CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 18
1
2
3
11
Last »
Search: Posts Made By: greg75vette
Showing results 1 to 25 of 430
Search took 1.40 seconds.
Forum: C3 Tech/Performance
12-11-2013, 08:44 AM
Replies: 144
Views: 19,823
Posted By greg75vette

Damn! Wish I was further along in my swap. You...

Damn! Wish I was further along in my swap. You guys are 20 minutes from me.

I'll be watching this thread closely.
Forum: C3 Tech/Performance
12-11-2013, 08:40 AM
Replies: 39
Views: 3,484
Posted By greg75vette

Nice!

Nice!
Forum: C3 Tech/Performance
12-10-2013, 10:16 AM
Replies: 39
Views: 3,484
Posted By greg75vette

That sounds like a great deal. Did it come with...

That sounds like a great deal. Did it come with the sensors as well?



Sorry for the confusion. I meant mine is the 305hp variant. All I know is mine has 305hp with 853 heads out of an Fbody. I...
Forum: C3 Tech/Performance
12-06-2013, 10:01 AM
Replies: 39
Views: 3,484
Posted By greg75vette

853s :nonod: That's what I have on my '00...

853s :nonod: That's what I have on my '00 Firebird pull out. This is the 305hp variant.
Forum: C3 Tech/Performance
11-25-2013, 01:44 PM
Replies: 31
Views: 13,619
Posted By greg75vette

So it's working in your set up? I'm hoping gauges...

So it's working in your set up? I'm hoping gauges are happy with the feed because I really don't want to change it :rofl:
Forum: C3 Tech/Performance
11-25-2013, 10:22 AM
Replies: 31
Views: 13,619
Posted By greg75vette

mmesa005, Good to see the boy off! No turning...

mmesa005,
Good to see the boy off! No turning back now.





So I looked over my notes it looks like I took the signal from on "under dash" plugs. However, I found a printed out forum post...
Forum: C3 Tech/Performance
11-22-2013, 01:21 PM
Replies: 31
Views: 13,619
Posted By greg75vette

:iagree: That's the piece I broke that goes just...

:iagree: That's the piece I broke that goes just above the oil filter.
Forum: C3 General
11-22-2013, 01:18 PM
Replies: 47
Views: 4,586
Posted By greg75vette

Been happy with mine. I bought it used about 3 or...

Been happy with mine. I bought it used about 3 or so years ago and it has been handy. I haven't used the cross bar yet, but I have completely removed the rear while on the lift:
...
Forum: C3 Tech/Performance
11-22-2013, 11:52 AM
Replies: 31
Views: 13,619
Posted By greg75vette

I believe you're right. What I do know is the...

I believe you're right. What I do know is the wire that cam out of the under dash plugs, 220 and 230, is where my VSS signal came from. I'll check my notes that are at home of where it terminates.
Forum: C3 Tech/Performance
11-22-2013, 08:19 AM
Replies: 31
Views: 13,619
Posted By greg75vette

If I could have, I would have. Up until a few...

If I could have, I would have. Up until a few weeks ago, the car has been on the side of my house, under a car cover, partially covered by a house extension. I did all of my work there never had the...
Forum: C3 Tech/Performance
11-21-2013, 02:29 PM
Replies: 31
Views: 13,619
Posted By greg75vette

That's pretty cool. I was hoping it wouldn't be...

That's pretty cool. I was hoping it wouldn't be heavier and hopefully lighter. That's awesome it only needs a few CAT5's. One or two of these and you're fine, but if you have about 20 feet of them,...
Forum: C3 Tech/Performance
11-21-2013, 08:22 AM
Replies: 31
Views: 13,619
Posted By greg75vette

That's pretty cool. I was curious as to why it...

That's pretty cool. I was curious as to why it was some much more money. How much does the final package weigh, including the CAT5s? I like the central wiring module idea. I wonder where guys are...
Forum: C3 Tech/Performance
11-21-2013, 08:17 AM
Replies: 31
Views: 13,619
Posted By greg75vette

No problem. :cheers: And yes, I chose to rewire...

No problem. :cheers: And yes, I chose to rewire the stock harness myself. If you get it done, it becomes very plug-n-play. I was stubborn and needed the room for the budget elsewhere. All in all, so...
Forum: C3 Tech/Performance
11-20-2013, 02:49 PM
Replies: 31
Views: 13,619
Posted By greg75vette

I believe I've misunderstood your intentions. Let...

I believe I've misunderstood your intentions. Let me try from another angle.

Don't feel limited in your selection based on my experience. Any LSx (and LTx) can be hooked up to a C3. In reality,...
Forum: C3 Tech/Performance
11-20-2013, 09:06 AM
Replies: 31
Views: 13,619
Posted By greg75vette

No problem! Unfortunately, I don't have any...

No problem! Unfortunately, I don't have any pictures. I'm a little reluctant to show them as well since I haven't vetted my wiring yet. My vette basically sat for 2 years while I was in the middle of...
Forum: C3 Tech/Performance
11-18-2013, 02:59 PM
Replies: 31
Views: 13,619
Posted By greg75vette

The long answer is complicated and depends on...

The long answer is complicated and depends on your goals, but the short answer is not as hard one would think.

This thread proved invaluable throughout my swap (and I still use it):...
Forum: C3 Tech/Performance
11-12-2013, 02:33 PM
Replies: 14
Views: 1,411
Posted By greg75vette

I didn't repair the seal myself, but I have taken...

I didn't repair the seal myself, but I have taken the diff out without a lift. It's very doable. A lot of stuff has to move and be taken out of the way, but nothing terrible. A friend to help you...
Forum: C3 Tech/Performance
11-11-2013, 12:40 PM
Replies: 26
Views: 10,637
Posted By greg75vette

I like the intake, riggs. I'm happy to hear...

I like the intake, riggs. I'm happy to hear clearance under the rad support was sufficient. I might give this a shot.




Not everyone likes coil covers.
Forum: C3 Tech/Performance
03-22-2012, 07:55 AM
Replies: 2,667
Views: 467,930
Posted By greg75vette

Mikey pretty much covered it here ^^^. ...

Mikey pretty much covered it here ^^^.

However, one of the goals of my project was to keep track of the true cost. There's so many people that claim "it only cost me $2500 (but the engine, trans,...
Forum: C3 General
08-31-2011, 08:38 AM
Replies: 29
Views: 38,502
Posted By greg75vette

I think where the LS swap starts to really shine...

I think where the LS swap starts to really shine is when you want the total package.

You want a hot little SBC with some good power (400hp+)? It can be done cheaper.
You want an OD transmission?...
Forum: C3 General
08-30-2011, 10:01 AM
Replies: 29
Views: 38,502
Posted By greg75vette

My swap should cost me about $8.5k when I'm all...

My swap should cost me about $8.5k when I'm all said and done, and most of everything is bought. With that said, I'm doing it myself, the Junkyard LS1/T56 complete drop out is in there and I didn't...
Forum: C3 Tech/Performance
08-26-2011, 09:40 AM
Replies: 4
Views: 2,953
Posted By greg75vette

What brackets do you have? I know of one...

What brackets do you have? I know of one manufacturer that requires the use a CTS-V pan with stock power steering. Can't recall the name off hand.
Forum: C3 Parts for Sale/Wanted
08-26-2011, 08:50 AM
Replies: 8
Views: 804
Posted By greg75vette

Could you post a pic of the inside surface facing...

Could you post a pic of the inside surface facing the crack?

And as Legacy stated, you need to list a price.

Thanks.
Forum: C3 Parts for Sale/Wanted
08-18-2011, 01:05 PM
Replies: 47
Views: 7,249
Posted By greg75vette

If my diff was going bad, I would be all over...

If my diff was going bad, I would be all over these!
Forum: C3 Tech/Performance
08-17-2011, 02:18 PM
Replies: 2,667
Views: 467,930
Posted By greg75vette

I googled the VIN. Would this be where you got...

I googled the VIN. Would this be where you got it?
https://www.salvageautosauction.com/vehicle_detail/Salvage-2006-Pontiac-GRAND+PRIX-for-Sale/lot-17101901/Chicago-heights-Illinois

But that VIN...
Showing results 1 to 25 of 430
 
Page 1 of 18
1
2
3
11
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 02:41 PM.