. I know were the single red wire goes but what about the plug with the two wires (red and Brown)? The new alternator has a plug but it is different. I looked over...
Forum: C3 General
03-13-2012, 04:20 PM
Replies: 3
Views: 1,313
Posted By JP_80

P/S Control Valve Fitting Sizes

I want to replace the rubber hoses with stainless steel ones but I don't know what size the fittings are to/from the pump to the control valve. Does anyone know?
Forum: C3 General
03-05-2012, 11:27 AM
Replies: 4
Views: 398
Posted By JP_80

It's a 77'. Thanks, I see it on the Zip.

It's a 77'. Thanks, I see it on the Zip.
Forum: C3 General
03-05-2012, 11:04 AM
Replies: 4
Views: 398
Posted By JP_80

Help Identifying Radiator Bracket

The bracket (looks more like a support rod) that is located in the front bottom center of the radiator support and attaches to just below the bottom of the hood. It's a round rod, threaded on the...
Forum: C3 Tech/Performance
02-08-2012, 01:26 PM
Replies: 4
Views: 548
Posted By JP_80

It's a 77 and it has a factory overflow tank but...

It's a 77 and it has a factory overflow tank but I would love to remove it if I can. I just don't want to do it if it is needed.
Forum: C3 Tech/Performance
02-08-2012, 12:59 PM
Replies: 4
Views: 548
Posted By JP_80

Dewitts Radiator Question

I swear I read on here somewhere that you don't have to have an overflow tank but I can't seem to find the post. I thought Tom commented that if you leave a little room in the top of the rad then it...
Forum: C3 General
09-19-2011, 02:16 PM
Replies: 1
Views: 657
Posted By JP_80

Fuel Return Line

What size is the factory fuel return line on a 77? Pump to tank, not the one from the vapor canister. Thanks
Forum: C3 Tech/Performance
09-09-2011, 07:59 PM
Replies: 4
Views: 601
Posted By JP_80

No typo on the comp. The carb is a quik fuel 850...

No typo on the comp. The carb is a quik fuel 850 and the thermostat is a 185. No return lines now or before with the mech. pump. Could that be the problem? Have not checked the float levels. How do...
Forum: C3 Tech/Performance
09-09-2011, 05:20 PM
Replies: 4
Views: 601
Posted By JP_80

Stalling Problem

I've got a problem I was hoping someone could help me out with. After I've been driving for a while and I’ve gotten up to normal operating temp (205-210) if I stop at a stop light it starts to act...
Forum: C3 Tech/Performance
08-10-2011, 02:23 PM
Replies: 3
Views: 1,092
Posted By JP_80

tekvette - Thanks for the pic's. That is one...

tekvette - Thanks for the pic's. That is one nice setup. I looked at (still looking at) the Concept One kit but it's a little more than I was wanting to spend.

I stumbled accross KRC's stuff...
Forum: C3 Tech/Performance
08-09-2011, 01:36 PM
Replies: 3
Views: 1,092
Posted By JP_80

KRC Serpentine Kit

Has anyone used KRC Serpentine Kit for street use? I talked to a guy named Norm there and he said the best Alt:Crank pulley ratio he could do is approximately 2.6:1 (3:1 is what is recommended). ...
Showing results 1 to 25 of 150
 
Page 1 of 6
1
2
3
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 08:32 AM.